Find the equivalent CapacitANce. If a 10 volt battery is connected to the Ceq, what is the potential energy of the circuit? IMF 3uF HH HH 44F 5uf Tzuf 2MF

Q: explain the principle of potentiometer and give TWO (2) functions in a robotic arm system.

A: The basic principle of potentiometers is that if the cross-sectional area of ​​the wire is uniform…

Q: Which of the following equations describes the relationship between the input, output, and system?…

A: Transfer function of a system is defined as the ratio of output of signal and input of the signal…

Q: Consider an aperiodic continuous-time signa x(t) having the corresponding Fourier transform X(jw).…

A: In this question we will find Fourier transform of given signal....

Q: If the absorption coefficient of silicon is 0.05 pm-1 at 860 nm, find the penetration depth at which…

A:

Q: What should be the power of the voltage supply that we will use in velocity selector region?

A: Velocity Selector Region:- A zone with a constant magnetic and electric field is known as the…

Q: The boolean function F=A+A'B+C+C'B' can be minimized to be equal to OA+B+C OA+C 01 00

A: Given function, F=A+A'B+C+C'B'

Q: Explore sources of static and dynamic power dissipation in CMOS logic.

A: CMOS refers to "Complementary Metal Oxide Semiconductor" . They are made of silicon and germanium,…

Q: Q3- A- Find £f(x)} for the square wave shown in the following figure. f(x) boca 2 3 4 1 5 6 7

A:

Q: Find out the Z transform of the unit step function. Show all calculation steps.

A: In this case, the Z transform of the unit step function is to be determined.

Q: For an SCR, the gate cathode characteristics is given by a straight line with a gradient of 16 volts…

A: We got an SCR with 16 volts per amp(V/A) Given Data, Minimum gate current (Ig)­min = 500 mA = 0.5 A…

Q: 15) Consider a system with transfer function G(s) = (s + 4)/ (ks^2 + s + 4). The value of damping…

A: Given data, Transfer function is given, Gs=s+4ks2+s+4=s+4s2+sk+4k

Q: Determine the value of the current i2 being supplied from the 2A source alone. Put your answer in…

A:

Q: 16. Determine the following from the given R-L-C series circuit: ) Impedance Z ii) Current i iii)…

A: We are authorized to answer only three subparts at a time since you have not mentioned which part…

Q: 24 V E2 b ↑2 A : 13 Ω 5Ω 5 A - 20 V 13 A multiloop circuit is shown in the figure. Considering…

A: The given circuit is shown below:  Applying K.V.L in loop 1 of the above circuit,…

Q: 13. A 200V DC Generator has a shunt field resistance of 200ohms. Its field current A) 1A B) 2A C) 3A…

A: 13. Given data, Terminal voltage V = 200 V Field resistance Rf=200 Ω Field current will be equal to,…

Q: 7. What is the word length of an 8-bit microprocessor?

A: The solution is provided in the following section.

Q: Calculate the response of the signal below:

A: Given- x[n] =3δ(n-1)+2δ(n)-δ(n+2)h[n]=2u[n+1]-r[n+1]+u[n]+2r[n-1]-3u [n-1]-r[n-3] To find- Response…

Q: R₁ R₂ Answer: R3 Quiz 3 - Q1CQ Given: R₁ = 14372 (Ohms) R₂ = 76172 (Ohms) R3 = 6227 2 (Ohms) Find…

A: Given circuit: R1=1437 ΩR2=7617 ΩR3=6227 Ω

Q: | ΜΑ For the op-amp circuit of Fig. 6.21, find Vo 10 ΚΩ wwwwww + V₁ V₂ ΜΜΜ 99 ΚΩ wwww 1 ΚΩ Hli RL Vo

A:

Q: The simplify expression for the K-map below is C0 AB 00 01 11 10 0 1 0 0 0 1 1 1 1 1

A: Given, The k-map is

Q: A dc machine is connected across 230 V supply and runs at 1200 rpm generating as emf f 210V with an…

A:

Q: The armature of a shunt generator has 0.05 ohm effective resistance. Each brush has an effective…

A: It is given that: Ra=0.05 ΩRb=2×0.01 Ω=0.02 ΩVt=100 VIL=40 A

Q: Write KCL equation for the current at node a in the circuit shown below. 1₁ R1 R3 a 13 12 www R2

A: Given circuit:

Q: property of Z transform.

A:

Q: A D'Arsonval galvanometer, 1 mA, 50 ohm is to be converted to a 5 Amp-ammeter. the value of the…

A: Given data, Rating of galvanometer Im=1 mA Resistance rating Rm=50 Ω Galvanometer to be converted as…

Q: A three phase motor canbe regarded as Balanced "Wye " load. A three motor draws 5.6 KW when the…

A:

Q: A 3-phase hydroelectric synchronous generator is rated 110 MW, 0.8 pf lagging, 13.6 kV, A-connected,…

A: We have an 3-phase hydroelectric synchronous generator with, Rating of generator = 110 MW Power…

Q: 8 + 12.5 Ω www Camuto 2011 και άλλοι 15 Ω -j25 Ω The voltage V₂ is 360 at angle 0° Vrms (360 Vrms at…

A: Given circuit: Vg=360∠0° V

Q: +1,0V +36 slokn 5.6kn B = 50, assume VBE) = 0.8V fina VE, VC, VB 1E, ib, ic

A:

Q: coso The electric field present in the region is given as E= P = 2.6838. The coordinates p and z are…

A:

Q: Find LT

A: In this case, the Laplace transform of the given function is to be determined.

Q: Which of the following is true when charging a capacitor using a DC source?     Current will flow…

A: The capacitor and inductor are two energy storage elements in electrical circuits. Capacitor stores…

Q: Show that the system shown in Figure (1) is equivalent to : C(s) R(s) Gp(s)Gc(s) 1+ Gp(s)Gc(s) R(s)…

A:

Q: If the reverse saturation current is 20 µA, then calculate the forward current for the voltage of…

A: Given, Reverse saturation current, Is=20 μA Diode voltage, VD=0.2 V At room temperature, VT=26 mV…

Q: A 500 V shunt motor running at 720 rpm takes an armature current of 50 A. The equivalent armature…

A: Terminal voltage V = 500 V Initial speed of motor N1=720 rpm Speed after adding resistance, N2=540…

Q: Two shunt DC generators G1 and G2 are rated at 100 and 150 kW at 110 V respectively. Their external…

A:

Q: 3. What is the value of constant B₁? A. -72 B. 0 4. What is the value of I'(0)? -72 A. B. 0 B. 25…

A: Given:  R=7.5 Ω, L=16 H, C=10-2 F and E=12 VAlso, i0=0 A and q0=0 C

Q: Calculate the equivalent resistance of the following circuit: 12 v 10 www R1 10 R2 10 R3

A: Given circuit:

Q: To access the services of the operating system, the interface is provided by the

A: The correct option along with the explanation is provided in the following section.

Q: Two wattmeters have been used to measure the power input to a 130 kW, 400 V, 3-phase slip ring…

A:

Q: 13) The transfer function of a system is given as 81/ (s^2 + 16s +81). Find the undamped natural…

A: Given data, Transfer function is given as, Ts=81s2+16s+81

Q: Answer the following questions pertaining to the following circuit: 6V a 12 Q e 8Ω b d Determine the…

A: The circuit is shown below:  a. The equivalent resistance of the above circuit is,  Req=12||6+8…

Q: A 30 hp, three-phase, wye connected, 60 Hz, 360 VLL, synchronous motor is operating at 50% full…

A: Given data: Resistance = 2.5 Ω/phase The power = 3 hp Core loss = 1 kw Windage loss = 1.5 kw

Q: Simplify the following expression: Y ABC + ABC +ABC + ABC

A: Given data, Expression is given, Y=A¯ B¯ C¯+A¯ B C¯+A¯ B¯ C+A¯ B C

Q: a) A balanced A-connected 3-phase load of 20 2 is supplied from 500 V/60 Hz mains supply. The load…

A: Given, A balanced delta connected 3-phase load of 20 ohm is supplied from 500 V/60 Hz mains.

Q: Determine the output time function, y(t), from the convolution integral y(t)=√ h{t=t\r{t}dt where…

A:

Q: voltage of v(t) = 4 cos(2π 43 t) volts is applied across the 33-ohm resistor. Find the total charge,…

A:

Q: Find the phase sequence of a three-phase circuit in which two of the phase currents of a balanced ∆…

A:

Q: X Express the reconstructed signal if x(t) is sampled at 80 Hz. Given x(t)= Acos[(130–20v)πt] v=1

A: The signal x(t) is given as x(t)=∑v=15Acos[130-20vπt]x(t)=Acos[130-20×1πt]+Acos[130-20×2πt]…

Q: Vo Answer: R1 + Ux ix Answer: - In the circuit above, use R₁ = 52, R₂ = 992, V = 42V, and k = 1/3…

A:

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.