EX1: 220KV bollz 3-Ø transmission Line has a length of Hokm. The resistance Per Phase is 0.152/km and the inductance is 1.3263 MH/KM. Find the voltage and Power at the sending side. Also find the voltage regulation and the efficiency when the load has 381 MVA at c.flag Power factor-

Q: 102 Exercise 2.31 Find a minimal Boolean equation for the function in Figure 2.86. Remember to take…

A: Given data: The truth table is  A B C D Y 0 0 0 0 0 0 0 0 1 1 0 0 1 0 X 0 0 1 1 X 0 1 0…

Q: how that a series LR circuit is a lowpass filter if the output is taken across the resistor.…

A:

Q: Supplemental Problem #3: An x-polarized constant-frequency electric field plane wave is propagating…

A: Given data We have x-a polarized constant frequency electric field. The direction of the propagation…

Q: Given the potential function in free space to be, V(x) = (50x² + 50y² + 50z²) volts, the magnitude…

A: Given: Potential function in free space. Vx,y,z=50x2+50y2+50z2 The magnitude and direction of…

Q: Fig. I shows a 60 Hz, three-phase power system with a load. The source is a three-phase, A-connected…

A: I have written this solution as handwritten solution. Hope you find the solution clear.

Q: i dont understand where va and vb came from and even if ib=0 how did u get the formula following it,…

A:

Q: Obtain the Thevenin equivalent circuit

A: In this question We need to determine the Thevenin equivalent across the terminal a and b.  We are…

Q: Through careful application of the supermesh technique, obtain values for all three mesh currents as…

A:

Q: 4. Obtain i, and iz for t > 0 in the circuit 4u(t) A ΣΩ Μ ell 3 Ω ἐπ ΤΗ 12 1Η

A: Given the circuit the current is given the step function

Q: A three phase, 50 Hz, 20 km long overhead line supplies 1100 kW at 11 kV, 0.8

A: Given,Frequency, f=50 HzLength, l=20 kmPower, P=1100 kWVoltage, V=11 kVPower factor, pf=0.8 lagLine…

Q: 3. Determine v(t) for t> 0 in the circuit.

A: It is given that:

Q: 7. A CT function x(t) is non-zero over a rahge of its argument from -2 to 3. It is convolved with…

A: Given, The CT function x(t) and y(t) are shown below,

Q: 5. Electrical System: Find the transfer function G(s) = √(s)/ V¡(s) for each electrical network as…

A:

Q: A separately excited DC motor rated 400 V, 15 A, 1500 RPM drives a constant torque load at rated…

A:

Q: 1. Determine the input impedance, output impedance and voltage gain for the circuit below. Beta for…

A: Since you have posted the multiple questions so we are supposed to answer 1st one only. 1) this…

Q: For the following truth table, write the corresponding SOP canonical formula in algebraic form and…

A:

Q: b) Figure Q4 shows a three-line network. The load currents and the fault levels at various locations…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Use nodal analysis to find V, in the following circuit: 20 Ω Here, vx = (40+ 9 υχ Μ 10 Ω Μ 20 Ω ) V…

A:

Q: NE 12 V ww w Fig. 2.182 Mi 14. Determine Thevenin's equivalent circuit which may be used to…

A: Given Data: A DC circuit with, Voltage source of 12 V and Six Resistors To Find: Thevenin's…

Q: For the circuit shown in the following figure, If Vin = 5 V, the slew rate is equal to R 15 ΚΩ…

A: Given data, Circuit diagram is given as,

Q: 1. Find the Thevenin and Norton equivalent circuits for the active network shown in Fig. 2.241 (a).…

A: a) Thevenin & Norton Equivalent circuit is asking, to the given problem. We have to find Vth and…

Q: From the given circuit below, solve for 1₁; ₂ and I, using two (2) methods:

A: It is given that:

Q: On the step 4 what does mean default: n_s <=Idle;  assign y = (c_s == s7) ? 1:0;  Can you help me…

A:

Q: 2. The only junction of an SCR that measures like an normal diode is a. the anode-cathode junction.…

A: We need to select correct option for SCR .

Q: (d) Analyze the circuit below to find f in terms of inputs x and y. να 1 με 1 ΜΩ 1 ΜΩ το Μ 5 ΚΩ Μ…

A: it is asked to find the output in terms of given inputs for given multi level op amp circuit

Q: 8. By applying nodal analysis to the circuit of Fig. 2.90, find and I All resistance values are in…

A: In this question We need to determine the value of unknown currents.  We are solving this problem…

Q: The variable resistor (R0) in the circuit attached is adjusted for maximum power transfer to R0. a)…

A: The given question is based on the concept of maximum power transfer. It involves finding the value…

Q: Combination of 3 Unequal Resistors I In the circuit Delo ne three resistors have different…

A: Given Data: A three-parallel branch circuit with Voltage source = V Resistors R1=40 Ohm, R2=35 Ohm,…

Q: In the network shown in Fig. 2.177 find the current that would flow if a 2-12 resistor was connected…

A: Given: A network, To find: The current that would flow if a 2Ω resistor was connected between…

Q: termine the value of Ia in the circuit. 21. ΣΩ 4V Ia| {2 Ω ΙΩ ΔΑ

A:

Q: 4. f(a,b,c,d)= (a+b) (a+c+d) (a+b+ d) (a + c+ d)

A:

Q: 13. Compute the power dissipated in the 9 ohm resistor in the Fig. 2.250 by applying Superposition…

A: Given the circuit,

Q: 13. Compute the power dissipated in the 9 ohm resistor in the Fig. 2.250 by applying Superposition…

A:

Q: In the car wash circuit, photo switch 5 and the drier override switch are used to control the dry…

A: Given a car wash circuit photo switch 5 and dryer override switch are used to control the dry area.…

Q: 11. Connect the circuit of Figure 2-13. Place CM switch 3 in the ON position to change the value of…

A: Given the circuit  using the CM switch 3 in the ON . R1=100 Kohm

Q: lab ex for the following non-inv Op-amp by Analyzing the equiv Crout as@ non-Ideal, Ⓒas ideal…

A:

Q: The variable resistor in the circuit attached is adjusted for maximum power transfer to R0. a) find…

A:

Q: 19. Using delta-star transformation, determine the current drawn from the source in the given…

A:

Q: (a) A 3 phase 4-pole induction motor is supplied from 3 phase 50Hz ac supply used as conveyor motor…

A: I have written this solution as handwritten solution.Hope you find the solution clear.

Q: 3. Construct the complex plane of the finite poles and zeroes of the following transfer functions.…

A:

Q: c) Three single-phase transformers rated at 150KVA, 3000V/300V, 50Hz, are connected in wye-delta on…

A: Given the 3 single phase transformer at 1500 KVA ,3000 V300 V,50 Hz,wye delta on 6250 V,Load=150 k

Q: Given the transfer function Vo(s) 6 A(s) s+3 compute the voltage vo(t) at the steady-state for a(t)…

A:

Q: In the equation for part 2 should the first term be AB instead of AD. You have AB in the original…

A: Given minterms are 8,11,12,13,15 Don't cares are 0,1,2,5,7,10,14 Asked to find output expression?…

Q: 6 v 1000 Find value of I 400 0 www 100 0 200.0 www

A: In this question We need to determine the current I as shown the circuit.  We are solving this…

Q: Compute the equivalent resistance voltages and currents of the series parallel circuit

A: The equivalent resistance can be calculated by using resistance reduction techniques and the…

Q: Using the mesh current method, find the currents i1, 12, and i3 in the circuit of Figure 4.…

A: We need to find out mesh current by using of mesh analysis .

Q: Find the fundamental frequency wo and the Fourier series coefficients for the following signals (a)…

A:

Q: Given that the marked current (lower center) is 0.5 amp, find the powers of the two sources. Problem…

A: We need to find out the power for both sources .

Q: 6. R = 10, 2, C = F and L = 1, H Compute the current i(t) at the steady-state for Ao = 6, A, e(t) =…

A:

Q: 7. With the help of Superposition theorem, compute the current in the circuit of Fig. 2.122. All…

A: answer :  given that a linear circuit  to find the current Iab

Short Transmission Line

A short transmission line is a transmission line that has a length less than 80 kilometers, an operating voltage level of less than 20 kV, and zero capacitance effect.

Power Flow Analysis

Power flow analysis is a topic in power engineering. It is the flow of electric power in a system. The power flow analysis is preliminary used for the various components of Alternating Current (AC) power, such as the voltage, current, real power, reactive power, and voltage angles under given load conditions and is often known as a load flow study or load flow analysis.

Complex Form

A power system is defined as the connection or network of the various components that convert the non-electrical energy into the electric form and supply the electric form of energy from the source to the load. The power system is an important parameter in power engineering and the electrical engineering profession. The powers in the power system are primarily categorized into two types- active power and reactive power.