Consider the following sequence of outcomes for a particular branch instruction: T, NT, T, NT, T, NT, T, NT…. Assume this sequence repeats indefinitely. Part A: The Easy Part What is the long-term (steady-state) accuracy of the predict-taken predictor? What about predict-not-taken?

Q: If an instruction is rejected, the system records a message on VA page 30. What does this mean? In…

A: The answer to the question is given below:

Q: Consider a program with 15% of all instructions are branch instructions, and 60% of these branch…

A: EXPLANATION DONE DOWN

Q: In the event an instruction is refused, what would be the result? In the following cases, a…

A: When an instruction is written to page 30, it comprises the following information: If the…

Q: Do you know what occurs when an instruction is rejected? A software-managed TLB would outperform a…

A: TLB: TLB stands for Translation Lookaside buffer. It is called a special type of cache used to keep…

Q: For the problems in this exercise, assume that there are no pipeline stalls and that the breakdown…

A: 1. Uses of data memory: The data memory is used by LW and SW instructions, so the answer is: 25% +…

Q: What happens if an instruction is not accepted and it writes to VA page 30? In the following…

A: Introduction: When a command is sent to VA page 30: If the instructions want to write to Virtual…

Q: What happens if an instruction isn't received, and it's recorded on VA page 30? Software-managed…

A: The following table shows the substance of a 4-entry TLB.

Q: What happens if an instruction fails to get approval before writing to VA page 30? In the following…

A: Introduction: The TLB caches recent virtual memory to physical memory translations and maybe an…

Q: The following instruction is executed. Assume that before execution, register R12 contains 0x05, and…

A: Instruction Pointer:- The program counter (PC), commonly called the instruction pointer (IP) in…

Q: A hardware designer is trying to choose between two code sequences running on the same computer. The…

A: The speed of a computer processor, or CPU, is determined by the Clock Cycle, which is the amount of…

Q: Write a delay loop with appropriate values of the count to get a delay of 1 second. THERE: HERE:…

A: Answer: We have explain in very well for given question

Q: Do you know what would happen if an instruction was rejected? When compared to a hardware-managed…

A: If the instructions specify that they desire to write to Virtual Address (VA), they try to locate it…

Q: Do you know what occurs when an instruction is rejected? A software-managed TLB would outperform a…

A: Instructions that write to VA page 30The Translation Lookaside Buffer (TLB) table is searched for…

Q: Q2: A- Give a short answer to i- ii- ii- iii- iv- V- vi- vii- ix- the following: Why POP instruction…

A: 1) PUSH stores a constant or 64 bit register out onto the stack. The POP instruction retrieves the…

Q: If the execution time of pipeline instruction execution is not balanced, what inefficiency must be…

A: Pipelining does not help with one job delay, it helps to get through all the workPipeline level is…

Q: 6. Fill in the requested register values on the right side of the following instruction sequence:mov…

A: Solution: mov esi,OFFSET myBytes mov ax,[esi]; a.Ax=20210h mov eax,DWORD PTR myWords;…

Q: Read the Assembly program carefully, understand its working/functionality and answer the below given…

A: The aim of this program is to find the largest among given set of “10” numbers. Numbers are stored…

Q: How long will the code snippet take to execute on a single-cycle processor with a clock frequency of…

A: Given: clock frequency = 1GHz (1 Giga Hz =109 Hz) Instruction is executed on a single-cycle…

Q: Consider two instructions (m and m+i) are executed in 4 stages pipelining process where the last…

A: Below i have answered:

Q: If the following code segment is pipelined, which are the instructions affected by data hazards and…

A: Answer related to finding hazards in the above instruction is stated in step 2 .

Q: Suppose CX=8520H and BX=62EDH. Determine whether the ABC label will execute after the conditional…

A: Assembly language is a programming language where there is a solid correspondence between the…

Q: The following instruction is executed. Assume that before execution, register R12 contains Ox90, and…

A: Registers are brief stockpiling areas inside the CPU that hold information and addresses. Its…

Q: 8. For a single cycle processor, the instruction breakdown of a program is listed as following. add…

A: The above question is answered in step 2:-

Q: Evaluate the statement below and show how to compile into MIPS code by using instruction set machine…

A: Suppose, G=3,H=1,I=5,J=4 F=(3+1)*(5+4) = 4*9 = 36 Suppose, F is $t0, G is $t1, H is $t2, I is $t3, J…

Q: he problems below refer to the following sequence of instructions, and assume that it is executed on…

A: Answer: Here given some instruction and we have to identified given instruction what is happening so…

Q: The content of AR after the end of execution for the next instruction is 620 O 432 O 368 None of the…

A: check further steps for the answers :

Q: From above question, if a branch instruction is a conditional branch instruction, the branch need…

A: The average instruction execution time is

Q: Question 8: Show by drawing and compare between two pipelining cases that contain 4- stage pipeline…

A: Show by drawing and compare between two pipelining cases that contain 4-stage pipeline…

Q: Do you know what would happen if an instruction was rejected? When compared to a hardware-managed…

A: Page 30 contains the following information when an instruction is written to it: It tries to locate…

Q: Suppose the logic blocks used to implement the processor as discussed in class have the following…

A:

Q: Question 12 In MIPS programs, the operation in any R-type instruction is specified by the function…

A: The answer is

Q: When the CMP instruction sequence executes, the final value for AL sets or resets the Carry flag,…

A: Here is the answer with an explanation:-

Q: True/False Run times of the typical five stages to execute an instruction are as given in some…

A: Here in this question we have given five stage  Instruction Fetch: 10 Instruction Decode: 15…

Q: 4. We have the following data for a branching instruction, where T = branch is taken, and N = the…

A: Branch Prediction: Requires three things to be predicted at fetch stage- Whether the fetched…

Q: Write an instruction to sum of the values 9AH, 29H and F4H.Put the sum in registers R0 (low byte)…

A:

Q: Do you know what would happen if an instruction was rejected? TLBs controlled by software are…

A: Instructions that write to VA page 30The Translation Lookaside Buffer (TLB) table is searched for…

Q: How does the VA page 30 look if an instruction was rejected? A software-managed TLB would outperform…

A: Introduction: TLB is used to cache page table entries in memory, which is commonly done inside the…

Q: 2) If AX= +16, and BL= -3, what is the result after the execution of the following instruction: IDIV…

A: The answer is given below:-

Q: In each of the following MOV or MVN instruction, identify whether the use of the immediate value is…

A: Below is the answer of above question, Which is valid or which is invalid with commands. I hope this…

Q: Q3:(A)- Does the instruction sequence: ADC AX, BX SBB AX, BX Always leave AX unchanged? Explain your…

A: We need to verify if the given instructions, always leave AX unchanged.

Q: The hazard caused by BRANCH instruction in pipelined implementation is termed as: Select one: O a.…

A: The hazard caused by BRANCH instruction in pipelined implementation is termed as: Select one:   a.…

Q: The basic computer is to execute SZA instruction stored at address 30A. If the AC is equal to…

A:

Q: We wish to execute a single LC-3 instruction that will subtract the decimal number 33 from R1 and…

A: we need to write LC-3 instruction that will subtract the decimal number 33 from R1 and put the…

Q: Let us assume that processor testing is done by filling the PC, registers, and data and instruction…

A: PC: The PC stands for program counter; it is a register that store the address of current…

Q: 8. After the execution of instruction NEG AX, what will be the value of AX with initial value of…

A: Please refer to the following step for the complete solution of the problem above.

Q: 1) Using all the given DLX handouts, give a detailed list of all the relevant control signals and…

A: Given a) sub b) addi c) lhi (lhi follows the AL-U immediate instruction format) d) jal e) sh f) bnez…

Q: Describe the implementation of the TestandSet instruction. Show how the following algorithm using…

A: Testandset: In Synchronization hardware, we tend to explore many additional solutions to the…

Q: Given that variable w is a WORD and initialized with the hexadecimal value 82h and variable b is a…

A: 35 :   3412h 36:    11111000b

Q: a.  MOV AL, BL ​​where AL contains 0A1h and BL contains 25h b.  ADD AL, BL ​​where AL contains 8Fh…

A: Assembly level language is a low-level programming language, that's used to communicate directly…

Q: With the 2-bit predictor, what speedup would be achieved if we could convert half of the branch…

A: Number of stall cycles due to mis-predicted branches = 3 Accuracy of the predicted branches with 2…

Computer Fundamentals

The computer is termed computation. For calculating or computing something the device that has been used is known as the computer. Or we can say that for performing a fast arithmetic operation the device that has been used is a computer. Storing, processing, and retrieving are the main features of a computer.