A length of rope is wrapped around a spool of weight W with inner radius r and outer radius R. The rope is pulled with a tension T at an angle ?. Which of the following conditions must be satisfied for the spool to slide uniformly without rolling? cos? = r/R sin? = r/R T = W T = Wsin? T = Wcos?

A length of rope is wrapped around a spool of weight W with inner radius r and outer radius R. The rope is pulled with a tension T at an angle ?. Which of the following conditions must be satisfied for the spool to slide uniformly without rolling? cos? = r/R sin? = r/R T = W T = Wsin? T = Wcos?

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter8: Rotational Equilibrium And Rotational Dynamics

Section: Chapter Questions

Problem 35P: A rope of negligible mass is wrapped around a 225 kg solid cylinder of radius 0.400 m. The cylinder...

See similar textbooks

Related questions

Q: University Physics 1 - Gravitation & Oscillation I need help with this problem and an…

A: The satellite moves in space in an orbit with very high velocity and tends to free fall towards the…

Q: I. A boy uses a rope to pull a loaded sled of mass m = 125 kg along a horizontal surface of snow at…

A: Variables and FormulasMass of the sled, m=125kgCoefficient of kinetic friction, μk=0.10Angle of…

Q: 7.15 A new sports stadium is being proposed for a city in North Dakota. Some of the project details…

Q: Example 2: Fixing the problem....simple optics. A person who is near-sighted has a far point of 460…

Q: can you help me with this problem:

Q: If the middle electron in the previous question is displaced horizontally by a very small distance,…

Q: An astronaut who is repairing the outside of her spaceship accidentally pushes away a 93.3 cm long…

A: The objective of this question is to find the magnitude of the electromotive force (emf) induced in…

Q: Find the magnitude and direction of the force between two current-carrying wires given I1 = 15A, I2…

Q: Plastic beads can often carry a small charge and therefore can generate electric fields. Three beads…

A: Step 1:The sum of the charges of q1 and q2is −8.3μCThe net charge of all the three beads is…

Q: Question Use the relationship between resistance, resistivity, length, and cross-sectional area to…

A: Explanation is given in answer itself.

Q: The fundamental frequency of an organ pipe, closed at one end, is 254.2 Hz. What is the…

Q: The figure below shows a series RLC circuit with a 21.0-Q resistor, a 460.0-mH inductor, and a…

Q: Pa ed ook Hint Print References Check my worl 20 Required information A piano "string" is steel wire…

Q: A thin metal disk mass 2.00×10^(−3)kg and radius 2.20 cm is attached at its center to a long fiber…

A: Step 1:

Q: 1. Find the moment of the 500 N force shown about Point A. Write your answer using 2 significant…

Q: A magnetic field is used to bend a beam of electrons. What uniform magnetic field is required to…

Q: Hbvagah8818182

A: Step 1:a=0.5mr = a/sqrt(3)r = 0.2887 m =0.2887m Step 2:Using Coulomb's law…

Q: You measure the mass (m) and physiological cross-sectional area (PCSA) of two muscles: Which…

A: The force that a muscle can produce is directly proportional to its physiological cross-sectional…

Q: Two boxes, A and B, are connected to each end of a light vertical rope, as shown in the following…

A: Step 1: GivenFA = 76.0 NTension in the rope, T = 33.0 NDistance descended by box B, d= 10.6 mTime…

Q: A laser bean in air is incident at an angle of 35 degrees with respect to the normal. The…

Q: Please don't provide handwritten solution ...

Q: A cosmic ray proton moving towards the Earth at 4.5 * 107 m/s experiences a magnetic force of 1.95 *…

A: The objective of the question is to find the strength of the magnetic field that a cosmic ray proton…

Q: A.5 After deposition of an Al film, the basic frequency of the quartz crystal monitor (10 MHz) is…

A: Step 1: Step 2: Step 3: Step 4:

Q: Q. A 75.0 kg boulder is placed at a distance of 1.40 m from the right end of a uniform 2.00 m long…

A: Step 1:Step 2:Step 3:

Q: Please add diagram for this question, Do not make mistakes.

A: Approach to solving the question: Detailed explanation:Examples: Key references:

Q: A hockey puck is sliding cross the ice at 108.0 km/h. The coefficient if friction is 0.222 How far…

Q: One type of BB gun uses a spring-driven plunger to blow the BB from its barrel. (a) Calculate the…

A: Approach to solving the question:Please see attached photos for detailed solutions. Thank you.…

Q: Suppose that a stove had a surface area of only 1.97 m2 . What would it's temperature (in kelvins)…

Q: 1. This question goes way back to the end of chapter 8 and the combined tones described there. You…

A: In music, a musical interval is the difference in pitch between two notes. A musical fourth is a…

Q: A pure aluminum plate is part of a heat shield for a manufacturing process. The aluminum plate has a…

A: Step 1:Step 2: Step 3: Step 4:

Q: Part A The nucleus of a typical atom is 5.0 fm ( 1 fm 10-15 m) in diameter. A very simple model of…

Q: A huge tank of Persian crude oil with a density of 915 kg/m3 is vertically stationed on a platform…

A: Step 1:Step 2:Hope this helps!

Q: Suppose 1.95 liters of gas at 35.5 °C is under 7.31 × 107 pascals of pressure. How many moles of gas…

A: In this problem, we use the ideal gas law PV = nRTPressure = 7.31 x 107 Pascals = 721.45 atm ;…

Q: Ps: 0.212V is also wrong

A: Step 1:Length is 9.4×10−2mArea is 5×10−5m2No of turns is 6500 per meter of lengthCurrent is 1.5ATime…

Q: 4. A pipe strut BC is loaded and supported as shown. The strut has a uniform cross section and a…

Q: Water at a gauge pressure of 3.8 atm at street level flows into an office building at a speed of…

A: Step 1:

Q: Unit 6 - Rotational Motion Test X physic math what is torque equation - Goog x | + ⭑…

A: The objective of the question is to find the velocity of the ball at the equilibrium position of a…

Q: Binary Star SystemAstronomers discover a binary star system with a period of 90 days, separated by a…

A: In the figure big circular represent the circular orbit( path) of the binary stars Thank you

Q: (a) An inductor designed to filter high-frequency noise from power supplied to a personal computer…

A: Step 1: L≈21.22mHSo, the minimum inductance required for the inductor to produce a reactance of 2.00…

Q: In the figure a 130-turn coil of radius 5.00 cm and resistance 2.00 Ω is placed around a smaller…

Q: Problem 5.17 A large parallel-plate capacitor with uniform surface charge σ on the upper plate and…

A: Step 1: Step 2:

Q: Light bulb 1 operates with a filament temperature of 2900 K, whereas light bulb 2 has a filament…

A: Step 1:Step 2:

Q: A raisin1 is held between a thin converging lens and its focal point. In the following questions,…

A: The objective of the question is to understand the behavior of the image formed by a converging lens…

Q: A scuba diver training in a pool looks at his instructor as shown in the figure on the next page.…

A: Step 1: a) According to Snell's law, if 'i' and 'r' are the angle of incidence and angle of…

Q: Explain why water boils at a lower temperature (< 100oC) in locations such as Denver, Colorado…

A: The atmospheric pressure is low at higher altitudes as compared to sea level. This causes decrease…

Q: U3P1 Graphically determine the equilibrant of the following vectors. V1=250@0°, V2=400@135° and V3 =…

A: Step 1:

Q: ANSWERS ASK YO max For the circuit shown in the figure below, AV, = 77.0 V, w = 65.0π rad/s, and L =…

Q: plz answer in details, thanks

Q: Use perturbation theory to calculate the first-order correction to the ground state energy ofan…

A: Solution Any doubt please askThank you

Q: 1) A blimp (a type of balloon) is filled with 2000 m3 of hydrogen gas. How much mass can the balloon…

A: Step 1:Step 2:Step 3:

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

A boy rides his bicycle 2.00 km. The wheels have radius 30.0 cm. What is the total angle the tires rotate through during his trip?
A system of point particles is rotating about a fixed axis at 4 rev/s. The particles are fixed with respect to each other. The masses and distances to the axis of the point particles are m1=0.1kg , r1=0.2m , m2=0.05kg , r2=0.4m , m3=0.5kg , r3=0.01m . (a) What is the moment of inertia of the system? (b) What is the rotational kinetic energy of the system?
A uniform cylindrical grinding wheel of mass 50.0 kg and diameter 1.0 m is turned on by an electric motor. The friction in the bearings is negligible. (a) What torque must be applied to the wheel to bring it from rest to 120 rev/min in 20 revolutions? (b) A tool whose coefficent of kinetic friction with the wheel with a force of 40.0 N. What torque must be supplied by the motor to keep the wheel rotating at a constant angular velocity?
A man stands on a merry-go-round that is rotating at 2.5 rad/s. If the coefficient of static friction between the man’s shoes and the merry-go-round is s=0.5 , how far from the axis of rotation can he stand without sliding?
The precession angular velocity of a gyroscope is 1.0 rad/s. If the mass of the rotating disk is 0.4 kg and its radius is 30 cm, as well as the distance from the center of mass to the pivot, what is the rotation rate in rev/s of the disk?
A rope of negligible mass is wrapped around a 225 kg solid cylinder of radius 0.400 m. The cylinder is suspended several meters off the ground with its axis oriented horizontally, and turns on that axis without friction, (a) If a 75.0-kg man takes hold of the free end of the rope and falls under the force of gravity, what is his acceleration? (b) What is the angular acceleration of the cylinder? (c) if the mass of the rope were not neglected, what would happen to the angular acceleration of the cylinder as the man falls?
Figure P12.67 shows a vertical force applied tangentially to a uniform cylinder of weight Fg. The coefficient of static friction between the cylinder and all surfaces is 0.500. The force P is increased in magnitude until the cylinder begins to rotate. In terms of Fg find the maximum force magnitude P that can be applied without causing the cylinder to rotate. Suggestion: Show that both friction forces will be at their maximum values when the cylinder is on the verge of slipping.
A potters wheela thick stone disk of radius 0.500 in and mass 100 kgis freely rotating at 50.0 rev/min. The potter can stop the wheel in 6.00 s by pressing a wet rag against the rim and exerting a radially inward force of 70.0 N. Find the effective coefficient of kinetic friction between wheel and rag.
Figure P10.82 shows a vertical force applied tangentially to a uniform cylinder of weight Fg. The coefficient of static friction between the cylinder and all surfaces is 0.500. The force P is increased in magnitude until the cylinder begins to rotate. In terms of Fg, find the maximum force magnitude P that can be applied without causing the cylinder to rotate. Suggestion: Show that both friction forces will be at their maximum values when the cylinder is on the verge of slipping. Figure P10.82
The wheel of a car has a radius of 0.300 m. The engine ofthe car applies a torque of 240 N*m to this wheel, which does not slip against the road surface. Since the wheel does not slip, the road must be applying a force of static friction to the wheel that produces a counter torque. Moreever, the car has a constatnt velocity, so this counter torque balances the applied tourque. What is the magnitude of the static frictional force?
A thin cord is wrapped around a uniform grindstone of radius 0.30 m and mass of 25 kg supported by bearings that produce negligible friction torque. The cord exerts a steady tension force on the grindstone, causing it to accelerate from rest to 60 rad/s in 12 s. (lgrindstone = 5 What is the magnitude of the tension force of the cord? O 5.6 N 11.3 N O 18.7 N O 37.5 N
A 2-kg disk has a radius of 18 cm and rotates with an angular acceleration of 12 rad/s2about an axis through its center and perpendicular to the plane of the disk. Determine the tangential force at the rim of the disk.