Answered: A method of analysis yields masses of…

A method of analysis yields masses of gold that are lower by 0.40 mg. Calculate the percent relative error caused by this result if the mass of gold in the sample is (a) 500mg (b) 70 mg

Introductory Chemistry: An Active Learning Approach

6th Edition

ISBN:9781305079250

Author:Mark S. Cracolice, Ed Peters

Publisher:Mark S. Cracolice, Ed Peters

Chapter12: Chemical Bonding

Section: Chapter Questions

Problem 37E

See similar textbooks

Related questions

Q: A piece of metal was weighed on a laboratory balance four times and gave the following results:…

Q: Express the results of the following calculation in scientific notation 0.0121 cm to the power of 2…

A: Scientific notation is a method of writing a very large and small numbers.

Q: It is estimated that uranium is relatively common in earth's curst, occuring in amounts of 4g/metric…

A: Given that mass of uranium present in earth’s crust = 4g/ metric ton Sample of earth crust taken =…

Q: Given that Xenon has a density of 5.37 g/L, calculate the mass, in grams, of xenon with a volume of…

Q: 15. In preparing a certain ointment, a pharmacist used 28.35 grams of zinc oxide instead of the 31.1…

A: Given, mass of zinc oxide (used) = 28.35 g mass of zinc oxide (required) = 31.1 g

Q: (i) The maximum error in each mass measurement using the balance is ±0.005 g. Calculate the…

A: Cr=19.5152=0.375Cl=39.9635.5=1.126H=4.511=4.51O=36.0216=2.25Whole No. ratios,Cr=1Cl=3H=12O=6So the…

Q: What is the percent error? And how do I find it with the information provided.

A: Percent error or percentage error expresses as a percentage the difference between an approximate or…

Q: You are a high school chemistry teacher. Describe to your students the purpose of calculating a Q…

A: Interpretation - To describe your students the purpose of Q value and demonstrate an example -…

Q: Please help me this question! Thank you! "What is the measuring range and accuracy (i.e. how many…

A: Micropipettes are precision instruments that are designed to transfer volumes in the microliter…

Q: Errors that are independent of the size of the sample being analyzed. * the sample

A: The relationship between the standard error of the mean and the standard deviation is such that, for…

Q: You are working in a hospital and you saw that a patient took 500 mg of ibuprofen but the chart…

A: Mean, Standard deviation and %RSD (percentage relative standard deviation) are the ways to check the…

Q: What is the mass of 0.207 moles of C3H9O4? Note: Express your answer in proper significant figures.…

A: Given, moles of C8H9O4 = 0.207 mol mass of 0.207 moles of C8H9O4 = ? Note: molar mass of C8H9O4 =…

Q: Suggest two sources of systematic error and two sources of random error in measuring the width of a…

A: Error in a measurement is observed when the true measurement value differs from the measured value.…

Q: Express the molecular mass and its standard uncertainty of C17H21NO4 with the correct number of…

A: Answer:- Molecular mass = 17 × mass of carbon atom + 21 × mass of hydrogen + 1 × mass of nitrogen +…

Q: Which of the following sentence is correct: O Gross errors cause outliers O Bias measures the random…

A: We have to choose correct statement , out of these 5 given statements.

Q: Explain the difference between random error and systematic error.

A: A mistaken result or false result obtained in an experiment or study is termed as error. Error is…

Q: 1. Define tensile strength? 2. Why is it important to test the tensile strength of materials? 3. The…

A: 1. Usually when a material comes under stress or strain it tends to break.So the ammount of load or…

Q: What is the uncertainty in a measurement of 0.39 mm?

Q: calculate its theoretical density in g/cm3. NA put the units

Q: The variance of chemical experiment .data is square of standard deviation

A: The standard deviation and variance are used to measure the scattering of data from the mean value.…

Q: Complete the table and answer the question that follows. a. Calculate the average mass of the…

A: In the experimental data we have to calculate the average mass of unknown gas, density and Standard…

Q: Does standard deviation give a measure of precision or accuracy?

A: Interpretation - Does standard deviation give a mesure of precision or accuracy - Introduction…

Q: How are systematic method errors detected?

A: Systematic method error is a kind of systematic error. It will have a different calculated mean…

Q: 3) For the results, discuss the significance of the following in terms of accuracy or precision: a)…

Q: The accepted density of Manning is 18.00g/mL. Your lab team measures the density of Manning to be…

Q: While doing a lab, a student found the density of a g/cm. The accepted value for the density of…

A: According to the question, Measured density of pure aluminum = 2.85g/cm3 Accepted value for the…

Q: How are systematic errors detected?

A: Systematic method error is a kind of systematic error. It will have a different calculated mean…

Q: Which of the following is incorrect: a. General steps in quantitative analysis include: Method…

A: Chemical analysis are of two types : 1. Quantitative analysis 2. Qualitative analysis

Q: The three targets from a rifle range shown below were producedby: (A) the instructor firing a newly…

A: The following comments can be made on the accuracy and precision for each of the three sets of…

Q: Given: Density @23°C = 0.99755 g / mL Total volume Mass of Mass flask Mass of True volume Correction…

A: The data given is,

Q: How many milligrams are in 0.250 mmole CHC16H17N2HNS2

A: Given, No of moles of CHC16H17N2HNS2 = 0.250 mmole =0.250 x 10-3 moles (Note: mmoles can be…

Q: 4-The density of water at 4°Cs known to be 1.00 g/ml kim experimentally found the density of water…

A: Given the density of water at 4 degree centigrade is 1.00g/ml. Experimental density of water is…

Q: Which statement is associated with random error?

A: Measured value is the value of a measurement obtained through an instrument or a device. The…

Q: zo determined the density of a sample of aluminum. For his sample, he found the volume was 0.350…

A: To calculate the percentage error in calculation.

Q: Which of the following sentence is correct: O Random errors cause outliers O Random error affects…

A: Errors are the deviation from the correct value. Errors can be of different types, like random…

Q: Calculate the percent error when a known value of 5.69 is measured to be 5.85

A: Given,Measured value = 5.85Exact or known value = 5.69Percent error can be calculated as:

Q: You are given the following data set: 50.3 52.8 60.3 55.4 48.3 35.4 57.6 Please choose the best…

A: As per our community guidelines we can only answer 3 sub-parts of a question, out of all the…

Q: What does it mean when the experimental value is larger than the accepted value? What could be some…

A: Errors are differences between observed values and what is true in nature. Error causes results that…

Q: A method of analysis yields masses of gold that are low by 0.4 mg. Calculate the percent relative…

A: Percent relative error is calculated as follows; Er=xf-xixi×100% Here xi is the actual mass of the…

Q: Which information does the pre-exponential factor contain?

Q: The density of a metal is calculated to 8.9377 g/cm3, using weight and volume measurements. The +…

Q: A student calibrated a eudiometer by first recording the mass of the empty eudiometer followed by…

A: The density of water at 220C is 0.9978 g/mL

Q: I measured a line that was 8.4 centimeters which is the same as 3.375 inches. How do I calculate the…

A: The relative percentage error is equivalent to the algebraic ratio between the difference measured…

Q: A loss of 0.4 mL of Zinc occurs in the course of an analysis to determine that element. Calculate…

A: Given that in an experiment involving Zn there is a loss of 0.4 mg of Zn. We need to calculate the…

Q: The area of an object is calculated from experimental data to be 24.6623 cm2. The t absolute error…

Q: Give two examples of the Method error (one of the classification of systematic error). Please do not…

A: Method error is caused by the defects in the exoerimental methods.

Q: thickness

Q: If the denisty of Platnuim is 19.32 g/cm3 what could the dimnesions of a cube be that weighted 1.00…

Question

A method of analysis yields masses of gold that are lower by 0.40 mg. Calculate the percent relative error caused by this result if the mass of gold in the sample is (a) 500mg (b) 70 mg

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Richards and Williard determined the molar mass of lithium and collected the following data (a) Find the mean molar mass determined by these workers. (b) Find the median molar mass (c) Assuming that the currently accepted value for the molar mass of lithium is the true value, calculate the absolute error and the present relative error of the mean value determined by Richards and Williard. (f) What factors have led to changes in molar mass since 191? (g) How would you determine the accuracy of a molar mass? Experiment Molar mass, g/mol 1 6.9391 2 6.9407 3 6.9409 4 6.9399 5 6.9407 6 6. 9391 7 6. 9406
7. 22 This question is about several salts. (a) A hydrated salt, compound A, is analysed and has the following percentage composition by mass: Cr, 19.51%; CI, 39.96%; H, 4.51%; O, 36.02%. Calculate the formula of compound A, showing clearly the water of crystallisation. Show your working. formula of compound A = (b) A student carries out an experiment to determine the amount of water of crystallisation in the formula of another hydrated salt. The student intends to remove the water by heating the hydrated salt. A diagram of the apparatus used by the student is shown below. crucible pipeclay triangie The student adds the hydrated salt to the crucible and weighs the crucible and contents. The student heats the crucible and contents and allows them to cool. The student weighs the crucible and residue. The student's results are shown below. 16,84 Mass of crucible + hydrated salt/g 16.26 Mass of crucible + residue after heating/g
In compounding a prescription, a pharmacist weighed 0.05 g of a substance on a balance insensitive to quantities smaller than 0.004 g. What was the maximum potential error in terms of percentage?
(b) Potassium nitrate was synthesized in an experiment using 10 mL of nitric acid and excess potassium hydroxide. The mass data obtained from the experiment is shown in Table 1 below. Given that the percentage yield of potassium nitrate was 88.3 %, calculate the concentration (% m/v) of the nitric acid used in the experiment. Table 1: Mass data for the synthesis of potassium nitrate from nitric acid and potassium hydroxide Mass of clock glass and crystallized potassium nitrate/ 45.55 Mass of empty clock glass/ g 39.18
Use the meaning of the prefix "nano-" to select the value of "x" in this equation: 1 m = 1 x 10x nm . The value of " x " is (a) +9 (b) -6 (c) +6 (d) -9
How is accuracy and precision related to errors incurred in the chemical analysis?
You are given a hammer a battery, a bulb, wires and switch(a) How could you use them to distinguish between samples of metals and non metals?(b) Assess the usefulness of these tests to distinguish between metals and non-metals
Suppose a student measured the mass of a sample that has a known mass of 40.5809 g using an analytical balance. The mass they observed was unstable, constantly jumping between 39.5 and 41.5. Choose all of the following reasons that could cause this error. O The doors to the analytical balance were not closed completely, allowing an air current to circulate inside the balance. One weigh boat was used to tare the balance while a different one was used when the sample was massed. Twice the amount of sample was placed on the analytical balance. O The sample was heated, causing a convective flow.
(A)18.7g NO2 express your answer in moles to three significant figures. (B)1.88 kgCO2 express your answer in moles to three significant figures. (C) 48.8 g KNO3 express your answer in moles to three significant figures. (D) 116.2 kgNa2SO4 express your answer in moles to four significant figures.
In preparing a zinc oxide ointment, 28.35 g of zinc oxide was used rather than the correct quantity, 31.1 g. What percentage error was incurred?
The fundamental difference between gravimetric and volumetric analysis: a gravimetric analysis involves a mass measurement as the determining measurement, while a volumetric analysis involves a volume measurement as the determining measurement, true or false?
Be sure to answer all parts. Urea, chemical formula (NH,)½CO, is used for fertilizer and many other things. Calculate the number of N, C, O, and H atoms in 1.68 x 10* g of urea. Enter your answers in scientific notation. (a) Nitrogen, N x 10 atoms (b) Carbon, x 10 atoms (c) Oxygen, x 10 atoms (d) Hydrogen, H x 10 atoms