A resistance R, capacitance C, and inductance L are connected in series to a voltage source with amplitude V and variable angular frequency v. If w = w0 , the resonance angular frequency, find (a) the maximum current in the resistor; (b) the maximum voltage across the capacitor; (c) the maximum voltage across the inductor; (d) the maximum energy stored in the capacitor; (e) the maximum energy stored in the inductor. Give your answers in terms of R, C, L, and V.

A resistance R, capacitance C, and inductance L are connected in series to a voltage source with amplitude V and variable angular frequency v. If w = w0 , the resonance angular frequency, find (a) the maximum current in the resistor; (b) the maximum voltage across the capacitor; (c) the maximum voltage across the inductor; (d) the maximum energy stored in the capacitor; (e) the maximum energy stored in the inductor. Give your answers in terms of R, C, L, and V.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter16: Inductance In Ac Circuits

Section: Chapter Questions

Problem 2PP: What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?

See similar textbooks

Similar questions

List the five capacitor replacement rules.
What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?
Solve for the current going through each passive component and the voltage at the capacitor.
A multi-plate capacitor is made up of 501 sheets of aluminum 20 cm x 30 cm with an insulation of paraffin paper 0.0015 cm thick. What is the capacitance in microfarads of the capacitor? (k for paraffin paper is 3) a. 50 b. 55 c. 35 d. 67
.A series RLC circuit contains a 4-kN resistor, an inductor with an inductive reactance (X,) of 3.5 kn, and a capacitor with a capacitive reactance (Xc) of 2.4 kN. A 120-Vac, 60-Hz power source is connected to the circuit. How much voltage is dropped across the inductor?
A 10.0-μF capacitor and a 2.00-H inductor are connected in series with a 60.0-Hz source whose rms output is 100 V. Finda. the rms current in the circuit.b. the voltage drop across the inductor. c. the voltage drop across the capacitor.
In the compuntation of experimental time constant of an RC circuit in the charging phase, explain the reason why we should not directly plot the capacitor voltage as a function of time in solving?
Consider the sinusoidal voltage and current for an inductor. If you are given the phase angle of the voltage, the phase angle of the current will be:a) The same as the voltage phase angleb) 90°more than the voltage phase anglec) 90° less than the voltage phase angled) Dependent on the inductance
R 1. Measure the internal resistance of the 1mH inductor. Set up the given circuit with R = 270n and L = 1mH. Apply a sinusoidal voltage as input. Adjust V, = 4Vpp and set the frequency as 20kHz. Observe the input voltage and the V, L voltage across the inductor simultaneously using an ocilloscope and plot both signals. Find the phase difference between these signals and comment on the results.
Find: the maximum charged value of the capacitor during the negative half cycle. the Vout during the negative half cycle. the Vout during the positive half cycle.
What impedance vector (0- j15) Ohms represents:A. A pure resistance. C. A pure capacitance.B. A pure inductance. D. An inductance combined with a capacitance.
6-9) A capacitor, an inductor and a resistor all walk into a bar. No, wait. A capacitor, and inductor, and a resistor are connected in series with a sinusoidal AC emf. At what frequency ω will the maximum voltage drop across the capacitor itself be maximized (VC MAX)MAX? This is a tedious one.