(c) A solar farm contains 300 modules each with an active area of 1 m² and generates 30 kW of power. If the modules have an open circuit voltage of 900 mV, a fill factor of 70% and the short circuit current density of 28 mAcm², determine the utilization factor of the farm. You may assume standard illumination conditions.

(c) A solar farm contains 300 modules each with an active area of 1 m² and generates 30 kW of power. If the modules have an open circuit voltage of 900 mV, a fill factor of 70% and the short circuit current density of 28 mAcm², determine the utilization factor of the farm. You may assume standard illumination conditions.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter30: Dc Motors

Section: Chapter Questions

Problem 6RQ: What is CEMF?

See similar textbooks

Similar questions

Three condensers of 6, 10, and 15 micro-farads are connected in series across a 200V supply. If the condensers are disconnected, how much energy can the charged condensers provide if connected across each other with like polarities together? Ans. 0.052 J
Which change to the circuit will not extend the charging time of one time constant.a. Increasing the value of the capacitorb. Increasing the value of the resistorc. Increasing the voltage from 15 to 20 volts
The type of output voltage from a Solar PV module is a. DC b. AC
Consider a PV Module with 24 solar PV cells with the Size of each 15cm x 10cm are connected in series. Choose the correct statement for the above PV Module. (Assume necessary data) a. The output power is 2.25W and the output current is 0.09A b. The output power is 540W and the output current is 45A c. The output power is 54W and the output current is 2.25A d. The output power is 54W and the output current is 4.5A
Example 18: A photovoltaic cell is to be used with radiation of intensity from 5 to 12 mW/cm². Measurements show that its unloaded output voltage ranges from 0.22 to 0.41 V over this intensity while it delivers current from 0.5 to 1.7 mA into a 100 52 load. Find the range of short circuit current.
Thermal question. A system has two thermal layers. The first layer has a Rth 0.5 K/W, and Cth 0.8 J/K, and the second layer has a Rth 0.2 K/W, and Cth 0.4 J/K. The ambient air temperature is 50 °C. The power dissipation in the system is 100 W. What is the temperature of the second layer 5 s after a system is switched off? Please do not include any units in your answer.
How output current is represented in an equivalent circuit of photovoltaic module? O a. IDH O b. I O c. Isi O d. Ic
Give advantages and limitations of solar PV systems
determint the short circuit current (Isc) foa a photovoltaic cell having a fill factor of 68.5 percent. solar cell efficiency as 9.6 percent, solar input irradiance as 100mW/cm2 with an open circuit voltage of 0.74v.
Below is the table of PV specifications of a standard commercial silicon PV. a) Calculate the efficiency of this PV module. b) Calculate the fill factor of this PV module. c) Estimate the number of solar cells included in this PV module. d) Draw a sketch explaining how the solar cells are connected in the PV module.
(b) A single-phase full converter charges a battery which offers a constant value of E. A resistor R is inserted to limit the battery charging current. Derive an expression for the average charging current. Find the value of R in case of battery charging current is 6 A, supply voltage is 40 V, 50 Hz, E=12 V and voltage drop in conducting SCR is 1 V determine: (i) Power dissipated in R (ii) Supply power factor
Draw VI characteristics of solar PV cell.