A six lane urban freeway (three lanes in each direction) is on rolling terrain with 11 ft. lanes, obstruction 2 ft. from the right edge of the travel pavement, and 1.5 interchange per mile. The traffic stream consists of commuters. A directional weekday peak-hour volume of 2,200 vehicles is observed, with 700 vehicles arriving in the most congested 15 minute period. If the traffic stream has 15% large trucks and buses and no recreational vehicles, determine the level of service.

Eight lane urban freeway is on level terrain with lane width of 12 ft, right shoulder lateral clearance of 4 ft, and 12 ramps over the 6-mi analysis segment. The traffic stream consists of unfamiliar road users. Peak hour volume for a directional weekday of 3200 vehicles is observed with 900 vehicles arriving in the most congested 15-min period. If the traffic stream has 20% large trucks and 20% buses and 15% recreational vehicles, determine the exact demand flow rate (in pc/h/In). Round your answer to 3 decimal places. Exclude the unit in the answer box.

Problem 2. Consider a freeway section with three lanes in each direction and with a length of 1.25mi (2km) and a +5% grade. In this freeway, the directional peak-hour volume is 3,800 veh/h, from which 76 are trucks and 152 are transit buses. The maximum 15-min volume within the hour of analysis is 1,055 vehicles. The lane widths are 12 ft (3.6m), and shoulder widths are 10 ft (3.1m). There are 2 exit ramps and 1 entrance ramp in the 3 miles in the upstream section and 1 exit ramp and 2 entrance ramp in the 3 miles in the downstream section (consider the same ramp density if using international (km) units). All transit buses will be removed from traffic since the transit service will be replaced by a commuter rail service. However, by removing buses, new additional passage car demand is expected. It is estimated that for each removed bus, 7 new passenger cars will be added to the original traffic volume of 3,800 veh/h. Question: Determine the change in speed and traffic density before…

A six-Lane urban freeway (three lanes in each direction) is on rolling terrain with 11 feet lanes, obstructions to 2 feet from the right edge of the travel pavement, and eight ramps within three miles upstream and three miles downstream of the mid point of the analysis segment. The traffic stream consist primarily of commuters. A directional weekly peak our volume of 2300 vehicles is observed, with 700 vehicles arriving in the most congested 15-min period. If the traffic stream has 15% large trucks and buses and no recreational vehicles, determine the level of service

6.3 A four-lane freeway (two lanes in each direction) is located on rolling terrain and has 12-ft lanes, no lateral obstructions within 6 ft of the pavement edges, and there are 2 ramps within 3 miles upstream of the segment midpoint and 3 ramps within 3 miles downstream of the segment midpoint. A weekday directional peak-hour volume of 1800 vehicles (familiar users) is observed, with 700 arriving in the most congested 15-min period. If a level of service no worse than C is desired, determine the maximum number of heavy vehicles that can be present in the peak-hour traffic stream.

A six-lane freeway (three lanes in each direction in mountainous terrain has 10-ft lanes and obstructions 1ft from the right edge. There are five ramps within three miles upstream of the segment midpoint and four ramps within three miles downstream of the segment midpoint. The traffic stream consists of mostly commuter with a peak hour factor of 0.84, peak-hour volume of 2500 vehicles, and 4% recreational vehicles. What is the level of service?

6.3 A four-lane freeway (two lanes in each direction) is located on rolling terrain and has 12-ft lanes, no lateral obstructions within 6 ft of the pavement edges, and there are 2 ramps within 3 miles upstream of the segment midpoint and 3 ramps within 3 miles downstream of the segment midpoint. A weekday directional peak-hour volume of 1800 vehicles (familiar users) is observed, with 700 arriving in the most congested 15-min period. If a level of service no worse than C is desired, determine the maximum number of heavy vehicles that can be present in the peak-hour traffic stream. (Ans 322)

Eight lane urban freeway is on level terrain with lane width of 12 ft, right shoulder lateral clearance of 4 ft, and 12 ramps over the 6-mi analysis segment. The traffic stream consists of unfamiliar road users. Peak hour volume for a directional weekday of 3200 vehicles is observed with 900 vehicles arriving in the most congested 15-min period. If the traffic stream has 20% large trucks and 20% buses and 15% recreational vehicles, determine the density in pc/mi/In. Round your answer to 3 decimal places. Exclude the unit in the answer box.

A six-lane urban freeway (three lanes in each direction) is on rolling terrain with 11-ft lanes, obstructions 2 ft from the right edge of the traveled pavement, and nine ramps within three miles upstream and three miles downstream of the midpoint of the analysis segment. The traffic stream consists primarily of commuters. A directional weekday peak-hour volume of 2300 vehicles is observed, with 700 vehicles arriving in the most congested 15-min period. If the traffic stream has 15% large trucks and buses and no recreational vehicles and at some point, further along the roadway there is a 6% upgrade that is 1.5 mi long.  (assuming that the proportion of vehicle types and the peak-hour factor remain constant) Determine the FFS value in mi/hDetermine the PHF or Peak Hour FactorDetermine the fHVDetermine the value of vp

A new section of a freeway is to be designed with a free-flow-speed of 65 mph along of 0.75 mile on 5% upgrade. The expected traffic volume is 4200 v/hr. The traffic composition is 15% trucks, 5% recreational vehicles, and 10% buses. The peak hourly factor is 0.9, the unfamiliar driver factor is 0.95. If the design requirement is to target a level of service (B), how many lanes must be provided to satisfy the design requirement?