Answered: capacitor is charged with 0.23 watt-sec…

Engineering

Electrical Engineering

capacitor is charged with 0.23 watt-sec of energy at a voltage of 48 volts. What is the capacitance?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter25: Surge, Spike, And Lightning Protection

Section: Chapter Questions

Problem 10RQ: In reference to the load, how are capacitors connected to help prevent voltage spikes and surges?...

See similar textbooks

Related questions

Q: Find the Nyquist rate for the signal: x(t) = 4 sin(10лt) + 3 cos(67лt). Select one: O a. 77 O b. 134…

Q: Find the voltage gain Vo/V₁ of the Op-Amp

A: Operational amplifier- An integrated circuit which amplifies weak electric signals into a strong…

Q: Using Superposition Theorem, what is the effect of a 10440" current source in calculating the…

Q: If the load of wye connected transformer are: IA = 10 cis(-30ᴼ) IB = 12 cis (215ᴼ) IC = 15 cis…

Q: using The Venin's Theorem, find resistor in figure. The current in [6] below ил, 55 MA 4.5 65

A: We need to find out current for given circuit by using of thevenin equivalent circuit

Q: What is the value off an N type JFET with Idss=6 mA and Vp=-4 when Vgs=-2.2V. Give the exact value…

Q: Solve for ro- I₁ Z₁ 2 Mohms 50 kohms O 40 kohms 100 kohms www 330 ΚΩ Vcc To 2.7kQ2 HA hfe = 120 hje…

Q: Help me answer pls. I need it in 3mins. Using Superposition Theorem, what is the effect of a 120∠0°…

Q: A coil having a resistance of 25 Ω and an inductance of 150 mH is connected in series with a 80…

Q: Symmetrical Components 4) Given Va= 10243°, Ub= 142-134°, Vc = 12/110°. a) find Vo,U₁ and V₂.

Q: Find / Derive the equation for the capacitance of a spherical capacitor, consisting a spherical…

Q: For the circuit of Figure 1.2(a), Vs = 10 V and R = 2 kn... Si 艹 lo + Vo R VR Figure 1.2(a) a)…

A: In the above given circuit, a voltage source is connected to the silicon diode and the resistor in…

Q: In Figure 2.2 is shown the fixed bias circuit of a Silicon transistor with B = 180. Determine the…

A: We need to find out unknown resistance value for given circuit

Q: Q: Draw output voltage waveform for this circuit if ß-50. +10v +5v -1v Vi 2 3 4 t(ms) Vi AC 50k +10v…

A: Brief description: The common emitter current gain of the amplifier is 50. For the given common…

Q: A10 microfarad capacitor has 250 milliamperes of current flowing through it. How much voltage at 60…

Q: 10 V A -10 V ΙΚΩ Si 10k2%

A: To Determine and sketch the output voltage waveform and the current flowing in the resistor for the…

Q: 3. I Wagon | TON WW SOOR CRO 14 11-00-1 CR 10.0-2 CRE 00-0 CR4)

Q: In a common emitter bjt amplifier circuit, what parameter is described by Bre. Choices: Diode…

A: In this question we will write about bjt hybrid model....

Q: Derive and plot the magnitude and phase responses of the first order difference system, y[n] =…

Q: figure the S-parameters for an ideal transformer with turn ratio N = N1:N2 where N1 is the no. of…

A: S- parameters is a scattering parameter it describe the linear behaviour of electrical network .…

Q: If w = 500 rad/s and I = 2.5 angle 40, find vs(t) ww 10 Ω 1,(1) + 25/-30° V • 25 Ω Μ | 20 mH

Q: Referring to this figure, calculate Zo if yos = 40 μS. o 20 V Va να N Z₁ 5 3.20 ΚΩ 3.25 ΚΩ 3.75 ΚΩ…

Q: A metallic wire is stretched from original length of 2 m to 4 m. If the original cross-sectional…

Q: Please explain this equation for nodal analysis. Why did Vs1 and Vs2 became negative? Why did Vs3…

A: In this question we will solve nodal equation.... We know that current always flow from positive…

Q: From the circuit below, what is the value of the mesh current C when the direction of all the mesh…

Q: V 14 R

Q: 1. Two toroidal solenoids are wound around the same form so that the magnetic field of one passes…

A: In this question we will find mutual inductance and average flux through each turn of solenoid...

Q: Q5: find the Fourier series of the following equation - 1<x<0 f(x) = { x 0<x< 1 1<x<3 1

Q: Q: Draw output voltage waveform for this circuit if B=50. Vi +5v H -1v +10v 2 3 4 t(ms) Vi 50k +10v…

A: We need to find out the output voltage for given circuit

Q: 3. Parallel and Series-Parallel a) Determine Vo and lp for the network of Figure 45.0. 20 V

Q: Answer (IV), (vii) and (VIII)

A: Given: An eight-pole, three-phase 3300 V, 50 Hz, 500 kW induction motor, the test results were…

Q: PROBLEM 1 In the region of free space that includes the volume 2<x, y, z <3, D = 2z (yz ax + x² ây -…

Q: Two 60 cycle currents having maximum values of 20 and 30 A differ in phase by an angle of 75…

A: Two 60 cycle currents having maximum values of 20 and 30 A differ in phase by an angle of 75…

Q: Find the Nyquist rate for the signal: x(t) = 4 sin(10лt) + 3 cos(67лt). Select one: O a. 77 O b. 134…

A: Given data, Signal, xt=4sin10πt+3cos67πt

Q: A 60 cycle alternating current with a maximum value of 10 amperes has an instantaneous value of…

Q: 3. Given the circuit below, find the values of the following: a. Ic Vcc b. Rc C. Ic 2.2 ΚΩ w la= 20…

A: We need to find out unknown resistance value for given circuit

Q: An analog-to-digital (A/D) converter has a 15-bit binary input. The input analog voltage range is 0…

Q: Implement the given notation using multiplexer: H (K,J,P,O) = ∑ (0,2,3,5,9,10, 11,12,13,14)…

Q: Find the total number of watts (P), VARS (Q), VA (S), PF, and the current I. Draw the power…

Q: this circuit is common grounded RBIAS2 360ΚΩ Rc 3ΚΩ a. Vce b. draw the BJT AC equivalent circuit c.…

A: Brief description: For the given common emitter amplifier circuit we need to calculate the value of…

Q: For the circuit of Figure 1.2(a), Vs = 10 V and R = 2 kn.. Si lo + VD- Vs Figure 1.2(a) a) Determine…

Q: Design a 3-bit priority encoder. D0 is the highest priority. Include truth table and equation.

A: The truth table for the 3 bit priorty encoder is shown below: D2 D1 D0 Y1 Y0 0 0 0 x x x x 1…

Q: 18. A current of 16 amperes divides between two branches in parallel of resistances 8 ohms and 12…

Q: A given transistor has the following values: hFE = 200, hfe 120, hie= 5 ks2, hre = 40, = and hoe =…

Q: 1. Use nodal analysis and find the voltages across z1, z2, z3 and z4. Use node A as your reference…

Q: Develop a two-component matching network for a ZL = (40 + j10) ohms , load and a 50 ohms, source.…

A: Solution

Q: Q: Draw output voltage waveform for this circuit if ß-50. +10v +5v -1v Vi 2 4 t(ms) 50k www +10v 10k…

A: Brief description: A common emitter amplifier is a wisely used amplifier because it provides…

Q: A 100- resistor, an uncharged 100-µF capacitor and a switch are connected in series across a 24-V…

Q: Determine the values of i3, V4, i5, and in the circuit shown below. + U1 - Μ b D ( C 6Ω Μ 18 V 8 Ω Μ…

A: To solve this problem I am using current division rule I1= I*(R2) /(R1+R2)

Q: The complement, F', of F(x, y, z) = x'{y'z) + (x'yz' + xz + xyz)' (not simplified) is: Ox+y+zxyz +…

Concept explainers

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.

Question

A capacitor is charged with 0.23 watt-sec of energy at a voltage of 48 volts. What is the capacitance?

show solution

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
4. In what form is the energy of a capacitor stored?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
In reference to the load, how are capacitors connected to help prevent voltage spikes and surges? Are capacitors connected in parallel or in series with the load?
You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor to a 480-V, 60-Hz line. To determine the proper conductor and fuse size for this installation, you need to know the amount of current the inductor will draw from the line. The nameplate on the inductor indicates that it has an inductance of 0.1 H. An ohmmeter reveals that it has a wire resistance of 10 . How much current should this inductor draw when connected to the line?
Can current flow through a capacitor?
A pure capacitive circuit is connected to a 480-volt, 60-Hz power source. An ammeter indicates a current flow of 24 amperes. The circuit current must be reduced to 16 amperes by connecting a second capacitor in series with the first. What is the value of the existing capacitor? What value capacitor should be connected in series with the original capacitor to limit the circuit current to 16 amperes?