PROBLEM-SOLVING: Given the following situations below, read thoroughly the problem and identify what is asked. Provide your answers and solutionseither through photos of your calculations or by typing on the provided field with the final answer highlighted.An electrical wire is rated up to 8A when it was used to pass 300c of charge for 12s. W the rated current of the electrical wire be enough to theactual electrical demand? What do you think will happen to the wire? Provide a short statement and support it with computations.

Answered: Image /qna-images/answer/6f2b2d75-2b86-4bc4-8735-2c257746d97f.jpg

An electrical wire is rated up to 8A when it was used to pass 300c of charge for 12s. Wil the rated curront of the electrical wire be enough to the actual electrical domand? What do you think will happon to the wire? Provide a short statement and support it with computations.

An electrical wire is rated up to 8A when it was used to pass 300c of charge for 12s. Wil the rated curront of the electrical wire be enough to the actual electrical domand? What do you think will happon to the wire? Provide a short statement and support it with computations.

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter1: Units And Measurement

Section: Chapter Questions

Problem 15P: Use the orders of magnitude you found in the previous problem to answer the following questions to...

See similar textbooks

Similar questions

Directions: Solve the given problems. Show your complete solutions.Round off your answers into the proper number of significant figures.1. A silver wire 2.5 mm in diameter transfers a charge of 370 C in 70 minutes.Silver is made up of 5.8 x 1028 free electrons per cubic meter.a. Find the current in the wire.b. What is the magnitude of the drift velocity of the electrons in the wire?
Capacitance, Charge and Voltage: Q = CV 1. Click the Reset Button on the bottom right of the PHET simulation. 2. CHECK Plate Charges and Bar Graphs boxes in the upper right so your display resembles the graph below. 3. SET the Plate Area to 200 mm² and the Separation to 4.0 mm. Capactance Tup Pate Charge oc Sured Energy Pu Charges r Graphs O e Fd Cument Direction 1500 V 4. Connect the voltmeter across the capacitor by placing the red on the top plate and black on bottom. If the voltmeter reads a negative, switch the red and black. 5. Set the battery Voltage to 0.25 V. Record the measured plate charge, Q. 6. Repeat Step 5 for each Voltage in Table 3. Table 3: Charge and Voltage Voltage |(V) Plate Charge |(pC) 0.25 V 0.50 V 0.75 V 1.00 V 1.25 V 1.50 V
Directions: Solve for the given problems. Round off all your final answers inthe proper number of significant figures.Find all the individual currents and individual voltages in Figure 2
Please fill out the template with the work for this problem. Note that you need to have a picture, a list of knowns and unknowns, the general equation/s you will use, and the math steps to solve for the unknown, Only plug in the numbers after you have solved for the unknown, and the answer with units included. Problem 1: A negative charge of q = -8.3 × 10-17C and m = 1.2 × 10-26 kg enters a magnetic field B = 1.3 T with initial velocity v = 410 m/s, as shown in the figure. The magnetic field points into the screen. Calculate the magnitude of the magnetic force F on the charge, in newtons.
Check your understanding A. Solve the problems below. You are required to show the proper solution with the final answer written inside a box. Make sure to put the final unit of measurement. 1. If in the process of rubbing the lenses of the eyeglasses, 6.28 x 10 10 electrons were transferred, a. what is the charge of the lenses and the nylon cloth? b. what is the change in their masses? CS Scanned with CamScanner
Please be detailed with the solution, step by step and I aslo attached the formulas that be needed to solve the problem. Thank you.
Analyze the given problem. Show your complete and detailed solution.
Please fill out the template with the work for this homework problem. Note that you need to have a picture, a list of knowns and unknowns, the general equation/s you will use, and the math steps to solve for the unknown, only plug in the numbers after you have solved for the unknown, and the answer with units included. Problem 1: The voltage across a membrane forming a cell wall is 80.0 mV and the membrane is 9.00 nm thick. What is the magnitude of the electric field strength, in volts per meter, assuming a uniform electric field? (The value is surprisingly large but correct.)
The picture is the complete solution guidee. Pls make it like that DIRECTIONS: Solve completely what is given and required by converting the units based on the DENSITY units. EXPRESSED ALL ANSWER TO SCIENTIFIC NOTATION to THREE SIGNIFICANT FIGURES for all the final answer and enclosed with a box each converted units and affix the required units. SET C : A 7.5 oz of spherical pebbles has a radius of 1.75mm. Calculate the density in g/L and its specific gravity? V= 4/3 πr ³
Compute for the following. Round your answers into to 2 significant figures. 1. What is the charge of an object that has 3,000,000 excess electrons? 2. What is the charge of an object that has 5,000,000 electron deficits? 3. How many excess electrons are there in an object with a charge if -3.6 ×10^-17 C?
Solve the following problems below. Show complete solution.
The picture is the complete solution guidee. Pls make it like that DIRECTIONS: Solve completely what is given and required by converting the units based on the DENSITY units. EXPRESSED ALL ANSWER TO SCIENTIFIC NOTATION to THREE SIGNIFICANT FIGURES for all the final answer and enclosed with a box each converted units and affix the required units. SET B : A 4.5 TONS OF RECTANGULAR BLOCK OF ICE HAS THE FOLLOWING DIMENSIONS: 6.5 ft in length; 3.25 in width ; 1.125 in height. Calculate the density in Kg/ m ³ and its specific gravity? V=Lx W x H