Answered: A 3-phase, 6-pole induction motor con-…

A 3-phase, 6-pole induction motor con- nected to a 50 Hz supply runs at 975 rpm on full load. Its full-load slip is (a) 25% (c) 2.5% (b) 1.5% (d) 2.0%

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter32: Three-phase Motors

Section: Chapter Questions

Problem 6RQ: Name three factors that determine the torque produced by an induction motor.

See similar textbooks

Related questions

Q: A 400V, 3-phase Induction motor has input power of 14 KW and operates at power factor of 0.87…

A: Given data, A 400 V, 3-phase induction motor has Pin=14 kWcosϕ=0.87 laggingη=86% Two wattmeter…

Q: . The expression of an AM modulated wave (DSB-LC) is: , vAM(t)=[5+ 4sin(3000π t)]sin(1x10^6π t) a)…

Q: An initially relaxed RC circuit with R = 2 M and C = 1 µF is switched on to a step voltage of 10V.…

Q: 5-17. For a rectangular waveguide with a wall separation of 2.5 cm and a desired frequency of op-…

A: Given parameters : Wall separation in the waveguide, a - 2.5 cm Desired frequency, f = 7 GHz Here we…

Q: When Inverters are used as the input to a NAND gate, the circuit performs what logic function? When…

A: NAND and NOR gates are the universal gates, using the NAND and NOR any gate can be implemented. Let…

Q: Consider the LTI system: To x(t) y(t) = Determine the impulse response of this system. e-(t-T)…

Q: 15-21. Determine the effective isotropic radiated power for an antenna with a power gain A, = 26 dB…

Q: system which consist of two power plants, the incremental cost in GHC/MWhr are dC₁ dP -= 0.17 P₁ +…

A: Given data : The given incremental cost , dC1dP1=0.17P1+140dC2dP2=0.24P2+185 The system operates…

Q: disadvantages of potential transformer.

A: Potential transformers, which drop a circuit's voltage to a lower voltage for measurement, are also…

Q: (a) What is the advantage of using MOSFET as compared to BJT at the first stage of multi-stage…

A: Since you have posted a question with multiple subparts and all the subparts are different, hence,…

Q: 2) Determine the value of R for the circuit below that will result in a diode current of 10mA if…

A: Given, The circuit is, Diode current, ID=10 mA Supply, E=7 V

Q: Determine the voltage and current meter indications in each circuit.

Q: ww 452 gaison 48veqa Dierovin + 10i с ww 252 Figure 1 Find the open circuit (open across a-b)…

A: Given circuit:

Q: le (mA) VCE -7.5 V Vcc=24V Rc {2.5 k Re 1.Sk 90 μ.Χ. 10 80 µA 70 μ.Χ. 60 μA 15 50 µA 25 µA 40 μA 30…

A: The characteristics shows are the output characteristics of CE configuration of a BJT. Q-point is…

Q: Consider the sinusoidal voltage v(t) = 80 cos (1000nt -30°) V. A. What is the maximum amplitude of…

A: Given, The sinusoidal voltage vt=80cos1000πt-30° V

Q: Q2 Minimize the following function using Boolean algebra: AB+ A(B+C) + B(B+C)

A: In this question we will minimize given boolean expression....

Q: Given u(t)=step(t) and h(t)=exp(-alpha t). a) perform convolution using different methods b) use…

Q: An infinite length wire carrying current 10A is positioned along the x-axis . a point is located…

A: By Amperes law , Magnetic field at a distance r from the line is given by uoI/(2*π*r) Also, the…

Q: A coil of resistance 20 Q and inductance 10 mH is in series with a capacitance and is supplied with…

A: Given a coil with a series RLC connection having, Resistance, R=20 Ω Inductance, L = 10 mH At the…

Q: Find v(t) for t>0. Assume the circuit is at steady-state before the switch closes. 60 V 352 ww 2 F…

A: Given here transient analysis problem and asked to find the voltage across the capacitor.

Q: Using Mesh analysis, find i3 in Amperes if Is = 2.44 A and R = 4.4 Ohms. Give answer in 3 decimal…

A: Given: Circuit diagram:

Q: 4. Which of the following is the correct relationship between temperature (T) and mobility (u) of…

A: The correct option along with the explanation is provided in the following section.

Q: 12-17. Determine the frequencies for electromagnetic waves with the following wavelengths: 5 c 50…

Q: Write the 2nd order differential equation of v₁. What should be the value of R (R>0) for this…

A: Solution is attached with this notes. Thank you.

Q: Derive the formula for admittance and draw the current triangle and admittance triangle for parallel…

A: Explanation is given in step -2

Q: For the circuit shown below calculate I and Iz. 1.5 ΚΩ 5.1 V ß = 200 ' 1.2 ΚΩ -12 V

A: Given circuit,

Q: ● Pay special attention to the role and operation of the horn relay. Learn how to measure voltage…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Q3.A. A TV station is transmitting 10 kW of power with a gain of 15 dB towards a particular…

A: We need to find out electric field at given point due given power

Q: The Zener regulator circuit in Figure Q1 has the following values: R₁ = 0.22 kn, Zener voltage, V₂ =…

A: Given: RL=0.22 k ohm Vz = 8 Volt Maximum power rating of the Zener diode = 400 mW In order to…

Q: 2. In a certain magnetic field the cross- sectional area is 0.5 m² and the flux is 1, 500 Wb. What…

A: Given, In a certain magnetic field, The cross sectional area, A=0.5 m2 Flux, ϕ=1500 μWb

Q: 3. The radar in which both transmission and reception is done using the same antenna are called:

A: The correct option along with the explanation is provided in the following section.

Q: Find i(t) for t>0. 8 V + x=0 t = 0 1Ω 1 H ²|=2F 252 2 H 1 F

Q: f) For the circuit shown, determine i, and i2. 20 mA www. 6 ΚΩ www ΑΚΩ

A: Given circuit,

Q: Use the diagram below for questions 11-17 12V 22 11. If current flow at point F is 3 amps and…

Q: 9. Which of the following equation represents mass semiconductors in electronic circuits? action law…

A: The correct option along with the explanation is provided in the following section.

Q: If the kinetic energy of a body about an axis is 9J and the moment of inertia is 2kg- m², then the…

A: Given data, Kinetic energy of rotating body KE=9 J Moment of inertia I=2 kg-m2

Q: An electric motor that runs at 3/4 of its full- load potential of 200 amperes is operating at which…

A: Given data, Full load potential Ifl=200 A Operating potential is given 34 times of full load…

Q: 1. Which of the following is not an electronic device? a) A mobile b) A computer c) A magnifying…

A: mobile , keyboard and computer are design by semiconductor devices like BJT ,MOSFET, Amplifier .

Q: A series RC circuit consists of a 2MQ-resistor and an uncharged capacitor, C=5μF. The circuit is…

A: Given here the data related to the RC series circuit and asked to find the voltage across the…

Q: If the vector R = 17.41 ap+ 16.83 a +5.13 az at (3.24, 357.37 degrees, 2.80) in cylindrical…

Q: Two separate but nearby coils are mounted along the sameaxis. A power supply controls the flow of…

A: Given: Two separate but nearby coils are mounted along the sameaxis. A power supply controls the…

Q: 3. The radar in which both transmission and reception is done using the same antenna are called:

A: The correct option along with the explanation is provided in the following section.

Q: 54 For the JFET Common-gate configuration below, determine its input and output impedance the…

Q: 7. A series RL circuit has a KVL equation of E=L di/dt + Ri where E-supply voltage (200V),…

Q: Find the reactance of a 0.45 H inductor at 60 Hz frequency. At what frequency is the reactance 500…

Q: 12-14. Using TDR, a transmission-line impairment is located 2500 m from the source. For a veloc ity…

A: The electromagnetic wave that is moving via the transmission lines is simply a combination of an…

Q: Two equal charges are released in a uniform magnetic field, one static and the other moving at a…

Q: 15-20. Determine the power gain in decibels for an antenna with a directive gain D = 50 dB and an…

A: Given directive gain D= 50 db and efficiency = 75% and asked to find the power gain.

Q: The above diagram represents a balanced Y-impedance load with the neutral grounded through some…

A: For star connected load, we have to draw Positive, negative and zero sequence network diagram when…

Q: Two uniform spherical charge distributions (see figure below) each have a total charge of 28.1 mC…

A: Given data,

Concept explainers

Three Phase Induction Motor

The induction motor is an electric motor that runs on AC (alternating current) and it is of two type single phase motor that work on single-phase power supply and three-phase motor that work on three-phase power supply.

Question

A 3-phase, 6-pole induction motor con-
nected to a 50 Hz supply runs at 975 rpm
on full load. Its full-load slip is
(a) 25%
(c) 2.5%
(b) 1.5%
(d) 2.0%

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

1. The operation of Commutator in DC Motor is * O a) to convert dc to ac O b) to convert ac to dc O c) to convert fixed dc to variable dc O reverse the current direction in the rotating windings each half turn
At standstill condition , the slip of induction motor is 1. Select one: O True O False
A 12-pole induction motor has a frequency of 60 Hz. Its synchronous speed would be: (a) 600 rpm (b) 480 rpm (c) 660 rpm (d) 500 rpm
6- Which of the following supply is given to the rotor winding of 3-Phase Induction Motor: a) DC Supply b) AC Supply c) No Supply d) Pulsating Supply 7- 3-Phase Induction Motor will have Starting Torque and Starting Current a) High, High b) Low, Low. c) High, Low d) Low, High 8- Which of the following method is used for controlling the speed of an induction motor: a) Changing number of stator poles b) Supply voltage control c) Frequency control d) All the options are correct 9- Which of the following method cannot be used for starting of 3-Phase Squirrel Induction Motor: a) Star-Delta Starting b) Line resistor startling c) transformer Starter d) Rotor Resistance Starting 10- The rotor of a stepper motor has no: a) windings b) commutator c) brushes d) all of the above
A 3-phase induction motor has a starting torque 100% and a maximum torque of 200% of the full load toque. Find the slip at maximum torque. Answer: 26.8%
Discuss the following statements briefly 1. Adding auxiliary winding in single phase induction motors. The starting capacitor of a capacitor start capacitor run induction motor is 100 µF while the running capacitor is 14 µF.
The starting torque of slip ring induction motor is High Negligible Medium O Low
3.8 An induction motor having 8 poles runs at 727.5 rpm. If the supply frequency is 50 Hz, the emf in the rotor will have a frequency of (a) 1.5 Hz (b) 48.5 Hz (c) 51.5 Hz (d) 75 Hz
If a 4-pole induction motor has a synchro- nous speed of 1500 r.p.m., then, supply fre- quency is (1) 50 Hz 60 Hz (iii) (ii) 25 Hz (iv) none of the above
In 3 phase induction motor the greater number of poles give.. * speed high O Medium Low
At rest condition, the slip of induction motor is 1. Select one: O True False
In a single phase AC capacitor start and run induction motor, to make the rotation in anti-clockwise direction, the capacitor is connected in a. series with running coil b. parallel with starting coil c. series with starting coil d. parallel with running coil