From Kirchoff's law, the current I in an RC (resistor-capacitor) circuit during discharging obeys the equation R ²+²=C² = ( di(t) 1(t) dt a. Find I (t). b. For a capacitance of 10,000 uF charged to 100 V and discharging through a resistance of 1 m2, find the current I for t = 0 and for t = 100 sec. Note: The initial voltage is IR or Q/C, where I = dQ/dt.

From Kirchoff's law, the current I in an RC (resistor-capacitor) circuit during discharging obeys the equation R ²+²=C² = ( di(t) 1(t) dt a. Find I (t). b. For a capacitance of 10,000 uF charged to 100 V and discharging through a resistance of 1 m2, find the current I for t = 0 and for t = 100 sec. Note: The initial voltage is IR or Q/C, where I = dQ/dt.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

5. a. In an electricity experiment, it was observed that as the potential difference in volts across a thin platinum wire increases, the current in amperes changes as follows: (V,I) = (0,0), (1.0,0.112), (3.0,0.337), and (6.1,0.675). Plot the graph of potential difference as a function of current and indicate whether the platinum satisfies Ohm's Law. If so, what is the resistance of the wire?
For the circuit shown in the figure, C = 12 µF and R = 8.5 MQ. Initially the switch S is open with the capacitor charged to a voltage of 80 V. The switch is then closed at time t = 0.00 s. What is the charge on the capacitor when the current in the circuit is 3.3 HA? Hint: Use the current discharge equation to find the time. Then put that time into the discharge function for the charge on the capacitor. O 340 uc Ο 480 μc O 620 uC Ο 700 μC O 350 uc
An R=88MS resistor and a C =43. capacitor are connected in series with a open switch and an V = 45.4V potential source. The capacitor is initially uncharged. The switch is closed at t = 0. Determine the current in the circuit when the charge on the capacitor is 1/9 of its maximum value (in p.A). I need to look. At correct answer and show all work please
P For a given load resistance R, = 4.7 ohm, the power transfer efficiencies 7 P load of total a de voltage source and a de current source with internal resistances R, and R,, respectively, are equal. The product R,R, in units of ohm (rounded off to one decimal place) is
For the circuits of Fig. 1.P2, use circuit reduction and superposition to deter- mine the current through each of the resistors. What is the power delivered by each of the sources? (b) (а) 4k 2k 5k 2k 1mA 1k 5V 8k 6V 10V 3k 4k 2k ww 3k
Ohm's law for electrical circuits like the one shown in the figure states that V = RI. In this equation, V is a constant voltage, I is the current in amperes, and Ris the resistance in ohms. Your firm has been asked to supply the resistors for a circuit in which V will be 240 volts and I is to be 20±0.2 amp. In what interval does R have to lie for I to be within 0.2 amp of the value I, = 20? R. To what interval must R be held to meet the requirements for the resistance? ohms
Consider the circuit shown in the figure below, where C, = 8.00 µF, C, = 6.00 µF, and AV = 18.0 V. Capacitor C, is first charged by closing switch S,. Switch S, is then opened, and the charged capacitor is connected to the uncharged capacitor by closing S,. AV (a) Calculate the initial charge (in µC) acquired by C,. (Round your answer to at least one decimal place.) 144 (b) Calculate the final charge (in µC) on each capacitor. (Round your answers to at least the nearest integer.) Q, = 61.7 X µC Q2 = 82.3 X µC (c) What If? After a very long time, switch S, is also closed. By what amount does the charge on the second capacitor change after S, has been closed for a very long time? (Give your answer in µC.) 46.3 V µC
Equation1: Q(t)=CVcap(t) Equation 2: Qcharging(t)=CV(1−e^(−t/RC)) 1. Combine equations 1 and 2 to create an equation capable of finding the time-dependent voltage across a charging capacitor. Equation 3: I(t)≡(dQ(t))/(dt) 2. Combine equations 2 and 3 to create an equation capable of finding the time-dependent current across a charging capacitor.
sq 4. Maximum surface resistance. Consider a square sheet of side L, thickness d, and electrical resistivity p. The resistance measured between opposite edges of the sheet is called the surface resistance: R = pL/ Ld = p/d, which is independent of the area of the sheet. (R is called the resistance per square and is expected in ohms per square, because p/d has the dimensions of ohms.) If we express p by p=m/ne²t, then Rq=m/ndet. Suppose now that the minimum value of the collision time is determined by scattering from surfaces of the sheet, so that Td/v, where v is the Fermi velocity. Thus the maximum surface resistivity is Rmvp/nd²e². Show for a monatomic metal sheet one atom thickness that sq Rħ/e² = 4.1k, where lkn is 10³ ohms. sq
Consider the circuit shown in the figure below, where C, = 8.00 µF, C, = 6.00 µF, and AV = 18.0 V. Capacitor C, is first charged by closing switch S,. Switch s, is then opened, and the charged capacitor is connected to the uncharged capacitor by closing S,. AV (a) Calculate the initial charge (in µC) acquired by C,. (Round your answer to at least one decimal place.) (b) Calculate the final charge (in µC) on each capacitor. (Round your answers to at least the nearest integer.) Q1 = %3D (c) What If? After a very long time, switch S, is also closed. By what amount does the charge on the second capacitor change after S, has been closed for a very long time? (Give your answer in µC.)
In the schematic below two batteries are in series and drive current through the circuit as shown. The first resistor has a voltage drop AV = 2.8 V, the middle resistor has a resistance of R = 154 Q, and the last resistor has a voltage drop AV2 = 1.6 V. Given these parameters, what is the magnitude of current flowing through the circuit in milli-amps (mA)? Giver your answer to 3 significant figures. %3D AV, 3.0 V 4.5 V ww
The voltage, V, in a simple electrical circuit is slowly decreasing as the battery wears out. The resistance, R, is slowly increasing as the resistor heats up. Use Ohm's Law, V = IR, to find the rate at which the current, I, is dropping at the moment when R = 100 N, I = 0.12 A. %3D AP dt = -0.002 , and dR = 0.025 2. dt Note: voltage is measured in volts (V), resistance is measured in ohms ( 2), and current is measured in amperes (A); 1 V = (1 A) · (1 N).