Convert the equation "PV =0.8206nT" to one relating P(psig), V(ft³), n(lb-mole), and T(°F). b. A 30.0 mole% CO and 70.0 mole% N2 gas mixture is stored in a cylinder with a volume of 3.5 ft3 at a temperature of 85°F. The reading on a Bourdon gauge attached to the cylinder is 500 psi. Calculate the total amount of gas (lb-mole) and the mass of CO (Ibm) in the tank. c. Approximately to what temperature (°F) would the cylinder have to be heated to increase the gas pressure to 3000 psig, the rated safety limit of the cylinder? (The estimate would only be approximate because the ideal gas equation of state would not be accurate at pressures this high.)

Q: A certain fluid at 10 bar is contained in a cylinder behind a piston, the initial volume being 0.05…

A:

Q: Saturated liquid ammonia is entering a 50 cm diameter 10-m long pipe at a steady 0.1 kg/s mass flow…

A: Given: Saturated liquid ammonia enters a pipe of diameter d = 0.5 m or 50 cm and L = 10 m.  The mass…

Q: Which of the following is sulphur compound. ΟΟΟΟΟ O None of the these O Pyridine O Cumene Ehtyle…

A: Given data: Find Sulphur compund  (Pyridine, Cumene, Ethylene mercaptan, Nathenic acid)

Q: A mixture of 0.5 benzene and 0.5 toluene was flashed into liquid and vapor phases at 368 K and 1…

A: A mixture of benzene and toluene is flashed vaporized.

Q: Final purification stage in the preparation of a pharmaceutical product A from natural sources…

A: Flow rate of recycle stream is to be determined.

Q: 1) CI and Kw are among the most important classifications adopted in the classification of crude oil…

A: Note: We are authorized to answer three multiple choice questions at a time, since you have not…

Q: 3. A gas is confined in a 1.20(ft) diameter cylinder by a piston, on which rests a weight. The mass…

A:

Q: I am trying to decide thesis topic for chemical engineering. Help me find thesis topic related to…

A: Chemical Engineering is known to create Valuable Products from waste.

Q: A mixture of dichloromethane (1) and ethyl acetate (2) and is separated in a flash drum at 1 bar. a)…

A:

Q: 2 kg / h of liquid octane (C8H18) are burned at 25° C with 180% of the theoretical air demand at 4…

A: Flow rate of liquid octane = 2 kg/h  Temperature = 25°c  Excess air = 180% = 1.8 at 4 bar and 400 K…

Q: Molecular weight data for some polymer are tabulated here. Compute (a) the number-average molecular…

A: From the given tabulated data we required to calculate the number - avg mol wt.This will be done by…

Q: Determine the work done while a body of mass 47 kg is lifted through a distance of 20 m. Also…

A: For a detailed solution, please see the attached files.

Q: What is main objective for Waste Vegetable Treatment to produce electricity

A: The main objective of the waste vegetable treatment is to be mentioned.

Q: O He 1.0 L 0.50 atm O Ne 1.0 L 0.40 atm All gases at T = 0°C Ar 2.0 L 0.20 atm Which gas has highest…

A: Given data is for three gases at T=00 C=273.15 K (constant temperature)- Helium (He) at, P=0.50 atm,…

Q: What is specific objective for Waste Vegetable Treatment to produce electricity

A: According to Reports, In India, there are almost 12% of the total agriculture produce go into waste.…

Q: An experiment on the growth rate of certain organism requires an environment of humid air enriched…

A:

Q: The solution to Fick's 2nd Law provided in the textbook (Eq. 5.11) for the process of carburization…

A: Given data: Initial composition of carbon in steel = 0.3 wt % Distance = 0.2 mm Time = 1 h

Q: A storage tank with a volume of 60 m² contains a mixture of CH., H₂, and C₂H₂ at 27 °C, 200 kPa. The…

A: For the detailed solution, please see the attached files.

Q: - Blood flow from the left ventricle into the aorta can be modeled as a reducing nozzle (Figure…

A: Given data: Diameter of tube at location 1 = 3.1 cm Diameter of tube at location 2 = 2.7 cm Pressure…

Q: Final purification stage in the preparation of a pharmaceutical product A from natural sources…

A: The pharmaceutical product A is prepared by centrifuging and continuous filtration process. Given…

Q: Give the major product(s) of the following reactio NaCN ㅁ H CN OH Br OH OH Br OH CN

A:

Q: We desire to produce two ethyl alcohol-water mixtures each containing 90% and 50% alcohol by mole…

A:

Q: A modified atmosphere requires higher-than-normal amounts of oxygen but sparing amounts of water…

A: Given that, The composition of stream A (dry air) xN2,A = 0.79xO2,A = 0.21xH2O,A = 0 The composition…

Q: A mixture of 2.00 g of H2 and 14 g of O2 is placed in a 1.8 L flask at 35.5°C. Assuming each gas…

A: Given data: Mass of H2 = 2 g Mass of O2 = 14 g Volume of flask = 1.8 L Temperature = 35.5 0C

Q: What is specific objective for Sewage Water Treatment to produce electricity

A:

Q: Convert the following: Show detailed dimensional analysis Btu h-ft-°F W m-k 3.33- to

A:

Q: here. The fraction recrystallized-time data for the recrystallization at 350°C of a previously…

A: The solid's transformation from one phase to another phase is described by the Avrami equation. This…

Q: An experiment research would produce a 1200 gram magnet material Neodymium-Iron-Boron Nd2 Fe14 B…

A: Given that,  Mass of sample of Fe3B = 500 g Mass of magnet material (Nd2Fe14B) produced= 1200 g…

Q: Given the following reaction with a feed rate of 10.0 kg/s each of H₂ and O₂: 2H2(g) + O2(g) → 2H₂0…

A: Given reaction of H2 and O2 is  2H2+O2→2H2O Feed rate=10kg/s conversion(XA) =0.67 Water enters at…

Q: - The following data represents a polymerization of styrene (3.34 mol/LS) after a fix benzene at…

A: Given that- Concentration of styrene, M= 3.34 mol/L.s Concentration of hydrogen peroxide initator,…

Q: A 15kg sample of water is held at 200°C in a variable-volume container (a piston-cylinder…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part…

Q: 5. A hypothetical gas obeys the equation of state pVt = nRT (1 + ap), where a is constant. For this…

A: Given, The equation of state is pVt = nRT1+ap        ......1 Here, p is pressure, Vt is total…

Q: Suppose a non-ideal gas has reduced pressure 3.5 and reduced temperature 1.5 at 98.5 atm and 410K.…

A: The ratio of pressure and critical pressure gives reduced pressure. Similarly, the reduced…

Q: 2 2 4 The reaction between ethylene and hydrogen bromide to form ethyl bromide is carried out in a…

A: Refer to the process flow diagram shown below for the given problem. Here, Basis: F = 100 mol of…

Q: Final purification stage in the preparation of a pharmaceutical product A from natural sources…

A:

Q: Nitrogen compounds poison the metallic catalysts used in the refining process, and do the problems…

A: Given that there is a statement given ,we have to identity this is true or false statement

Q: If the tank was actually pressurized such that the top surface of the milk was at a pressure of…

A: Given Bottom pressure=40kPa Top pressure=110kPa SGmilk=1.030 Find Actual height of milk in the…

Q: Determine the process control strategy shown in this figure. Steam Feed FIT O Feedback Control O…

A: In the given figure, we have two input streams, one is the feed, and another one is the steam.…

Q: Steam enters an adiabatic turbine at 1.2 MPa and 451 °C and leaves at 129 °C with a quality of 44…

A: Given  Adiabatic turbine with Intel pressure P = 1.2MPa Intel temperature of turbine T = 451 oC At…

Q: A stack gas from a combustion reaction is given off of a furnace which contains mole fractions of…

A:

Q: Which of the following compounds is called 18-Crown-6? A B 0 C

A:

Q: The polymerization of vinyl chloride (1.6x105M) is carried out using hydrogen Peroxide (0.4x106 M),…

A: Given data are as follows: Initial rate(Ri)=1×10-4mol/L.S, DP=300, Kd=1, f=1

Q: PROBLEMS 1 A 40-ft "fiberglass" boat hull weighs 2000 kg. Sixty percent of that is a fully cured…

A: Given the 40-ft fiberglass boat hull Weight of the fiberglass boat hull = 2000kg Out of which 60% is…

Q: Two well agitated tanks are connected to each other as seen above.  Initially, Tank 1 contains 480…

A: There is no accumulation in the system. So the mass balance would be the mass at the inlet will be…

Q: I need the answer as soon as possible

A:

Q: The internal energy of ideal gases only depends on temperature. When this is used with the energy…

A: Given Data: Internal energy of an ideal gases depends on temperature only Process is an ideal gas…

Q: In a Nal(Tl) detector with the energy calibration equation E(x) = 1.0322x - 16.61, a measurement was…

A: Given that- for NaI (Tl) detector with the energy caliberation equation as- E(x)=1.0322x-16.61 After…

Q: Problem #1 o How many moles of gas are present in a 25L chamber containing a pressure of 750mmHg at…

A: It is given that gas is present in the chamber. Given data are as follows: Volume of gas = 25L…

Q: 14 The temperature achieved when two fluid streams of differing temperature and/or composition are…

A:

Q: . sider the composite solid shown. Solid A is a ther mally conductive material that is 0.5-cm thick…

A: INTRODUCTION  HEAT TRANSFER THROUGH CONDUCTION -  CONDUCTION IS MODE OF HEAT TRANSFER SPECIALLY IN…