QI. s) Q1: A 1 m diameter well penetrates vertically through a confined aquifer (30 m) thick. When the well is pumped at (2712 m³/day), the drawdown in a well 15 m away from pumped well is 1.8 m; while the drawdown in another well 50 m away from pumped well is 0.5 m. Take the maximum head is 40 m. 1- Determine the transmissivity. 2- What is the approximate head in the first well? 3- What is the approximate head in the second well? 4- What is the approximate head in the pumped well for steady-state conditions? 5- What is the approximate drawdown in the pumped well?

QI. s) Q1: A 1 m diameter well penetrates vertically through a confined aquifer (30 m) thick. When the well is pumped at (2712 m³/day), the drawdown in a well 15 m away from pumped well is 1.8 m; while the drawdown in another well 50 m away from pumped well is 0.5 m. Take the maximum head is 40 m. 1- Determine the transmissivity. 2- What is the approximate head in the first well? 3- What is the approximate head in the second well? 4- What is the approximate head in the pumped well for steady-state conditions? 5- What is the approximate drawdown in the pumped well?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

I need right solution with clear calculations. If you don't know the solution please leave it but don't give me wrong solution. A 100 mm diameter well is drilled to withdraw water from a 11 m thick confined aquifer having coefficient of permeability equal to 64.8 m/d. The depth of water below the piezometric level is 30 m and it falls 2 m in the well while pumping. Calculate the discharge from the well when the radius of the circle of influence is 50 m.
(b) Calculate the discharge from a tubewell of 20-cm diameter penetrating fully into a confined aquifer of 20-m thick and having a permeability of 40 m/day. The drawdown in the well is 3 m and zero drawdown at 300 m from the well. If the diameter of the well is doubled, find the percentage increase in the yield, the other conditions remaining the same. State the assumptions in the formula you use. Ans: (1303.7 lpm)
QUESTION 11 1. The discharge from a fully penetrating well operating under steady state in a confined aquifer of 30 m thickness is 1500 liters/minutes. The drawdown observed at an observation well located at 20 m is 3 m. The transmissibility is 0.005 m²/s. Determine the location of the observation well with 0.5 m drawdown. Round off to two (2) decimal places, in m
A 2 ft diameter well penetrates vertically through a confined aquifer 50 ft thick. Whenthe well is pumped at 500 gpm in 1 day, the drawdown in a well 50 ft away is 10 ft andin another well 100 ft away is 3 ft. The storativity of aquifer is 0.0005. What is the valuefor transmissivity and drawdown? Note; the piezometric head is 100ft from datum.Combination of thiem & thies equation
Calculate the discharge from a tube well of 20-cm diameter penetrating fully into a confined aquifer of 20-m thick and having a permeability of 40 m/day. The drawdown in the well is 3 m and zero drawdown at 300 m from the well. If the diameter of the well is doubled, find the percentage increase in the yield, the other conditions remaining the same. State the assumptions in the formula you use. (1303.7 lpm)
A 30 cm diameter well completely 15 points penetrates a confined aquifer of permeability of 45 m/day. The thickness of the aquifer is 20 m. Under steady state of pumping the drawdown at the well found to be 3.0 m and the radius of influence was 300 m. Calculate the discharge of the well * Pumping well dia = 2r + Original piezometric surface Piezometric surface under pumping Aquiclude Flow Confined aquifer Aquiclude Well Operating in a Confined Aquifer 1.548 m^3/min 0.0258 m^3/min 0.258 m^3/min 0.0851 m^3/min
9) A well is located in a confined aquifer near the intersection of a constant head and impervious boundary. a) Estimate the steady state drawdown in the well for Q=2 ft³ s, rw = 1 ft, distance from the well to stream= 300ft and distance from well to impervious boundary= 150 ft. T = 0.14ft²/s b) Estimate the steady state drawdown at point P located midway between the well and the steam. The angle between the stream and the impervious boundary is 90°
A 2‐ft diameter well penetrates vertically through a confined aquifer 50 ft thick. When the well is pumped at 500 gpm, the drawdown in a well 50 ft away is 10 ft and in another well 100 ft away is 3 ft.(a) What is the approximate head in the pumped well for steady‐state conditions, and what is the approximate drawdown in the well?(b) Compute the transmissivity. Take the initial piezometric level as 100 ft above the datum.
Yuri wants to determine the permeability of an aquifer The aquifer has a test well 300-mm in diameter with two observation wells A pumping test was conducted for 24 hours with the discharge being held constant at 5,608.7 m^3/day. The first one, 86 59 meters from the test well, has a draw-down of 0.81 meters. The second one, 48 meters from the test well, has a draw-down of 1.13 meters. The static water table penetrates the well to a depth of 28 meters. Determine the radius of influence of the aquifer in meters Round off to three decimal places. Activate Windows A Moving to another question will save this response. Go to Settings to actiyate Windows Question 8 of 20 ASUS W R] 7T U K
A well is pumping at an unknown, steady rate in a confined aquifer. Near the pumping well are two observation wells; observation well A is located 8m from the pumping well and B is located 24m from the pump- ing well. The heads in these wells are hA = 134.20 and hB = 134.28 m. You know from prior pumping tests of the well that the well and the observation wells are screened in a confined aquifer with transmissivity T = 1200 m2/day. Assuming that without the well pumping there would be no hydraulic gradient at all, what is the pumping rate of the well?
Q-26: A 0.5 m diameter well fully penetrates an unconfined aquifer whose bottom is 150 m below the undisturbed groundwater table. The water is pumped out from the well at a constant rate of 0.1 m³/s. After equilibrium is reached, the drawdown observed in two observation wells at radial distances of 10 m and 50m are respectively 10 m and 5 m. Determine (i) The coefficient of permeability (in m/s) (ii) The drawdown in the well (in m)
TELEGRAM Q1: A 30cm diameter well penetrates vertically through an aquifer to an impermeable stratum located 18.0 m below the static water table. After a long period of pumping at a rate of 1.2 m3/min, the drawdown in test holes 11m and 35 m from the pumped well is found to be 3.05 and 1.62m respective. What is the hydraulic conductivity of the aquifer? Express in meters per day. What is its transmissivity? Express in cubic meters per day per meter. What is the drawdown in the pumped well?