A bar 13 of length (0,6 m and weight 3 N issuspended horizontally by two strings at A andB. Civen that its centre of gravity is ().-1 m frvmA, the tension in the string at A is50.(0.2 N131.4 N0:8 N1.0 N

Given, Legth (L) = 0.6 m Weight (W) = 3N

A bar A8 of lengıh (0,6 m and weight 3 N is Suspended horizontally by two strings at A and B. Given that its centre of gravity is (),-1 m frm A, the tension in the string at A is (),2 N 13 1.4 N 0,8 N 1,0 N

A bar A8 of lengıh (0,6 m and weight 3 N is Suspended horizontally by two strings at A and B. Given that its centre of gravity is (),-1 m frm A, the tension in the string at A is (),2 N 13 1.4 N 0,8 N 1,0 N

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter8: Rotational Equilibrium And Rotational Dynamics

Section: Chapter Questions

Problem 16P

See similar textbooks

Related questions

Q: ) Unit of Young's modulus is: Select one: a. N/m O b. N/m? Oc. N.m2 O d. N

Q: Determine the tension at the cable TAB and TAC in the system below at equilibrium. 3 m C 4 m A 4.5…

Q: A 210 mm diameter pulley is prevented from rotating relative to a 61 mm diameter shaft by a 71 mm…

A: The width (b) is 15.90 mm

Q: m1 = 6.0 kg at (0.0, 0.0) m, m2 = 2.3 kg at (0.0, 4.3) m, and m3 = 4.0 kg at (3.9, 0.0) m. Determine…

Q: A non-uniform rod of length 1.00 m is hung horizontally, supported by strings on both ends. If the…

Q: A uniform bar whose mass and length are 55.0 kg and 8.00 m, respectively is supported by two light…

A: Given Data : The mass of the bar is given as mb = 55 Kg. The length of the bar is given as L = 8 m.…

Q: Solve for the center of gravity of the composite object below. A- 1.0 m 0.8 m 0.6 m Ø-0.76 m 3 m…

Q: What would be the maximum weight W of the block, shown in the following figure, so that the tension…

A: ∑Fx = 0TBC cos40 = TAC sin 30TBC = TAC sin 30cos40 ............eq(1)

Q: One end of a uniform 3.80-m-long rod of weight Fg is supported by a cable at an angle of ? = 37°…

Q: When the structure shown below is supported at point P, it is in equilibrium. Find the magnitude of…

A: Given, The system is in equilibrium about Point P.

Q: A uniform rod AB is 1.6 m long and weighs 16 N. It is suspended by strings AC and BD as shown. A…

Q: The sian Shown in Fia 7.48 is 4.00m long weighs 155ON, and is made of uniform materiale A weight of…

Q: The man has a weight W and stands at the center of the plank. If the planes at A and B are smooth,…

Q: Determine the magnitude P of the vertical force required to lift the wheelbarrow free of the ground…

Q: Determine the minimum distance x from point A at which an additional weight w (the same as the…

Q: 4] The members of a truss are pin connected at joint O. Determine the magnitude of F, and its angle…

Q: For the beam and loading shown, determine the tension in cable BC if P = 165.8, Q = 249.3, R =…

A: Here, a figure is given. Also, it is given that, P = 165.8, Q = 249.3, R = 355.4, S = 268.2, T =…

Q: If you hang at rest by your hands from a vertical rope, where is your centre of gravity with respect…

A: The center of gravity associated with a body is defined as the point, respect to which the torque…

Q: A uniform awning of mass 30 kg is attached to a building at one end and supported by a massless…

Q: A 3.0-m long steel wire of radius 0.60mm supports a weight of 50N. By how much is the wire elongated…

Q: One end of a uniform 4.70-m-long rod of weight F, is supported by a cable at an angle of 0 = 37°…

Q: A 557-N force is applied to stretch a cable, 66-m long and has a cross-sectional area of 2.8 mm^2.…

A: Given F=557 N L=66m A=2.8 mm2 Y=1.0x10^11 N/m2

Q: Look at the figure below. The horizontal beam weighs 200N, Find the tension in the cable if the…

Q: A P8.11 SL: dir Find the x and y coordinates of the center of gravity of a 4.00 ft by 8.00 ft…

A: consider the two rectangles, the big rectangle have area of 16 square feet ( 4.00 ft *4.00 ft) and…

Q: A museum of modern art is displaying an irregular 426-N sculpture by hanging it from two thin…

Q: If the required clamping force at the board A is to be 2.50 kN, determine the torque M that must be…

Q: One end of a uniform ℓ = 4.70-m-long rod of weight w is supported by a cable at an angle of ? = 37°…

Q: A 20.0-m tall hollow aluminum flagpole is equivalent in stiffness to a solid cylinder 4.00 cm in…

A: The expression for the required distance is,

Q: A non-uniform rod of length 1.00 m is hung horizontally, supported by strings on both ends. If the…

A: Length of the rod is 1m CG is at 0.2m from left end

Q: the grou Fig. 6.59 shows a uniform boom of mass m = supported by a cable perpendicular to the boom.…

A: The torque acting on a body is the force applied at a distance l from it's pivot point , required to…

Q: A light string ABCD whose extremity A is fixed, has weights W and W1 attached to at B and C and…

A: Given: A light string ABCD who is extremity A is a fixed, has weight W and W1 attached to at B and C…

Q: Answer must be according the correct signifcant numbers.

A: The length of the rod, The half-length of the rod,

Q: Two 20 kg blocks are connected by a 2.0-m-long, 5.0-mm-diameter rope. Young's modulus for this rope…

A: Given data: Mass m1=m2=20 kg Length of the rope l=20m Diameter of the rope d=5.0mm Young's modulus…

Q: The flanged steel cantilever beam with riveted bracket is subjected to the couple and two forces…

Q: A 7-m long beam of negligible mass is hanged horizontally and is supported at each end by vertical…

Q: A museum of modern art is displaying an irregular 426-N sculpture by hanging it from two thin…

Q: 1.0 The post weighs 8 kN/m. Determine the internal normal force in the post as a function of x. 2 m

Q: A uniform 0.40 kN boom is supported as shown. Find the tension in the tie rope and the components of…

Q: The Howe roof truss shown carries the given loads. The wind loads are perpendicular to the inclined…

Q: against the wall, where it is held by friction as shown in the figure below. The coefficient of…

Q: A 20.0 m tall hollow aluminum flagpole is equivalent in strength to a solid cylinder of aluminum…

Q: One end of a uniform meter stick is placed against a vertical wall. The other end is held by a…

Q: The triceps muscle at the back of her upper arm has an effective lever arm of 1.75 cm, and she…

A: Given: The weight of the women = 50 kg. The triceps muscle at the back of her…

Q: The location of the box's center of gravity is indicated by point G. The location of the box's…

Q: 45. A bar AB, of length 0.6 m and weight 3 N is suspended horizontally by two strings at its ends A…

Q: Two ladders, 4.00 m and 3.00 m long, are hinged at point A and tied together by a horizontal rope…

Concept explainers

Rotational Equilibrium And Rotational Dynamics

In physics, the state of balance between the forces and the dynamics of motion is called the equilibrium state. The balance between various forces acting on a system in a rotational motion is called rotational equilibrium or rotational dynamics.

Equilibrium of Forces

The tension created on one body during push or pull is known as force.

Question

A bar 13 of length (0,6 m and weight 3 N is
suspended horizontally by two strings at A and
B. Civen that its centre of gravity is ().-1 m frvm
A, the tension in the string at A is
50.
(0.2 N
13
1.4 N
0:8 N
1.0 N

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A 20.0-m tall hollow aluminum flagpole is equivalent in stiffness to a solid cylinder 4.00 cm in diameter. A strong wind bends the pole much as a horizontal force of 900 N exerted at the top would. How far to the side does the top of the pole flex?
Can Young’s modulus have a negative value? What about the bulk modulus?
A 100-N weight is attached to a free end of a metallic wire that hangs from the ceiling. When a second 100-N weight is added to the wire, it stretches 3.0 mm. The diameter and the length of the wire are 1.0 mm and2.0 m, respectively. What is Young’s modulus of the metal used to manufacture the wire?
The forearm shown below is positioned at an angle with respect to the upper arm , and a 5.0- kg mass is held in the hand. The total mass of the forearm and hand is 3.0 kg, and their center of mass is 15.0 cm from the elbow. (a) What is the magnitude of the force that the biceps muscle exerts on the forearm for =60 ? (b) What is the magnitude of the force on the elbow joint for the same angle? (c) How do these forces depend on the angle ?
The light boom AB is attached to a vertical wall by a ball and socket joint at A and supported by two cables at B. A force P is applied at B where P = 19i - 10j kN.Note that the reaction force at A acts along the boom because it is a two-force member. Magnitude of the reaction force at A in kN = 34.8 Calculate the magnitude of the tension in cable BD in kN
02: The cylinder A weighs 450 N and it is supported by the vertical smooth wall and the cable system as shown in figure, 1) Find the tension in cable AC 3 D 12 5 B.
A non-uniform rod of length 1.00 m is hung horizontally, supported by strings on bothends. If the center of gravity of the rod is 0.200 m from the left end, what is themagnitude of the tension applied by the string on the right end of the rod? A. 50% of the weight of the rod B. Cannot be determined unless the weight of the rod is given C. 80% of the weight of the rod D.20% of the weight of the rod
HER A man holds a 175-N ball in his hand, with the forearm horizontal (see the drawing). He can support the ball in this position because of the flexor muscle force M, which is applied perpendicular to the forearm. The forearm weighs 21.4 N and has a center of gravity as indicated. Upper am bone Flexor muscle cing fc Elbow joint 89) 00510 m r 0.0890 m 0.330 m- (a) Find the magnitude of M 1149 X N (b) Find the magnitude and direction of the force applied by the upper arm bone to the forearm at the elbow joint. magnitude direction downward Additional Materials Book ??TO MacBook Ait 7.
SAQ 1.1 1. A nonuniform bar 2 m long is horizontal and is in a state of equilibrium when supported at the center. If it weighs 5 N locate its center of gravity. 4N 6 N
24.lf a walking stick with a mass of 300 g can be balanced by placing a mass M of g at a distance L of 40 cm from the fulcrum, then the center of gravity of the 150 stick is cm away from the fulcrum.
The uniform bar with end rollers weighs 85 lb and is supported by the horizontal and vertical surfaces and by the wire AC. Calculate the tension Tin the wire and the reactions against the rollers at A and at B. 1.9' B 3.5' A 4.1' Answers: T= i 82.3 Ib A = i 19.5 Ib В - i 49.8 Ib Save for Later Last saved 4 days ago. Attempts: 0 of 1 used Submit Answer Saved work will be auto-submitted on the due date. Auto- submission can take up to 10 minutes.
A 195-kg load is hung on a wire of length of 3.40 m, cross-sectional area 2.00 x 10-5 m², and Young's modulus 8.00 x 1010 N/m2. What is its increase in length? m Need Help? Read It Master It