9- If supply voltage is 1500 V and total current drawn by motors is 1300 A, calculate: a- Power taken by motors in KW:

Q: A continuous signal x(t) is 2 seconds long. The first second of the signal contains music while the…

A: SOLUTION GIVEN-->                 x(t) is 2 sec long.…

Q: EIRP Calculations 8) Consider a wireless transmitter that has an antenna gain of 5 dBi. Calculate…

A: For Q.8: Antenna Gain=5dBi RF power fed=27 dBm EIRP=?   For Q.9: EIRP<36dBm RF power Fed= 27 dBm…

Q: What is the Cartesian representation of z = 460/135°? O a. z = -325.27-j325.27 O b.…

A: Given  Impedance in polar form z = 460∠135° Asked to represent in the Cartesian (Rectangular) form

Q: Write two factors which justify the need of modulating a low frequency signal into high frequencies…

A: Modulations- It is carrying a signal having information from transmitter to receiver by imposing it…

Q: 7. The main purpose of the commutator in a DC Generator is to a. provide smoother output c. convert…

A:

Q: Wavelength division multiplexing, to put it briefly.

A: Wavelength division multiplexing:- A fiber-optic transmission method called wavelength division…

Q: Q2: Draw the output waveforms (S, X, and Y) for the below sequential circuit by assuming the…

A:

Q: alculate the effective resistance of the following combination of resistance and the voltage drop…

A:

Q: Calculate the core and window areas required for a 1100 kVA, 6600/400 V, 50 Hz, single pahse core…

A:

Q: *40. Design a clamper to perform the function indicated in Fig. 2.184. 20 V -20 V Ideal diodes…

A:

Q: OV 50Hz 10 кг louF calculate Va VAK = 0 VGK=0 IH = 0

A: The given circuit is RC firing circuit of half wave rectifier.

Q: A transformer has a rated output of 300 kVA at a power factor of 0.6. Determine the rated power…

A: As per the question, it is given that Rated output (S) = 300 kVA Power factor ϕ= 0.6 We have to find…

Q: Which bulb operates on lowest power?   A) Night bulb B) Torch bulb C) Neon bulb D) GLS bulb

A: Bulb:- Bulbs provide light from the electricity by passing a current through the thin wire which is…

Q: Ideal voltage source should have • zero internal resistance O • infinite internal resistance O •…

A:

Q: 2. Why do we need to have an Exciter in a complete set-up of an Alternator system operations?…

A:

Q: Using nodal analysis, Vo in circuit Select one: O O a. -8 v b. 24 v c. -24 v d. 8 v j6Ω 4/90° A V₂…

A: Given, The circuit is,

Q: Q6. Determine the total amount of power in the series circuit in Fig. 592 50 V 292 I + I 192 292

A: Given data, Circuit diagram is given as,

Q: Find the current (1) using superposition.

A:

Q: At w=0, a capacitor can be treated as a short circuit, and at w = ∞o, a capacitor can be treated as…

A: We need to tell about whether the given statement is or false

Q: A battery of unknown e.m.f. is connected across resistances as shown in Fig. 2.26. The voltage drop…

A: We have a circuit as shown in figure .   We have been asked to find the reading of the ammeter means…

Q: ● How are 500 Q resistors connect so as to give an effecti ?resistance of 750 Three resistors of 500…

A:

Q: A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its…

A: For Capacitor, Capacitive Reactance, Xc=40 and f=50Hz  For series RL circuit, VR=12V and  VL=5V

Q: A coil of inductance 318.3 mH and neg[1]ligible resistance is connected in series with a 200…

A: Given that The coil has inductance L=318.3 mH and negligible resistance RC=0 ohm. Series resistor…

Q: A transformer has a rated output of 300 kVA at a power factor of 1.2. Determine the rated power…

A: Please comment if you need any clarification. If you find my answer useful please put thumbs up.…

Q: Ⓒ which of the following signals are periodic I Find the period of the periodic ones: (a) x[n] = 2…

A: To find the period signals and it's period

Q: Task III: You were asked to evaluate the efficiency of a 5.5 kW motor that operates on a constant…

A: According to the question. The motor operates at a constant load. Output voltage, V0 = 380 Output…

Q: B) Find the response to an input signal (step function) applied on the 2nd order equation y"+c₁y' +…

A:

Q: A 4 pole, 220 V d.c. shunt motor, lap wound has 960 conductors. The flux per pole is 20 mWb.…

A: We have a DC shunt motor having, Pole (P) = 4  Voltage (V) = 220 V Lap conductor (Z) = 960  Flux per…

Q: Represent v(t) = 350 cos(250t +150°) - 280 сos(2л5оt -30°) V by a single sinusoid. O a. v(t) = 630…

A: We need to simply the given function

Q: step-down transformer having a turns ratio of 20:1 has a primary voltage of 4 kV and a load of 10…

A: We need to find out secondary side current for given transformer

Q: 6. Hysteresis loss depends upon_ a. the volume and grade of iron c. frequency of magnetic reversals…

A:

Q: 12v+ what is the value of the unknown resistor R in fig. if the voltage drop across the 5000…

A:

Q: Q1. Choose the right option for the following. [ 1. If a DC voltage is applied to a DC motor, then,…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Let v₁(t) = 5 cos(271000t) V and v₂(t) = 5 cos(271000t - 1359) V. Notice that v₂(t) is a delayed…

A:

Q: . (A)-Create an 8086 Assembly language program that subtracts two 8-bit ASCII numbers, the first and…

A: Given: 8086 Assembly language program to subtract two 8 bit ASCII numbers. Two 8-bit ASCII numbers…

Q: Q2: Draw the output waveforms (S, X, and Y) for the below sequential circuit by assuming the…

A:

Q: 4 Find the F.T. of the following Signals using differentiation prop. <<-2 2 +t 4 (sin² (w) - 2 Sinc…

A:

Q: (2) Find the energy (a) X[n] = sin() (b) x[n]= π/2 (e) (c) x[n] = ()u[n] (d) x[²4] = {" x[^] = and 1…

A: Energy signals are those whose amplitude tends to zero as time tends to infinity.  Power signals are…

Q: Jor 30V 北 经 卡 北 V₂ V1=6, V2=2,V3=0O

A:

Q: In a 3-phase, 4-wire, 400/230 V system, a lamp of 200 watts is connected to one phase and neutral…

A: We have a 3-phase 3-wire system in which 2 lamps are connected between 2 phase and neutral . We have…

Q: Let R₁ = 16 N, R₂ = 27, R₂ = 38 N, Zc = -135, and Z₁ =j56 in the circuit shown in Figure 9.30. Find…

A:

Q: Q5) Use superposition to find v, in the circuit of Fig. 5. 2 A 10 2 8 Ω ww 4 A Figure 5 12 V 592 www

A:

Q: Calculate the actual sag and vertical sag from the following information  Weight of conductor = 0.9…

A:

Q: The peak voltage rating of the transformer secondary for a voltage doubler that produces an output…

A:

Q: Q5: An output pulse of 3 ms duration is to be generated by a 74LS122 one-shot. Using a capacitor of…

A: Given Data pulse width = 3 msec = 3*10-3 sec External Capacitor value = 50000 pF=5*10-8 F External…

Q: A coil of inductance 318.3 mH and negligible resistance is connected in series with a 200 resistor…

A: Inductance (L) = 318.3 mH Resistance (R) = 200 Ω Frequency (f) = 50 Hz Voltage (V) = 240V We have to…

Q: Ideal current sources have • zero internal resistance O • infinite internal resistance O • low value…

A:

Q: The transfer function of a series RLC bandstop filter is given by 1 LC H(o)= -0² +₁ 1 LC At…

A: We need to tell about phase of given transfer function

Q: Determine the main dimensions of 40 kW, 3 phase, 400 V, 50 Hz, 1440 rpm squirrel cage induction…

A:

Q: Calculate the junction capacitance of a silicon pn junction at T = 300 K with doping concentrations…

A:

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.