explain the causes and process of a) Subsidence
Q: The relative velocity is defined so that VA/B-VA-VB-A graphical version of this equatio 0 Answer: 0-…
A:
Q: A rectangular concrete beam 120 x 300 mm is prestressed by straight cable, effective force 180 kN at…
A:
Q: The velocity of a particle is given by V=25t^2-80t-200, where V is in feet per second and t is in…
A: Give: V = 25t2 - 80t - 200
Q: Car A rounds a curve of 175-m radius at a constant speed of 36 km/h. At the instant represented, car…
A: It has been asked in the question to evaluate the velocity and acceleration of car A as observed…
Q: B) For the soil condition shown in Figure (1). Determine: 1- The rate of flow per unit area. 2- The…
A:
Q: a. The value of x from locating the neutral axis using Qtop Qbot in mm is [Select] b. The value of…
A: Answer (a) Consider 'x is a location of Neutral axis from the top as shown below Equate Qtop =…
Q: Assume the section has cracked and use the transformed-area method to compute the required…
A:
Q: Calculate the friction drag on a plate 0.15 m wide and 0.45 m long placed longitudinally in a stream…
A:
Q: 5- A solid sphere of diameter 240 mm is subjected to an external uniform pressure of 100 MPa. For E…
A:
Q: What method of selecting data is applicable when the second largest value (or lower) of the year…
A: The following different methods for selecting data are applicable in the above case. 1) Multivariate…
Q: A 9,000 gallon storage tank was purchased for $200,000 12 years ago. How much would a 12,000 gallon…
A:
Q: B) For the soil profile shown in Figure (2), the rate of downward water flow is 0.4 m³/hr.m².…
A:
Q: What will be the area ratio of a split barrel sampler having inside diameter of cutting edge as 35…
A: Given: Outside diameter of cutting edge, A1=51 mm. Inside diameter of cutting edge, A2=35 mm. Inside…
Q: Shear Question Factored shear force of 140 kN is applied on a beam having breadth 250 mm. The beam…
A: Given Data Factored shear force (Vu) = 140 KN Width of beam (b) = 250 mm Factored torsional moment…
Q: The uniform 5.5-m pole has a mass of 220 kg and is supported as shown. Calculate the force P…
A: Given data, Static friction = 0.31 Length of pole = 5.5 m Mass of pole = 220 kg
Q: explain the causes and process of b) Seawater intrusion
A: Sea water intrusion:- The passage of salty water into freshwater aquifers is known as sea water…
Q: 3. What mathematical law was being applied on the "General Rectilinear Motion" principle? Please…
A: The "General Rectilinear Motion" principle The "General Rectilinear Motion" principle refers to the…
Q: I. Proving. SHOW THAT 2 1 5. v = ² R³²S² → hf = 10.29n² LQ2 D16/3 6. v=0.849CD2.63 0.54 → hf =…
A:
Q: 5. Determine the flowrates distribution in each pipe using Har B 2.5 m³/s i. ii. iii. 10 m³/s- A…
A:
Q: B) For the soil condition shown in Figure (1). Determine: 1- The rate of flow per unit area. 2- The…
A:
Q: The reactions at the support for a simple beam loaded as shown. Neglect the weight of the beam. The…
A: Given: A simple beam with loadings Required: Support reactions Internal forces at C
Q: A 7.5m cantilever beam shown carries a 115KN/m uniform load. Point A is free end while point B is…
A: Given data in question Length 7.5 m UDL 115 kN/m A is free end To find out Value of EIY at free…
Q: A-5m as shown in the figure. The L300 has a will load of 12kN, 8kN and 6kN. The distance between…
A:
Q: Block A is connected to Cylinder B by a r od. If the weight of the cylinder is 50 KN, what is the…
A:
Q: A post tension beam section drawn below consists of three cables of 100 mm² area. Initial…
A:
Q: Know the load, warping and frictional stresses on a cement concrete pavement slab as 220 N/mm2, 300…
A:
Q: 1. At 10:00 am the inflow to a reservoir was 20 m³/s and outflow was 12 m³/s. At 10:30 a.m. the…
A:
Q: Fill in the blanks! 1. ................are used in open channels systems to control and regulate the…
A:
Q: A beam with a W360x45 section (Beam weight 45 kg) is used as a cantilever beam 7.5 m long. Find the…
A: uniform distributed load : A uniform distributed load is a force delivered uniformly over the length…
Q: Q.1 (a) A sluice gate in a 2.0 m wide horizontal rectangular channel is discharging freely as shown…
A:
Q: A company that manufactures pulse Doppler insertion flow meters uses the Straight Line method for…
A: An asset's book value is its value as expressed by the balance in its balance sheet account. Asset…
Q: 1-47. The beam is supported by two rods AB and CD that have cross-sectional areas of 12 mm² and 8…
A:
Q: Assume the section has cracked and use the transformed-area method to compute the required…
A:
Q: Two people weighing W each are sitting on a plank of
A:
Q: Draw the influence line for the force in member HC, IC and IJ of the bridge truss shown below. H B D…
A:
Q: Determine the equilibrium speed and cant to be provided on a BG curve of 3 degree if the speeds of…
A: Given,BG curveDegree of curve=3speeds of several trains running on the line are as follows: 15…
Q: Determine the force in each member of the truss. Note: Summary of forces should be listed in table…
A: given data:
Q: Q- The velocity of water at the outer edge of a 60cm diameter whirlpool, where the water level is…
A: Given- Diameter of whirlpool D=60 cm Velocity of water at horizontal water level V=2.5 m/s It is…
Q: A rectangular concrete beam 120 × 300 mm is prestressed by straight effective force 180 kN at…
A:
Q: If wheat requires 7.5 cm of water after every 28 days and the base period of wheat is 140 days, what…
A: Given data, Wheat requires 7.5 cm of water after every 28 days. Base period of wheat= 140 days…
Q: Determine the cracking moment in kip-ft for the section shown if: f'c = 4000psi and f₁=7.5√f'c. 9…
A: Given:- The compressive strength of the concrete = 4000 psi The steel reinforcement provided = 3-#10…
Q: Q2/ Determine the horizontal and vertical compounds force at pins A and C of the two member frame.…
A: A frame is loaded as shown below
Q: A Plate load test is carried out on submerged soil using a 300 mm radius rigid plate. A load of 5…
A: Given- Radius of rigid plate a=300 mm, Load P=5 tons=5000 kg, Deflection d=1.20 mm, Poisson's ratio…
Q: A town has an existing horizontal flow sedimentation tank with an overflow rate of 17 m³/day/m², and…
A: Given data- Overflow rate- OFR=17 m3/day/m2, Settling velocity- Vs=0.1 mm/s, Ideal sedimentation…
Q: 7 4 The precast floor system consists of a 150-mm-thick concrete slab carry its self weight as well…
A:
Q: 12 13 14 15- Design slow sand filters for a population of 40000 with an average rate of water supply…
A:
Q: A Plate load test is carried out on submerged soil using a 300 mm radius rigid plate. A load of 5…
A: Given data in question Radius 300 mm Load 5 Tons Deflection 1.20 mm Poissons ratio 0.5 To find out…
Q: A 6 hour storm has 6 cm of rainfall and the resulting runoff was 3 cm. if the phy index remains at…
A: Given data:- Precipitation = P = 6cm Runoff = 3 cm time = t = 6 hour if the ϕ index remains at the…
Q: A section Line AB 300m Long on a flat terrain measure 102,4mm on the vertical photograph. A radio…
A:
Q: A) For the soil profile shown in Fig. (2), determine: 1) Effective stress at point A. 2) Piezometric…
A:
explain the causes and process of
a) Subsidence
Step by step
Solved in 2 steps