Answered: A circuit containing a 10 Ohms…

A circuit containing a 10 Ohms resistance is in series to 250 microFarad capacitance with a source of 40Volts. The switch is turned on at t = 0. What is the time will reach the the steady state value

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter20: Capacitance In Ac Circuits

Section: Chapter Questions

Problem 5PP: Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 -...

See similar textbooks

Related questions

Q: a) It is applied direct current to RC circuit. Which figure does belong to power supply, which…

A: a)we need to identify and explain which figure belongs to power supply and which one is for…

Q: Q2) For the circuit in the figure, the capacitance is 0.5, the resistor is linear with v-i…

A: It is given that the resistance has a linear characteristic v=2i. So we have vi=2. And by ohm's law…

Q: Assume the switch is closed and enough time has elapsed for the circuit to be in "steady-state,"and…

A: In circuit under steady state condition after the switch is closed, the capacitor will act as open…

Q: Consider the R-C circuit. we idealise the emf to be constant and have zero internal resistance. We…

A: as stated, the capacitor is initially not charged. and it is conneced in series with the resistance…

Q: 3 Assume that the circuit shown in Figure P5.73 is underdamped and that the circuit initially has no…

A: The circuit is under-damped circuit and has no initial energy stored. The circuit diagram is shown…

Q: The circuit shown in _below figure consists of ideal capacitors, inductors, resistors and current…

Q: You measure the capacitanceC1of a capacitor by doing thefollowing: First connect capacitorsC1andC2in…

A: Given capacitance c2 is 3 mf and slope of the graph between voltage across c2 and supply voltage Vs…

Q: An RC circuit has an emf of 5 V, a resistance of 10 ohms, a capacitance of 10 – 2 F, and initially a…

Q: An industrial load has been modeled as a series combination of a capacitance and a resistance as…

Q: Design a single circuit element containing one inductor, one capacitor and one resistor with v(t) of…

A: Steps: Possibilities of elements are Resistor, Inductor, and Capacitor Since voltage contains a dc…

Q: Is the circuit currently in steady-state or transient condition? Justify your answer. Based on the…

A: In this question, RL circuit is given as per question. Justifiy the given. 1. Is the circuit…

Q: An inductor (L= 0.35 H) and two resistors (R1 = R2 = 2.0 N) are connected to a battery with an emf…

A: According to question: a) The potential drop across inductor at t=0.040sec is calculated as…

Q: An electromotive force of 100 volts is applied to an RC series circuit, in which the resistance is…

Q: Task 2: Consider the electrical system in the figure below, derive a differential equation that…

Q: a) A variable capacitance and a resistance of 100 Q are connected in series across a 240-V; 50-Hz…

A: Here, we have asked about a series circuit having a combination of a resistor and a capacitance in…

Q: 200-volt electromotive force is applied to an RC series circuit in which the resistance is 1000 ohms…

Q: For the circuit shown in the figure, in which the capacitor is initially fully discharged. If the…

Q: 2. In the circuit shown below, the switch is closed long enough for the circuit to reach DC…

A: For calculation of thevinin resistance remove the L and find resistance seen from the terminals of…

Q: Q1/ For the network shown in figure (Q1), the switch has been in position "a" for a long time. At…

A: In this network shown as per given question, Initial switch at position a for long time. At the…

Q: Switch S in in the figure is closed at time t = 0, to begin charging an initially uncharged…

Q: Consider the circuit shown in the figure, with ε=36.0V,R0=50.0Ω,R=150Ω andL=4.00H. (a) Switch S1 is…

Q: Rs Vs R2: Figure P5.47 8 For the circuit of Figure P5.47, assume Vs 100 V, Rs = 4 k2, R¡ = 2 k2, R2…

A: To find the voltage across capacitor (vc) of the following circuit:

Q: Switch S is closed in position a at time t = 0 for along of time in the below circuit, to being…

A: The capacitor stores the charge in the form of voltage. The current can be exponential decaying or…

Q: Propose set of differential equations that fully describe the behavior of the system shown in Figure…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: What are the steps in solving a circuit having a resistance, a source, and an inductance (or…

A: Concept: A capacity to do work is called energy and it may exist in potential, kinetic, thermal,…

Q: t=0 Rs1 Rs2 LE R Vsi R2 Vs2 Figure P5.61 2 In the circuit shown in Figure P5.61 Vsi = 12 V Rsi = 50…

A: As it is known that the capacitor behaves as an open circuit and the inductor behaves as the short…

Q: EUDORA IS LOOKING AT A CIRCUIT THAT HAS A 0.05 HENRY INDUCTANCE AND A 20 OHM RESISTANCE. ALSO, WITH…

Q: In the circuit given below, a) When the switch is in position 1 at t = 0 seconds, the current (Ic)…

A: (a) When switch is at position 1 the circuit will look like

Q: Plot the graph between P vs Va in Dc series excitation motor

A: Armature voltage : Armature voltage is the voltage developed at the…

Q: Calculate V1 and v2 for t > 0, if the circuit is in steady state at t = 0-.

Q: 10. In the figure, suppose the switch has been closed for a time interval sufficiently long for the…

A: The voltage across a capacitor will not change suddenly unless an impulse source is applied. Under…

Q: 3. You have seen how Kirchhoff's laws were used in your lectures to obtain a 2nd order differential…

A: According to the question we have to find At what time Thaly will the amplitude of the charge…

Q: What is the practical application of a circuit that you can tune such that it reaches some minimum…

A: The Resistance in a circuit can be paired as the series or parallel combination. These combinations…

Q: The capacitor has been added to the load in the circuit shown in figure below to maximize the power…

A: In this question we need to find a value of capacitance so that maximum power transfer to load.

Q: An R-C series circuit consists of a capacitor with capacitance, C, connected in series with a…

Q: switch In the figure, suppose the switch has been closed for a time interval sufficiently long for…

A: Given- Voltage = 42 V R1 = 8 ohm R2 = 6 ohm R3 = 3 ohm C = 4 μF

Q: Consider a circuit consisting of a 12 V battery, a 50 Ω resistor, and a 100 µF capacitor connected…

Q: 3. You have seen how Kirchhoff's laws were used in your lectures to obtain a 2nd order differential…

A: Kirchoff's law states that the sum of all currents flowing through a closed is zero.

Q: Refer to attached image

A: If we give supply to an uncharged capacitor then at time (t=0) it behaves like short circuit and at…

Q: Att<0, a 360-nF capacitance is charged to an unknown voltage Vị. The capacitance is in parallel with…

A: A parallel RC circuit Initial capacitance have Vi voltage. If voltage across the capacitance at…

Q: Q.15: The switch has been in position "a" for a long time. At t=0 the switch is moved to position…

Q: Att<0, a 360-nF capacitance is charged to an unknown voltage Vj. The capacitance is in parallel with…

A: Applying KCL at node gives diffrential equation in terms of capacitor voltage. Solving differential…

Q: Calculate the theoretical voltages across the resistor (VR) and capacitor (VC) for 500 Hz and 1750…

A: Given An RC circuit,we need to determine the voltage across capacitor and resistor. Please find the…

Q: A resistor of resistance 20 ohms is in series with an inductor of inductance 2H. At t = 0, it is…

A: Given data Resistance is R = 20 ohms Inductance is L = 2 H Source voltage is Vs = 50 V Expression…

Q: 8 For t > 0, the circuit shown in Figure P5.22 is at steady state. The switch is changed as shown at…

A: The circuit diagram is,

Q: Att = 0, a charged 27-µF capacitance is connected to a voltmeter (VM), as shown in the figure below.…

A: The capacitor stores the charge in the form of voltage. The current can be exponential decaying or…

Q: 10. What happens to the potential difference across the resistor when the capacitor becomes fully…

A: Explanation: “Since you have asked multiple questions, we will solve the first question for you. If…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

A circuit containing a 10 Ohms resistance is in series to 250 microFarad capacitance with a source of 40Volts. The switch is turned on at t = 0. What is the time will reach the the steady state value?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
A resistor of 20 Ohms and a capacitance of unknown value when connected in in parallel across a 100V, 50Hz supply, take a current of 6A. The combination is now connected across a 100v supply of unknown frequency and the current falls to 5.5A. What is the frequency?
Using the series circuit in Figure 3 consisting of a voltage source V, the resistor R and the fully uncharged capacitor C, how to find the value of the capacitance C considering as known data the time constant of the circuit T and the value of the resistor R? V ww R
A resistor of 20ohms and a capacitance of unknown value when connected. In in parallel across a 100V, 50Hz supply take a current of 6A. The combination is now connected across a 100V supply of unknown frequency and the current falls to 5.5A . What is the frequency?
A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor?
The time taken by the series RL circuit having an inductance of 0.6 H and resistance of 30 Ohms to reach a steady-state value.
Let's say you measure t1/2 to be 0.037 seconds and the resistance in the circuit is 68 Ohms. Then what is the capacitance in micro Farads? Answer in micro Farads.
4. A RC series circuit is composed of a resistor of resistance 50 ohms and a capacitor of capacitance 100µF. It is suddenly disconnected from a source voltage of 12V. Determine the time it takes for the voltage across each element is equal and determine the rate of change in the current at this time.
An inductor and a resistor are in series with a sinewave voltage source. The frequency is set so that the inductive reactance is equal to the resistance. If the frequency is increased, then options: Voltage across the inductor= Source Voltage Voltage across the inductor> Voltage across the resistor Voltage across the inductor= Voltage across the resistor Voltage across the resistor > Voltage across the inductor
A 22-k resistor and a 0.02-F capacitor are connected in series to a 5-V source. How long will it take the capacitor to charge to 3.4 V Select one: a. 0.501 ms b. 0.66 ms c. 0.44 ms d. 0.70 ms
A capacitor in series with a 200 ohms resistor draws a current of 0.3 ampere from 120 volts, 60 hz source. What is the value of the capacitor in microfarad? a. 8.7 b. 9.7 c. 6.7 d. 7.7