Closed loop poles in a second order system -3 + 4j and -3-4j If so, what is the damping rate of the system?
Q: For the circuit given below, apply Loop/Mesh Analysis to obtain the complete set of loop equations.…
A:
Q: A circuit with a resistor and capacitor in series is subjected to a number of different input…
A: Here, we have given a circuit where a resistor and a capacitor are connected in series. Here, we…
Q: The circuit is at steady state when the switch closes at time t = 0. Determine v1(0−), v1(0+),…
A:
Q: Consider a circuit shown in the right figure where we have a battery of emf E, a capacitor of…
A: Capacitor will work as open circuit at final stage and work as short circuit at initial stage .
Q: 1. For the following funchron, g (6), onich aecet'sfjes the Divichlet's onditions,uning the…
A: G(w)=∫-∞∞g(t)e-jwtdt =∫-∞∞αe-βte-jwtdt =∫-∞0αe-β(-t)e-jwtdt +∫0∞αe-βte-jwtdt…
Q: Q4. The series RL circuit of Figure Q4 is subject to a unit step voltage input of height 5 volts at…
A: The laplace transform converts the time domain into frequency domain. The impedance for inductor is…
Q: In steady state, the two currents in the circuit are iL 2 mH A) ic = 0mA, i̟ = 2mA rell B) ic = 3mA,…
A: Given I =5 mA
Q: 6. The T.F approach is applicable to a) only lincar time-invariant systems b) linear time-invariant…
A:
Q: PROBLEM IO.27 For the circuit shown in Figure 10.128, sketch and label vR versus time. Assume that v…
A:
Q: What is the differential gain of the differnce stage of the instrumentation apmplifier? What is…
A:
Q: Write down the differential equations describing the loop currents of the given circuit. Assume…
A:
Q: 3. Determine the kind of damping and the value of q for the arrow refers to number #1 in the figure…
A: The above response is equivalent to mechanical response of spring mass system stretched from a…
Q: Using Kirchoff's Law determine the following current R1=40 R2=70 R3=70 V1=26volts V2=DB volts Type…
A: The circuit is The current in the circuit is shown.
Q: :The potential at point P due to 01 and Q2 is Q1 1x10-12C 0.5 m 0.5 m Q2 = 1x10-12C %3D %3D 50 cm P
A: The data is Q1=1×10-12 C, Q2=1×10-12 C. Calculate the distance between Q1 and point P :…
Q: Q1: For the circuits shown in figures. If the temperature has changed from 25°C to 65°C, find AIc.…
A:
Q: 14. Find f(t) of the following F(s) = 20s² + 141s +315 s(s² + 10s +21)
A: In this question we will find f (t) with the help of inverse laplace transform....
Q: Q2) The figure (b) represents the step response of a linear system. i) Find the order of the system.…
A: Step response of 2nd order system is given by:
Q: Q1: For the circuits shown in figures. If the temperature has changed from 25°C to 65°C, find Alc.…
A: Redraw the circuit: Here the collector current is IC=βIB+1+βIC0. Apply the Kirchhoff's voltage law…
Q: we added the shown Pl controler to reduce the steady-state.error of this system to become e 0.1 for…
A:
Q: Initial conditions for the circuit below: switch is open and capacitor is uncharged. Determine the…
A: GIVEN: R1=4ΩR2=4ΩR3=5ΩR4=3ΩV=10V FIND: initial and steady state current through…
Q: In the induction motor equivalent circuit, why R2\ is divided by s?
A: The stator circuit model of an induction engine comprises of a stator phase winding resistance R1,…
Q: (a) Describe the four errors and explain how you must fix them. You can mark up the diagram…
A: The answer to the above problem is provided below:-
Q: 1. Write the equation that sums the voltage drops around the closed loop according to Kirchoff's…
A: Write the loop equation for the given circuit ?
Q: A DC RL circuit has an inductor with a value of 1, with units given by A on the Student Values…
A: A DC RL circuit where inductor L= 1kH Resistance R= 1G ohm Find the time constant?
Q: Two carts with negligible rolling friction are connected as shown in Figure (1b). An input force tu…
A: In this question , we have to find out differential equation representing system and transfer…
Q: 067. The steady state error for the control system with 120(S + 2) G(s) %3D (s + 3)(S + 4) due to…
A:
Q: This system has an input of a unit step function or u(t). Find: a.) Output Equation c(t) (numerator…
A:
Q: H4. Find the number of left, right and jw-axis poles in these following characteristic equations: I.…
A: Based on Routh-hurwitz table we can say the number of poles on right side ,left side, jw axis of a…
Q: Closed loop poles in a second order system -5 + 12j and -5-12j what is the damping ratio of the…
A:
Q: Q3/ For the network shown in Figure (Q3), the switch has been in position "a" for a long tie. At…
A: Looking at the situation before t = 0, 9 kΩ and 15 kΩ are in parallel. Their equivalent…
Q: A cylindrical solenoid 49 cm long with a radius of 7 mm has 325 tightly-wound turns of wire…
A: Given:l=49cmr=7mmN=325a=3cmb=2cmR=135ΩN2=2
Q: *:The potential at point P due to Q1 and Q2 is Q, = 1x10-1²C 0.5 m 0.5 m Q2 = 1x10-12C %3D %3D %3D…
A: As we know the potential due to Q charge(VQ) at a distance r units can be calculated by following…
Q: Where can you find a ground in Multisim Live Online Circuit Simulator? а. Electromechanical b.…
A: In Multisim online circuit simulator, Schematic connectors block contains Ground, voltage source,…
Q: (i) Develop a model for spring and damper system shown in Figure 1.0 (ii) Derive the transfer…
A: In this question we will find transfer function...
Q: Consider the circuit in Figure 4. a) Find the Thevenin equivalent of the network connected to the…
A:
Q: For the control system in the given figure, the value of K for critical damping is * R(s) C(s) K…
A: First we will find transfer function C(s)R(s), we will compare with standard second order system for…
Q: For the circuit shown in Figure Vec=22V, Rc= 5. 6 Kr Vcc R8=330KS2, B= 80 Rc RB Yo= ∞52 %3D Vi…
A:
Q: If step response of a system is given as c(t) =Ae- + Be-A! where A and B are constants, then the…
A: The graph of above response will look like this :- This is the graph of an over-damped system. In…
Q: t=0 R1 vc(t) R3 V1 R2 V2 For the above circuit, the switch has been closed for a very long time and…
A:
Q: Consider the circuit shown in Figure Q4.1. The switch has been in position A for a long time before…
A: When switch is at position A for a long time , inductor acts like a short circuit .
Q: Question 3:Indicate the type of the following immittances (RL or RC or RLC or none of the above).…
A: Given
Q: +Vcc E3632A RB 34461A E E3631A 10k2 B VB8 2N3906 34461A RL V 1k2 Please show how to construct a…
A: For transistor, if we face the flat surface of transistor then, left side terminal is emitter(E),…
Q: Circuit Analysis , answer the questions below for the given circuit in the picture. Thanks.…
A:
Q: The circuit given is at steady-state when the switch closes at time t= 0. Determine v(t) for t≥ 0.…
A:
Q: H.W Find Time response for Yes)=. s' (s+3) 25+3
A: first we will split the given function by partial fraction and than we will apply inverse laplace…
Q: The switch in the circuit below closes at time t=0, and a long time passes such that steady-state…
A: Brief description : For the given second order system we need to calculate voltage across resistor…
Q: Shown in the figure below is an electrical circuit containing three resistors and two batteries. I,…
A: According to the question we have to calculate the loop equation, junction equation, and all values…
Q: Q1: For the circuits shown in figures. If the temperature has changed from 25°C to 65°C, find Alc.…
A: Given, Rf=250 kΩ Rc=1 kΩ Re=0.5 kΩ where, Rf is the base resistor,Rc is the collector resistor and…
Closed loop poles in a second order system
-3 + 4j and -3-4j
If so, what is the damping rate of the system?
3/4
4/3
5/4
5/3
3/5
one
4/5
0
Step by step
Solved in 2 steps with 2 images
- /Q6 The potential at point P due to Q1 and * :Q2 is = 1x10-12C 0.5 m 0.5 m Q2 = 1x10-12C %3D 50 cm P. 0.01797 V O -0.01271 V O ov O 0.01271 V C 10Find the resultant system of converging forces in the 500 N figure. Below 20ON 30ONA 22-k resistor and a 0.02-F capacitor are connected in series to a 5-V source. How long will it take the capacitor to charge to 3.4 V Select one: a. 0.501 ms b. 0.66 ms c. 0.44 ms d. 0.70 ms
- For R1=9000, R2=2000, R3=6000, R4=5000, C1=0.006, C2=D0.002 & 11=0.007 A in the shown circuit, obtain the energy stored in each capacitor under dc conditions. C2 R4 ŽR3 ER2 ŽRI C1= Energy stored in C1= Energy stored in C2=An inductor and a resistor are in series with a sinewave voltage source. The frequency is set so that the inductive reactance is equal to the resistance. If the frequency is increased, then options: Voltage across the inductor= Source Voltage Voltage across the inductor> Voltage across the resistor Voltage across the inductor= Voltage across the resistor Voltage across the resistor > Voltage across the inductorAn inductance coil consumes 500W of power at 10A and 110V and 60HZ. Determine the resistance and the inductance of the coil
- A load is composed of a 4 ohm resistance connected in series with a 3 ohm inductive resistance. The load is connected across a 120 source. Compute: (a) current (b) voltage across the resistance (c) voltage across the inductor Explain each step.1 Q2- Using convolution property to find time function of - 6+5jw-w?A capacitor of capacity C₁ is charged upto V volt and then connected in parallel to an uncharged capacitor of capacity C₂. The final potential difference across each will be (a) (c) C₂V G₁ + C₂ (1+2) GV G + C₂ (4) (1-²) v (b)
- how do i find the voltage of the capacitor? do i need to assume capacitor is charging so capacitor is open circuit and after that voltage on R2 is capacitor voltage after simplifying circuit?this is electric circuit questin ...plz solve it early .plz solve earlyAn alternating voltage is applied to a series circuit consisting of a resistor and iron-cored inductor and a capacitor. The current in the circuit is 0.5 A and the voltages measured are 30 V across the resistor, 48 V across the inductor, 60 V across the resistor and inductor and 90 V across the capacitor. Find (a) the combined copper and iron losses in the inductor (b) the applied voltage.