a battery of E volts. At t=0 the current is zero. Find the current at any time t > 0 and the maximum current if E=32e-8t
Q: 10-ohm resistor and 10 H inductor are connected in series across a source of 12 V. If the current is…
A:
Q: Consider the circuit shown in the figure. A short time after closing the switch, the charge on the…
A: Initially, the capacitor is fully charged. The capacitor discharges when the switch is open, the…
Q: Consider the circuit shown in the figure. The circuit is kept running for a very long time. IfI, =…
A:
Q: 5. A circuit contains a 30 mH inductor, a 20 resistor, and a battery. Initially a switch was off (no…
A: In this question , RL circuit is given with DC source .We have to find out current through circuit…
Q: A. A voltage waveform is described mathematically as 50tV 0<t<1 100 – 50tV 1<t<3 v(t) = -200 + 50tV…
A: As per our policy I have to do the first one only, vt=50t 0<t<1100-50t…
Q: The switch in the circuit seen in has been in position a for a long time. At the switch me…
A:
Q: Mathematical discussion is posted a screenshot for further information.
A: Evaluating the amplitude of current wave when a triangular wave voltage of amplitude 2 V and…
Q: capacitor having capacitance of 10uF is connected with 1k ohm resistor in series. The switch of the…
A: Series circuit which have capacitor 10uF with 1k ohm resistor. DC supply =10 Volts, a. Draw a…
Q: in the circuit shown below has been in position x for a long time. The initial charge on the 60 nF…
A: The circuit at t=0- is The circuit at t=0+ is The circuit at t=∞ is
Q: Draw the inductance and resistance voltages on an oscilloscope screen in accordance with their…
A: The formula for Ohm's law mentioned in the last line is incorrect. The actual formula is V=IR. The…
Q: A resistor-inductor circuit is supplied by a variable voltage source defined by 3 sin(2t) in Volts.…
A:
Q: 3. Four capacitors are connected to a EMF as shown with C, = 20 µF, C2 = 4 µF, C3 = 3 µF, and C4 = 4…
A:
Q: A 1-H inductor is connected in series with a 6-ohm resistor. If the connection is energized from a…
A: As current through long time indicates that time "t" tends to infinity
Q: The capacitor shown in the figure is initially charged to +10 V. The switch closes at time t = 0.…
A: Given values are - VC0=10Volt Given circuit is - Given that switch is closed at (t = 0).
Q: 2. The circuit shown in Figure-2 is at steady state before the switch closes at time t = 0. The…
A:
Q: 2. Suppose that you have a circuit that has a resistance of 6 Ohms, capacitance of 1/24 Farads, and…
A:
Q: Untufastresult.com C ELECTRICAL AND ELECTRONICS ENGINEERING (BEEE) 1 Prove that the energy stored in…
A: Given, R = 25ΩL = 64 mHC = 80μFV = 110 ∠0°f = 50 Hz Circuit diagram,
Q: Q.1: An RC circuit with a 110.0 V power source is connected to a fluorescent lamp as shown in the…
A: VS=110 VVL=75 Vt=0.65 secR=3 MΩ Using the expression, V0t=VS1-e-tτ →eq. 1 substituting the given…
Q: The figure shows an electrical circuit with an ideal source ε1 = 12 [V], a real source ε2 = 9 [V]…
A: A circuit circuit is shown the question. One source is ideal source ε1=12 Volts. Once source is real…
Q: 1. For the network shown in Figure 1: (a) Determine the mathematical expressions for the variation…
A: solution (a) switch closed at position 1 at t=0iL(0-)=0AiL(0+)=iL(0-)=0Abecause inductor does not…
Q: Q1. In the adiacent figure each of the two capacitors mounted in parallel has a value C, the…
A: given data:
Q: 10. In the figure, suppose the switch has been closed for a time interval sufficiently long for the…
A: The voltage across a capacitor will not change suddenly unless an impulse source is applied. Under…
Q: 9. The initial rate of current rise in an R-L circuit is 800 amps per sec when 453 volts is suddenly…
A: (9) Given Initial rate of rise of current in the circuit is 800 amp/sec. i.e di/dt = 800 amp/sec…
Q: 2. The circuit shown in Figure-2 is at steady state before the switch closes at time t= 0. The input…
A:
Q: switch In the figure, suppose the switch has been closed for a time interval sufficiently long for…
A: Given- Voltage = 42 V R1 = 8 ohm R2 = 6 ohm R3 = 3 ohm C = 4 μF
Q: The figure below shows how a bleeder resistor (R = 236 KA) is used to discharge a capacitor (c -…
A: (a) Write the formula for the time constant. τ=RC Solve as, τ=236 kΩ60.8 μF=14.3488 sec This is the…
Q: 14. Figure 9 shows the voltage across a capacitor discharging through a 2k resistor. Use the graph…
A: Given the figure which shows the voltage across a capacitor discharging through a 2 kΩ resistor. We…
Q: 10.A 100-µf capacitor is connected in series with a 150-volt voltmeter that has a resistance of…
A: In this question, we need to determine the reading of the voltmeter V, Where sensitivity of the…
Q: Question 5 Consider the circuit shown in the figure. The circuit is kept running for a very long…
A:
Q: In the figure R1 When the switch is opened after having been closed for a long time, the current in…
A: Given circuit is shown below. Given data is R1=4Ω, R2=1Ω. When switch is opened inductor current…
Q: 3. For the circuit, (i) Find the voltage vc and the current ic if the capacitor was initially…
A: At steady state capacitor acts as open circuit
Q: A capacitor can be used .............................................. in electrical circuits. Which…
A:
Q: For the electric circuit shown in the figure beside, the switch has been in position "1" for a long…
A: In this question we will find inductor current....
Q: The switch in the picture below has been open for a long time. It is then closed at t=0 s. A) Write…
A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…
Q: a) Find the mathematical expression for the voltage VR (t).
A: Find the mathematical expression for the voltage VR (t).
Q: An (open) electric circuit consists of an inductor, a resistor, and a capacitor. There is an initial…
A: Given that: Initial charge q(0)=2 C I=3 A E(t)=20 cos(t) The voltage drop across the resistor is 4…
Q: J1 J2 Xsc2 R1 4 Key = A 4700 Key = A Tektronix V1 =25 V C1 :1000µF R2 1kQ
A: If switch J2 is closed then C1 and R2 are in parallel. Now if J1 is closed then initially capacitor…
Q: ** 18. The following questions refer to the circuit represented by the diagram at right. Think of R,…
A: According to the question we have to calculate, a) Immediately after the switch is closed,…
Q: In the following circuit E=10 V, R=5 Q and C=4 µF. The capacitor is initially uncharged. The switch…
A: a..>> In the given circuit ,E= 10 V. The capacitor initially behaves as short circuit. So 2R…
Q: A resistor of resistance 20 ohms is in series with an inductor of inductance 2H. At t = 0, it is…
A: Given data Resistance is R = 20 ohms Inductance is L = 2 H Source voltage is Vs = 50 V Expression…
Q: switch In the figure, suppose the switch has been closed for a time interval sufficiently long for…
A: Given- Voltage = 42 V R1 = 8 ohm R2 = 6 ohm R3 = 3 ohm C = 4 μF To find- Current at steady state =?…
Q: Q1. In the adjacent figure each of the two capacitors mounted in parallel has a value C, the…
A: Before closing the key S, from the given figure in the question, Voltage across capacitor is, Vc(0-…
Q: What is the current at t = 0.008 s? (In [A]) c) What is the voltage at t = 0.008 s?
A:
Q: Problem #1: If the current flowing through a 75mH inductor has the waveform shown below. (a)…
A: (a) Calculate the equation of current from the graph using the straight-line method for the time…
Q: Att = 0, a charged 27-µF capacitance is connected to a voltmeter (VM), as shown in the figure below.…
A: The capacitor stores the charge in the form of voltage. The current can be exponential decaying or…
Q: 4) After the switch has been closed for a very long time, it is then opened. What is I3(topen), the…
A:
An electric circuit contains an 8 ohm resistor in series with an inductor of 0.50 henries and a battery of E volts. At t=0 the current is zero. Find the current at any time t > 0 and the maximum current if E=32e-8t
Step by step
Solved in 2 steps with 2 images
- 1. A purely resistive circuit the current is leading by 90° with respect to voltage. 2. A purely inductive circuit the current is lag behind the voltage by 90°. 3. A purely capacitive circuit the current is lead by 90° with respect to the voltage. 4. A capacitor element stored magnetic energy. 5. An inductor element stored electrical energy. 6. Resistor elements consume power. 7. Angle between current and voltage is called power. 8. The power factor angle for a purely resistive is zero. 9. The power factor angle for a purely inductive load is -90°. 10. The power factor of a purely capacitive is leading.How temperature effect conductivity? Explain with the help of following equation. m e'n7'Electrical Engineering I'm reading about the electronics in touch screen. It says when i touch the panel it distorts the electrostatic field and thus will have a change in capacitance. This is how it detects My question is the electrostatic field same as electric field? Please explain in details How did the capacitance change when i just touch the panel
- If a circuit has a resistance of 3002 and a series inductance of 5002, what is the relationship between the applied circuit voltage and the circuit current? The applied voltage lags the circuit current. The phase shift between the circuit voltage and current changes with time. The applied voltage is in phase with the circuit current. The applied voltage leads the circuit cur Previous Page Next Page Page 2 of 10a. What is the instantaneous current when switch is closed at t=0 b. After t=0.3s, what is the current?The peak-to-peak alternating potential difference across a 150 2 resistor is 339 V. The r.m.s. current in the resistor is?
- Sketch even and odd for this figureThe distance of the first voltage maximum from the load is 4cm. The distance of the first current maximum of the load is 10cm Find the length of the standing wave. Select one: O a. 6cm O b. 24cm O c. 10cm O d. 12cmA 1-H inductor is connected in series with a 6-ohm resistor. If the connection is energized from a 9-V DC source, determine the current (in amperes) through the circuit for a long time. The initial current is 100 mA. Express your answers accurate to four decimal places. No need to put the units.
- An R-C series circuit has a supply voltage of 100 V. The resistance is 200 ohms and the capacitance is 0.0001 Farad. Solve for the current "i" at any time "t". Solve for the charge "q" at any time "t".C) A 25 A electrodynamic ammeter is controlled by a spring having a constant of 5.7295x 10-6 Nm/rad. The full scale deflection is 110°. Determine the inductance of the instrument while measuring a current of 20 A. The mutual inductance at 0° deflection is 4 u H and the change in mutual inductance is linear with the deflection.A 22-k resistor and a 0.02-F capacitor are connected in series to a 5-V source. How long will it take the capacitor to charge to 3.4 V Select one: a. 0.501 ms b. 0.66 ms c. 0.44 ms d. 0.70 ms