Given: A P. Speaker Amplifier voltage gain: 11 dB, input voltage: 19 mv, speaker impedance: 6 Ohms What is the output power (in dBm) for the given input voltage? No need for a solution. Just write your numeric answer in the space provided. Round off your answer to 2 decimal places.

Q: Q3: The Impulse response of linear time invariant system is shown in figure below. Determine and…

A: Please find the detailed solution in below images

Q: Question 4: a)The barrier potential (v)at a PN – junction in a semiconductor diode is given by (0 +…

A:

Q: Implement the following Boolean function using: a) 8x1 MUX b) 4x1 MUX F = ABC' + A'BC' + A'BC + AB'C

A:

Q: relaxation OScIi generate pulses controlled rectifier and, it is known that the external capacitor…

A:

Q: 6. Given VC = 8V for the network, determine: a. IB b. IC 9 18 V с. В d. VCE 3.9 k2 560 kQ OVc=8 V…

A: In this question we will fund base current , collector current , current gain , collector to emitter…

Q: Q2/ A single phase, 2200/200 V transformer takes 1 A at the H.V side on no load at a power factor of…

A:

Q: 1. The bandwidth of the Single-Stage IF amplifier of a Superheterodyne receiver is to be determined.…

A: Input signal  Pi=25 dBμ RF amplifier gain PGRF=30 dB Mixer loss PGM=−10 dB IF Amplifer PGIF=20 dB…

Q: A 2-wire d.c. distributor 81 m long at a distance of 59 m is uniformly loaded with 0.26 A/m.…

A: Given a 2 wire d.c. distributor 81 m long at a distance of 59 m. Uniformly loaded with 0.26 A/m…

Q: use the supe position thearem, bind the current in the 40 A resistor of the circuit shown. sO v 407

A: Given: Circuit diagram

Q: .150KVA, 440 V, 50 Hz, star-connected diesel generator has armature reaction 1.6 S2 when it is…

A: Star Connection: A way of connecting polyphase circuits in which one end of each phase line is…

Q: I ww 20 L 30 L 25 s

A: Solution- VTH across 25 ohm, Voltage at node a  Va = 50 V Apply nodal analysis at node…

Q: For a RTD temperature sensor, the set point is 100 degrees celsius and the proportional output being…

A:

Q: Course Name & Code: Signals & Systems (CNET-221) 3. Consider an LTI system with impulse response…

A: We need to find out the convolution of given signal

Q: 3- Show to connect two 7482 adders to form a four-bit adder? 4- Draw a block diagram for 8-bit…

A: The 4 bit adder can be designed by using the two 2-bit adder and similarly the 8-bit adder can be…

Q: Your Answers may be presented through Discussions, Drawings/Figures/Diagrams, Reference to NEC/PEC…

A: The solution is given below

Q: Find a function to detect an error in the representation of a decimal digit in BCD. In other words,…

A:

Q: Q2: A PMMC(Galvanometer instrument) has a resistance of 1002 and FSD for a current of 400Aµ. A shunt…

A:

Q: 1. The equivalent circuit impedances of a single phase 10-KVA, 480/120 V, 60 Hz transformer are to…

A:

Q: D11.2. Let H, = (21-40 a, - 3/20 a,)e-/0.07 A/m for a uniform plane wave traveling in free space.…

A: Solution- Given, Hs = 2∠-40°ax-3∠20°aye-j0.07z A/m Solution- a) ω -     It is given that uniform…

Q: 8.74 Use mesh analysis to find V, in the circuit in Fig. P8.74. 6/0 A 4/0'A -j21 ww V 20

A: Mesh Analysis: Mesh Current Analysis is a method for determining the currents circulating around a…

Q: For the figure system 5 sis + 2) 1+ as Find the characteristic equation and bring it to the Evans…

A: Given:

Q: Show how two 7483 a four-bit parallel adders can be connected to form an eight- bit parallel adder.…

A: The 8-bit adder can be designed by using the two 4-bit adder by connecting them in cascade.

Q: 4.a) Realize the given system in direct form-I y[n] = 0.5y[n-1] – 0.25y[n-2] +x[n]+ 0.4 x[n-1]

A: As per our guidelines we are supposed to be answer the first question only. Kindly repost the other…

Q: ) Express Y(e) (=DTFT of y[n]) as a function of w

A: In this question,  We need to determine the discreet time Fourier transform of the given signals.

Q: Q1// Find the result for the following. 1- (-27)10 +(-80)10 (in binary, then convert the answer to…

A: The solution is given below

Q: 19. On a short circuit test of a transformer, the readings are I = 10 A, E = 126 V, P = 400 W.…

A: Given data, Short circuit current Isc=10 A Power P = 400 W EMF V = 126 V

Q: Discuss the phase shift method of generating SSB through this block diagram

A: The block diagram is shown below,

Q: Q1: Sketch the following sequences 1) -3.8 и (п-2) 2) x(n) =-0.58(n+1)+0.58(n)+8(n-1)-0.58(n-2)+…

A:

Q: 4. Determine the lc and Ver for the transistor circuit in Figure Vcc 10 V VBB 5 V R 1.0 kn

A: Given,

Q: nd inverse-time circuitbreaker rating for a circui

A: Circuit breaker When there is fault then the switching device for interrupting the abnormal current…

Q: A PMMC instrument gives 27 mA at full scale reading when a potential difference across its terminals…

A: Given: For PMMC Im=27 mAVm=38 mV So, meter resistance Rm=VmIm=38 mV27 mA=1.407 Ω

Q: A galvanometer is rated to have a sensitivity of 80mA/cm.What will be the change in reading when the…

A: Given a galvanometer is rated to have a, Sensitivity = 80 mA/cm Current reading = 500 mA

Q: H. W1: - Determine if the following system are causal or not a.y(n) = x(2n) b.y(n) = 3x(n) – 4 x(n –…

A:

Q: 6. For the circuit shown, use source transformations to obtain an equivalent circuit as seen by the…

A:

Q: In a PCM system, 128 levels are present in the uniform quantizer. How many bits per sample are

A: Given information: In a PCM system, the number of levels present in the quantizer is 128.  The…

Q: b) Consider a sinusoidal type of signal to be sampled, for which the highest frequency is given as…

A: Given, Maximum frequency of message signal is fm = 45 kHz Therefore, Let us consider the message…

Q: You are performing a market basket analysis where there are over 5 million different types of…

A: To find the correct answer, we will refer all techniques and then choose relevant option based on…

Q: 6. A 50 hp, 440-V, three-phase induction motor with an efficiency of 0.90 and a p.f. of 0.85 on full…

A:

Q: A 15-kVA, 60 Hz, 240/120 V transformer has a core loss of 350 W. The full load copper loss is 650 W.…

A: In this question we will find primary current at maximum efficiency....

Q: Use the supuposition theorem, bind the current in the 40 A resistor of the circuit shown. 2on 10V sO…

A:

Q: choose the correct expression for C+ A BC: OB+A C OB +AC A + B C+ A B

A: Given: Boolean expression, F=C+A.B.C

Q: The circuit consist of a capacitor, inductor, resistor and voltage source in series, the standard…

A: Given, The circuit consist of some circuit elements in series, Capacitor Inductor Resistor Voltage…

Q: Determine ZT for the circuit if inductive reactive is 10220 and resistance is 9850. Answer:

A: Given: A circuit is having Inductive reactance, XL=1022 Ω Resistance, R=985 Ω

Q: The circuit consist of a capacitor, inductor, resistor and voltage source in series, the standard…

A:

Q: Q3. A relaxation oscillator is to generate train of pulses that is used to fire a Thyristor circuit…

A:

Q: ) G()H(s) s(s+3) (s +3)(s + 4) (s+1)(s + 2) ) G(s)H(s) s+3 s2-s-2 -(s)H(s)ɔ (m

A:

Q: Two single-single phase transformers are to be connected open-delta. What is the minimum kVA rating…

A: From given load power calculate load current in terms of load voltage.  KVA rating of transformer =…

Q: What is multiplexer? Explain.

A: The electronic device that is used to select the fixed or desired input, from the multiple range of…

Q: A 230-V, kVA single-phase transformer has an iron loss of 100 W at 40 Hz and 70 W at 30 Hz. Find the…

A:

Q: 3. Given the information appearing in the network, determine the following using the approximate…

A:

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.