Create your own Workplace Housekeeping Inspection Checklist for a NETWORK /CABLE Company with the following areas:   General Areas: ◦Floor and Other areas ◦Aisles and Stairways ◦Spill Control ◦Equipment and Machinery Maintenance ◦Waste Disposal ◦Storage ◦Fire Prevention   Example: ◦Floor and Other areas 1. Are floors clean and clear of waste? 2. .... 3. .... ◦Aisles and Stairways 1. Are aisles unobstructed 2. .... 3. ....   Note: Please make sure it is for a cable company. Thank you!

Q: B. A truck with axle loads of 30 kN and 500 kN on a wheel base of 4 m rolls across a 8-m span.…

A:

Q: What is the area of cut in square metre? what is the average cut in metres? what is the volume of…

A: Grid Method is used to find the volume of cut and fill in earthwork. In grid method we divide the…

Q: Explain how the functional characteristics and design selection criteria are informed by proposed…

A: OPERATING/FUNCTIONAL FEATURES OF THE PROPOSED BUILDING - 1. The proposed structure should be strong…

Q: Expand the drawing board on the AutoCAD screen - Limits - Units - Properties O - Zoom -all

A: Given - Expand the drawing board on the AutoCAD screen   - Limits   - Units   - Properties   - Zoom…

Q: (c) A circular cylinder is rotated about its own axis at a constant rate of 1500 rpm Determine the…

A:

Q: A mass weighing 16 lb stretches a spring 3 in. The mass is attached to a viscous damper with a…

A:

Q: pare the positive and negative effects of disinfection of wastew

A: Introduction- Wastewater experts will become familiar with the aces, cons, and expenses of different…

Q: 431 seconds*726 * 89

A: Given:- 431 seconds*726 * 89 To find:- product of 431 seconds*726 * 89

Q: USE NSCP 2015 A W460X177 is used as a compression member with one end fixed and the other end fixed…

A: Given values: Section used: W 460*177 Length, L =3657 mm One end fixed and other end fixed against…

Q: Three turbines each of capacity 10000 kW are installed at a hydel power station. If the peak load…

A: Given data, No. Of turbines = 3 Capacity of Each turbine= 10000kW Peak load = 25000kW Average load =…

Q: A pump handling a liquid raises its pressure from 1 bar to 30 bar. Take the density of the liquid as…

A:

Q: Q1: The table below represents the annual average rainfall (mm) for each station A with the average…

A: Given data:

Q: In reference to the figure, 0.125 m B Vo = 10 m/s аллл 30° Determine the velocity in m/s of point A…

A:

Q: Two hills B and C have elevations 590m and 780m respectively. Hill A which has an elevation of 676m…

A: given- The given situation is shown in the below diagram-

Q: A sample of dry sand has a volume of 1000 ml in its natural state. Its minimum volume when compacted…

A: given Dry sand-volume V=1000 mLminimum volume Vmin=750 mLMaximum volume Vmax=1320 mL

Q: 1. The angular momentum equation becomes ΣM = E(rxV)pV. A if the convective term of the angular…

A:

Q: 5 -2 01 Given A=-2 6 2 , and X= x₂ 0 2 7] show that XTAX = 27, suggest that 5X + 6X2+7X3-4X₁X₂ +…

A: →GIVEN DATA:-⇒A= 5-20-262027 , X=X1X2X3⇒XT= X1X2X3

Q: (c) A circular cylinder is rotated about its own axis at a constant rate of 1500 rpm Determine the…

A: Given, Number of rotations in 1 minute (60seconds) , N= 1500 radial distance r = 15 cm = 0.15 cm…

Q: A: B: 1) Complete the leveling field notes shown in the table by computing and recording the…

A:

Q: A square steel bar of 50 mm side and 5 m long is subjected to a load whereupon it absorbs a strain…

A: Given data- side of the steel bar=50 mmlength = 5 mstrain energy = 100 JTo Find-Modulus of…

Q: A pin-connected truss is loaded and supported as shown. Each aluminum member has a cross-sectional…

A: GIVEN DATA:-⇒a = 4.25 ft⇒b = 5.10 ft⇒A = 2.1 in2⇒σ = 35 ksi

Q: (c) A circular cylinder is rotated about its own axis at a constant rate of 1500 rpm Determine the…

A: Asked: To determine the centripetal acceleration for the given rotating cylinder and the ration of…

Q: A compound shaft consists of segment (1), which has a diameter of 1.5 in., and segment (2), which…

A:

Q: Explain

A: This question is from Environmental Engineering.

Q: Sketch a typical surface water treatment plant, label all its parts, and explain their functions.

A: Wastewater treatment : Wastewater treatment is the process of removing impurities from wastewater…

Q: In the traverse below, angles measured by theodolite as following: ABC-88°20', BCD-250°15',…

A:

Q: Q2: In the sewage pipe project, the readings of the ruler from left to right were as follows: 0.680,…

A: Given data in question  Staff reading  Elevation of 1st point To find out  Elevations and check Note…

Q: Calculate the average speed of a body traveling 120m to the south in one minute

A: Given data,  Distance = d = 120m  Time = 1 minute = 60 sec  Find : Average speed (S) ?

Q: A spiral easement curve has a length of 100m with a central curve having a radius of 310 m. The…

A: Note : As per our company's guidelines we are allowed to solve 1st three sub-parts only.  a. Find…

Q: In reference to the figure below, if us = 0.2 at the rear drive wheels B of the 1.5 Mg vehicle with…

A: The entire load of the car will get transferred through the front and rear wheel pair. And…

Q: number

A: The true statement is the surface dressing can also be considered for the single carriageway, major…

Q: Use the graphical method to construct the shear-force and bending-moment diagrams for the beam…

A: Given A beam Required  Shear force and bending moment diagram  and (a) Determine V and M in the beam…

Q: For the beam shown, the magnitude of the concentrated load is 29 KN, the magnitude of the couple is…

A:

Q: Q2: For an open channel slope (1/200) and (n=0.015). Find the discharge in (L/hr), and shear stress.…

A:

Q: Q2: The table below represents the vertical coordinates of the hydrograph of a rainstorm over a…

A: Given data:- Mountain area, A=770 km2 Below table is given; 72 66 60 54 48 42 36 30 24 18 12 6 0…

Q: Situation III: Given the grouped data for the strengths of the reinforcing steel bars. 7. Determine…

A:

Q: L=10 m E=200 GPa P=30 KN A 212 22 212 B

A: Solution: Given: L = 10 m E = 200 GPa P = 30 kN

Q: * Consolidation is a process to reduce the moisture content within soil structure. True A O False…

A: Consolidation is a process in which soil reduces it's mositure content under the action of applied…

Q: A force of 40 Newtons is applied to an object at an angle of 37 degrees from the horizon, displacing…

A:

Q: Question(5): (A) (Practical Question) In Figure (4), water flows through the pipe at A with a…

A:

Q: 15) A distance from the point to the given line. 16) The elevation is 17) The point which has two…

A: These all questions are from surveying As per bartleby guidelines here I am solving three questions…

Q: Draw the profile for the point below: Distance (m) 0 22 30 45 60 78 85 91 125 150 Elevation (m)…

A: To Determine Draw the Elevation from from the given distances and the elevation at those distance…

Q: e 1 0.97 0.85 0.75 o' (kN/m²) 20 50 180 320

A: Given : H = depth of clay soil in field = 1.37m             σ0' = effective stress = 70 KN/m2σ0' +…

Q: Consider a point in a structural member that is subjected to plane stress. Normal and shear stress…

A:

Q: If we don't use Rotate's command, we can replace his work using O - Copy then instruct Mirror Copy…

A: Option 3rt is correct :- None of the above is always true. Mirror command :- mirror command use to…

Q: For the beam shown in the figure, find the shear stress at a point 30mm above the bottom of the beam…

A:

Q: Q5: A vertical arc of 500 meters in length connects a line that rises with slope +1.35% and meets…

A: Given Data:Length = 500mg1 = -1.80%g2 = +1.35%Station 18+00

Q: Create a calendar showing the beginning and the end of daylight saving time for the years 2016–2022.

A: To find:- Create a calendar showing the beginning and the end of daylight saving time for the years…

Q: Q2: In the sewage pipe project, the readings of the ruler from left to right were as follows: 0.680,…

A:

Q: The stresses shown act at a point on the free surface of a machine component. Normal and shear…

A:

Electric Circuit and Components

An electrical circuit or electrical network is a pre-determined pathway to make the electrons flow in the desired direction. The flow of electrons will set up a current flow in the circuit. Normally, the flow of electrical current is opposite to the flow of electrons. An electron is a fundamental sub-atomic particle of an atom possessing a negative charge. To initiate the flow of current and achieve the desired output, the electrical circuit should necessarily be composed of closed pathways. The pathways are made-up of good conductors of electricity such as aluminium and copper.