A circular loop of wire is centered at the origin of an axis system. The plane of the loop is in the xy plane. A B-field, which is increasing in magnitude, is directed along the +z axis. Determine the direction of the induced current in the loop. A. clockwise when viewed from the front B. counterclockwise when viewed from the front C. The current direction alternates back and forth in the loop D. There is no current in the loop

A circular loop of wire is centered at the origin of an axis system. The plane of the loop is in the xy plane. A B-field, which is increasing in magnitude, is directed along the +z axis. Determine the direction of the induced current in the loop. A. clockwise when viewed from the front B. counterclockwise when viewed from the front C. The current direction alternates back and forth in the loop D. There is no current in the loop

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter31: Faraday’s Law

Section: Chapter Questions

Problem 31.5OQ: A square, flat loop of wire is pulled at constant velocity through a region of uniform magnetic...

See similar textbooks

Similar questions

(a) If the emf of a coil rotating in a magnetic field is zero at t = 0, and increases to its first peak at t = 0.100 ms, what is the angular velocity of the coil? (b) At what time will its next maximum occur? (c) What is the period of the output? (d) When is the output first one-fourth at its maximum? (e) When is it next one-fourth at its maximum?
A rectangular conducting loop is placed near a long wire carrying a current I as shown in Figure OQS1.3. If I decreases in time, what can be said of the current induced in the loop? (a) The direction of the current depends on the size of the loop. (b) The current is clockwise. (c) The current is counterclockwise. (d) The current is zero. (e) Nothing can he said about the current in the loop without more information.
The square armature coil of an alternating current generator has 200 turns and is 20.0 cm on side. When it rotates at 3600 rpm, its peak output voltage is 120 V. (a) Wliat is the frequency' of the output voltage? (b) What is the strength of the magnetic field in which the coil is turning?
(a) An MRI technician moves his hand from a region of very low magnetic field strength into an MRI scanner's 2.00 T field with his fingers pointing in the direction of the field. Find the average emf induced in his wedding ling, given its diameter is 2.20 cm and assuming it takes 0.250 s to move it into the field. (b) Discuss whether this current would significantly change the temperature of the ring.
A coil of area 0.100 m2 is rotating at 60.0 rev/s with the axis of rotation perpendicular to a 0.200-T magnetic field. (a) If the coil has 1 000 turns, what is the maximum emf generated in it? (b) What is the orientation of the coil with respect to the magnetic field when the maximum induced voltage occurs?
Figure P30.41 shows a compact, circular coil with 220 turns and radius 12.0 cm immersed in a uniform magnetic field parallel to the axis of the coil. The rate of change of the field has the constant magnitude 20.0 mT/s. (a) What additional information is necessary to determine whether the coil is carrying clockwise or counterclockwise current? (b) The coil overheats if more than 160 W of power is delivered to it. What resistance would the coil have at this critical point? (c) To run cooler, should it have lower resistance or higher resistance? Figure P30.41
(a) By how many percent is the torque of a motor decreased if its permanent magnets lose 5.0% of their strength? (b) How many percent would the current need to be increased to return the torque to original values?
(a) A car generator turns at 400 rpm when 1he engine is idling. Its 300-turn, 5.00 by 8.00 cm rectangular coil rotates in an adjustable magnetic field 50 that it can produce suf?cient voltage even at low rpms. What is the field strength needed to produce a 24.0 V peak emf? (b) Discuss how this required field strength compares to those available in permanent and electromagnets.
Shown below is a conducting rod that slides along metal rails. The apparatus is in a uniform magnetic field of strength 0.25 T, which is directly into the page. The rod is pulled to the right at a constant speed of 5.0 m/s by a force . The only significant resistance in the circuit comes from the 2.0resistor shown. (a) What is the emf induced in the circuit? (b) What is the induced current? Does it circulate clockwise or counter clockwise? (c) What is the magnitude of(d) What are the power output of and the power dissipated in the resistor?
What is the value of the magnetic flux at coil 2 in Figure 23.56 due to coil 1? Figure 23.56 (a) The planes of the two coils are perpendicular. (b) The wire is perpendicular to the plane of the coil.
An N-turn circular wire coil of radius r lies in the xy-plane (the plane of the page), as in Figure P20.10. A uniform magnetic field is turned on, increasing steadily from 0 to B0 in the positive z-direction in t seconds. (a) Find a symbolic expression for the emf, , induced in the coil in terms of the variables given. (b) looking down on at the xy-plane from the positive z-axis, is the direction of the induced current clockwise or counterclockwise? (c) If each loop has resistance R, find an expression for the magnitude of the induced current, I.
A circular coil with 200 turns Las a radius of 2.0 cm. (a) What current through tire coil results in a magnetic dipole moment of 3.0 Am2? (b) What is the maximum torque that the coil will experience in a uniform field of strength 5.0102 ? (c) If tire angle between and B is 45°, what is the magnitude of tire torque on the coil? (d) What is the magnetic potential energy of coil for this orientation?