Example 6 Four channels are multiplexed using TDM. If each channel sends 100 bytes/s and we multiplex 1 byte per channel. 1- show the frame traveling on the link, 2- the size of the frame, 3- the duration of a frame, the frame rate, and the bit rate for the link.

Q: From Jur

A: We can see that from june to july there is a decrement of  73 to 68. So option A is wrong because it…

Q: Obtain the transfer function C(s)/R(s) of the block diagram shown in the Fig.(4). G₂ Ge Gr G G₂ OU

A: Given data : The block diagram shown in below,

Q: +30V 15 ΚΩ www I₁ + VD Figure (a) + ID 25 ΚΩ ww 1₂ = 0.12 mA ID (MA) 2 m = 1.25 5 Figure (b) VD (V)…

A: For the above given electrical circuit we need to design it by calculating unknown values such as…

Q: 4. (c) A 3-phase Y-connected synchronous generator supplies current of 15 A having phase angle Of…

A: A synchronous generator is a device that uses electromagnetic induction to transform mechanical…

Q: Q2 If the unit step response of a network is (1 - e-at), then Find its unit impulse

A: Given data ; The unit step response is,  xt=1-e-αt

Q: What is the closed-loop transfer function of the following system? R(s) OY(s) OY(s) R(S) O M(s) G(s)…

A: Given control system block diagram, Given system having forward path Gs Unity feedback, Hs=1

Q: A solenoid coil has a resistance of 30 Ohms and an inductance of 0.5H. If the current flowing…

A:

Q: In a Two port network analysis, if the output port is short circuit, we will put a in the input port…

A: In this answer we will find the solutions to the above two questions by using the concepts of…

Q: Which of the following power is useful power? O Apparent Power Reactive Power Average Power OActive…

A: In this question,  We need to choose the correct option in this question.  In this question, we are…

Q: By using Laplace Transform for circuits analysis we O O Replace capacitor with impedance SC in…

A: For the capacitor: The current is given by: it=Cdvdt from which the s-domain is formed as :…

Q: 2. Find the inverse Fourier transform of the following signals. (a) X(jw) = (1-j)8(w - 3) + (1+j)8(w…

A:

Q: Given the circuit as shown, what is the expected approximate output dc voltage (Vout) if diode D1 is…

A: It is given that: Vrms=12 VVmax=122V

Q: نقطتان (2) St In the lab, If the circuit shown in the figure with R1= 3000 and R2=2000 ,R3=002, then…

A: Given data, R1=300 Ω, R2=200 Ω, R3=0 Ω Circuit diagram is given as,

Q: Q1: For the Instrumentaion amplifier shown below, drive the equation of v, and i,. R₂ ww CHI A₁ A₂ R…

A: 1)  To derive the equation of output voltage and current for instrumentation amplifier

Q: The time constant for the following circuit for t>O is 30 V O7S O 5S O 6S O3S LAS 12 V t=0 b 6Ω www…

A: We need to find out time constant for given circuit

Q: For the "tank" circuit in Fig. 14.79, find the resonant frequency. 1, cos ar -895 44) m 3002 1 μF

A:

Q: B/A shunt generator delivers 450 A at 230 v and the resistance of the shunt field and armature are…

A:

Q: 1. Let us assume that two homogeneous, isotropic di electric mediums with dielectric constants=3 and…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: (a) Find the s-domain expressions for the z-parameters of the two-port circuit shown in Fig. (b)…

A: Given circuit :

Q: Q2\ The adder-subtractor circuit of Figure below has the following values for mode input M and data…

A:

Q: If the value of capacitor in the time domain is 12.82 mF. What is its representation in the…

A:

Q: A half wavelength dipole of length 1-5 m is radiating into free space. If the dipole current is 2…

A:

Q: Question 1: a) Determine the current i. 60V 18 Ω Μ 4Ω i=3A Μ 3Ω Μ 4Ω 3Ω

A: This question comes under electrical circuit theory . It is based on the concept of calculation of…

Q: To solve the circuits using Laplace Transform we follow the following procedure O Simplify the…

A: In this question , we will write procedure of solving equations with Laplace transform....

Q: Compare the motor action with generater action principle.

A: Comparision of the motor action with generater action.

Q: Write a MATLAB function and testbench to obtain the first 10 elements of the following differenc…

A: GIVEN:               yn=0.5yn-1+xn where,   x0=1  FIND: write a MTLAB function to obtain first 10…

Q: The sensitivity SM of the system with transfer function A B C D 1 1+GH 1-H G 1+GH GH M = G 1+GH is…

A: Given, Transfer function, M=G1+GH

Q: For a filter works with low frequency 150Hz, the Vin is 25V and the resistor is 8.2KQ. Compute the…

A: The passive low pass filter can be designed by using the resistor and capacitor elements.

Q: (B): Obtain the transfer function V₂(s)/V₁(s) of the electronic cct. shown in Fig.(3) Vi(s) Fig. (3)…

A:

Q: Q2: Obtain the transfer function using Mason's gain formula for the following S.F.G., -0.5 R(s) 1 10…

A:

Q: For the circuit shown, find v(t) for t>0 Your answer 100 mF t=0 - ww 10 22

A:

Q: Tek Tektronix TBS 1052B-EDU Digital Oscilloscope 1.00V M 100us Station 2 Toaching M.Pos: 0.000s…

A:

Q: 2- نماز (b) X(jw) = (-w²-3.75 ju-1)(jw+0.625) Hand written plz only 'b' part

A:

Q: The waveforms shown below are V₁ and Vo of a schmitt trigger circuit. From these waveforms the…

A: The Given waveforms the values of the two comparison voltage V1 and V2 To Schmitt trigger circuit Vi…

Q: 2- نماز (0,625+ تعا) (1 - 3.753 - 2 - ) = (ساز)b) X)

A:

Q: 6. In an enhancement type MOSFET if: a) VGs > Vth and VDs Ov then the shape of the channel is b) VGS…

A:

Q: In an estable multivibrator using a 555 timer, the out put is and the high or logic (1) when the the…

A: Astable multivibrator using 555 timer : An Astable multivibrator using 555 timer is act like a…

Q: Obtain the transfer function H(s) = = i 0.5 F S 1 H m 2i 3Ω www + Vo S

A: the voltage across 3Ω is V0              the current is I=v03

Q: ARC. Circuit has the Following trans For Function & YUS) RUS) # 2. 105+4 For step input retis 20,…

A:

Q: Q: A full-wave rectifier produces an 80 V peak rectified voltage from a 60 Hz ac source. If a 10 uF…

A:

Q: state variable equations

A:

Q: Find the current through the resistor at t=0+, and at t=1.25s. The switch is closed at t=0 50V O 0,…

A:

Q: For a filter works with high frequency 150KHz, the Vin is 25V and the resistor is 8.2KQ. Compute the…

A: The passive high pass filter can be with the help of capacitor and resistor. The capacitor will…

Q: A 10V, 1kHz signal is applied to a 10mH coil with negligible winding resistance. Determine Q…

A: Given 10V, 1kHz signal is applied to a 10mH coil with negligible winding resistance. Here We have to…

Q: For the circuit shown, find v(t) for t>0 +1 100 mF t=0 + v (t) 10 92

A: At t=0-, just before the switch is closed, the circuit is shown below:  Vc(0-)=vs Using the…

Q: A 50 MVA, 11 KV three-phase alternator was subjected to a different types of faults. The fault…

A:

Q: (B): Obtain the transfer function V₂(s)/V₁(s) of the electronic cct. shown in Fig. (3) Vi(s) C₁ R₂…

A:

Q: Why transient steady in electric circuits is important ?

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: The force between two long parallel conductors is 15 kg/meter. The conductor spacing is 10 cm. If…

A: It is Given that:Force between two long parallel conductor is=15 Kgmd=10 cmI1=2I2

Q: handwritten answer Q. What are the types of different CMKs in Amzon KMS?

A: CMK stands for custom key storage is an AWS KMS resources which is mainly connected with hardware…