Compute the resistance change of 100-ohms coils of Manganin and gold chrome for 50,000 lb/in² pressure and 100 'F temperature changes.

Q: Which of the following correctly expresses the magnitude of the transfer function for the series RC…

A:

Q: An IDMT over current relay has a current setting of 15% and has a time multiplier setting of 0.5.…

A: An IDMT over current relay- Current setting = 15% and Time multiplier setting = 0.5 The relay is…

Q: In digital communications: What is the dynamic range in dB of an 8-bit linear sign magnitude PCM…

A: Given Data:  A linear sign magnitude PCM spectrum with, Maximum decoded voltage Vmax=1.27 Vp…

Q: Given a single ended mode differential amplifier with a single ended mode output. Calculate the…

A:

Q: A source impedance vs(t) = Vcos100πt has an internal of (4+j3) N .If a purely resistive load to this…

A: Given - Source Voltage, vs(t)=Vcos100πt. Internal impedance, Zs=(4+j3) Ω.,   To find- Value of…

Q: Feedback control 3.Determine Automatic Voltage regualtion system of Vr  Vf  Vt ?

A: According to the question, for the given diagram as shown below We need to find the automatic…

Q: The finite-duration sequence x[n] = [-4, −1, 2, 0, 3] has a Fourier transform X(w). Determine X(0).…

A:

Q: 1.5 V 1Ω t=0 ANSWER: 12.885 kV. acc H 1 nF www 50 ΚΩ What is the maximum voltage magnitude present…

A: Solution: Given Data: V=1.5V L=(10/101)H C=1nF R(L)=50Kohm DETERMINE: Here find maximum Voltage…

Q: +130/300 SUD 3510 720 74 2266v حال What should be the value of IN and Rig of the Norton equivalent…

A:

Q: A continuous-time signal, x(t), has a Fourier transform denoted by X (w), and is expressed as: a)…

A: The above question is based on the concept of inverse Fourier transform. Please note that only part…

Q: Consider a filter with a constant term of 0.01, a zero at 2 rad/s, a pole at 10 rad/s, and a pole at…

A: it is asked to find the transfer function from given pole zero locations and constant term

Q: A star-connected load of 20 per phase is Fed from source through a 3-phase bridge inverter. For 180°…

A: Source voltage ,Vs = 450 ( V ) Resistance ,R = 20 ( ohm ) Power , P = ?

Q: The Fourier transform of a continuous-time signal x(t) is denoted by X(ω). Apply Continuous time…

A:

Q: A single period of the magnitude and phase spectra of a discrete-time signal is shown below. What is…

A: The above question is based on the definition of discrete-time Fourier series (DTFS).

Q: VIO R₁ 2₁ R₂ -Vcc 2₂ +Vcc +Vcc 23 R3 R₁ 24 RL VO Suppose Vcc=10V, the transistors are matched with…

A:

Q: Workspace From your observation of the measurement results in Table 5.0, was the operation of a…

A: The potentiometer placement in the bread board is The values of measurement of potentiometer are…

Q: 1. A 10 MVA, 3-phase alternator has an equivalent short-circuit reactance of 20 %. Calculate the…

A:

Q: A process to be controlled has output c(t) and is modeled by the following differential equation: 4…

A: A process that is to be controlled is defined by the following differential equation. 4dctdt+ct=5mt…

Q: Draw the diagram of the numerical integration errors as function of the step size and show the…

A: Here is a diagram showing the numerical integration errors as a function of the step size:

Q: A resistance temperature detector (RTD) is placed in a Wheatstone bridge as according to Figure 4.…

A:

Q: Given the range find the per scale value for each range based on the encircled basis (follow the…

A: Analog multi-meter screen is shown. We have to identify the values for each of the given rages for…

Q: The electric potential and electric field at any given position due to a point charge are 600 V and…

A: It is given that: V=600 VE=200 NC

Q: Find the Norton current for the circuit below at terminals a-b. Ο IN=1,404 <9,40 A IN=1,639 <10:30 Α…

A:

Q: A 240 rms 60 Hz source supplies a parallel combination of a 4.5-kW heater and a 27-kVA inductor…

A: In this question we need to find the kVA rating of the capacitor required to adjust the system power…

Q: Consider the following bode plot representing a filter with a constant term greater than 1, two…

A: The given problem is from control system bode magnitude plot.  The detailed solution is given in the…

Q: e. How Zi is affected by the second stage and RL. f. How Zo is affected by the first stage and Rs.…

A: Given data: The input impedance of emitter follower, Zi1=50 kΩ The output impedance of emitter…

Q: A) Describe whether the following statements are (True) or (False) 1- Air conditioner is an open…

A: 1- False. An air conditioner is a closed-loop control system, where the output (room temperature) is…

Q: For a periodic signal π v(t) = 30 sin 100t + 10 cos 300t + 6 sin 500t + 4 the fundamental frequency…

A: Given- Signal equation, vt=30 sin 100t+10 cos 300t+6 sin 500t+π4.   To find- The fundamental…

Q: Consider the finite-duration sequence x[n] = [−1, 0, 2, 0, −1], where the boldface number is the…

A:

Q: pour L

A: Solution (1)   Statement is false.

Q: Given the following control system block diagram: R(s) 9 s+1 1 K (a) Find the closed-loop…

A:

Q: Complete the simulation table for the 1-bit register until cycle 4 considering the following inputs:…

A: To complete the simulation table for the 1-bit register until cycle 4, we need to calculate the…

Q: 2+ R2 www 800 L1 80μH = 80 R1 www 400 C1 12.5nF --803

A: GIVEN DATA: An RLC circuit with, Supply voltage V=40 cos1,000,000 t V TO FIND: Frequency domain…

Q: Express (t) = 5 + 3 sin ( t + ) = O a. O b. 5 + (2ri OC 5 + c. 2 نے * 2) * + 5 3 12 3 2 j27 3 j2 2…

A: In this question we need to find the expression as a linear combination of complex exponentials.

Q: PART A Simplification using De Morgan's theorems 1. Draw a logic diagram for the equation : Y=ABB+C…

A: Since you have asked multiple questions, we will solve the first  question for you. If you want any…

Q: Determine the Thevenin equivalent with respect to the terminals a and b for the circuit attached.

A:

Q: Q1) Conduct an evaluation on the practical applications of the concepts of electromagnetism and…

A: Given: Discuss about the principles of electromagnetism used in the simulation.

Q: The frequency-division multiplexing system shown below combines two messages for transmission across…

A:

Q: Suppose Vcc=10V, the transistors are matched with Is=33fA and B=200, and the resistors have the…

A: The amplifier is given as here VCC=10V,β=200,R1=R2=5kΩ,R3=R4=2Ω,VBE=VEB=0.7V,VT=26mV. We need to…

Q: The Fourier transform of a continuous-time signal ä(t) is denoted by X(w). Apply CTFT properties to…

A:

Q: For the system shown in Figure 2, find the poles of the closed-loop transfer function, T'(s) =…

A: Given Data: A block diagram representation of a system with, Reference input =Rs Controlled output…

Q: the following bode plot. What is the corresponding transfer function? Magnitude (dB) Phase (deg) 0 0…

A:

Q: 3. Find an expression for I(s) in the circuit below using the Laplace transform. Assume the initial…

A: In this question we need to find the current I(s) for the given circuit . To find the current I(s)…

Q: In reference to the given figure, the current flowing through 2022 resistor is 3 A A 1A B 2A C 3A D…

A: circuit is given as:

Q: (c) If an amplifier provides a voltage gain of 105 when the input resistance is IMS2 and the load is…

A: For the given amplifier specifications the value of power gain needs to be calculated. If the load…

Q: Express x(t) = 5 + 3 sin (35+) as a linear combination of complex exponentials. O a.…

A: here we have to convert the given signal to the linear combination of complex exponentials.   we…

Q: (a) Find the maximum rolloff factor for a raised-cosine pulse suitable for on-off signaling at 1.00…

A: Rs = 1 Mbps N= 10 B.W  =(600+10 M)

Q: A lossless 37- transmission line is terminated in a load with Z1 = (63+j22) . Use the Smith chart to…

A:

Q: (a) Use the Standard Resistor Colour-Code Chart in Figure 1.0f to: (i) determine the numerical…

A:

Q: 1) The purpose of using Matrix in stereo system is: (a) to reduce the noise (b) to make stereo…

A: We need to select correct option for given statement from given options .

Photoconductive Cell

Photoconductive cells are light-sensitive resistors in which resistance is inversely proportionated to light intensity when illuminated. These devices consist of a thin single-crystal or polycrystalline film of composite semiconductor materials. Cadmium sulfide (CdS) is used to make the most commercially available photoconductive particles which are sensitive to light in the visible spectrum. Other less commonly used substances respond to infrared light, but not to the visible spectrum. Such substances are lead sulfide (PbS), lead selenide (PbSe), and lead telluride (PbTe), and so on.