7) The homogeneity of the chloride level in a water sample from a lake was tested by an analyst. Below are the concentration in parts per million (ppm) of Cl: 27.32, 27.22, 27.21, 27.24, 27.20 i. Determine the mean and median. ii. Calculate the confidence limit at 90%. iii. Identify a possible outlier and use the Q-test to determine whether it can be retained or rejected at 90% confidence level

7) The homogeneity of the chloride level in a water sample from a lake was tested by an analyst. Below are the concentration in parts per million (ppm) of Cl: 27.32, 27.22, 27.21, 27.24, 27.20 i. Determine the mean and median. ii. Calculate the confidence limit at 90%. iii. Identify a possible outlier and use the Q-test to determine whether it can be retained or rejected at 90% confidence level

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter7: Statistical Data Treatment And Evaluation

Section: Chapter Questions

Problem 7.21QAP

See similar textbooks

Similar questions

Patients undergoing an upper gastrointestinal tract laboratory test are typically given an X-ray contrast agent that aids with the radiologic imaging of the anatomy. One such contrast agent is sodium diatrizoate, a nonvolatile water-soluble compound. A 0.378-m solution is prepared by dissolving 38.4 g sodium diatrizoate (NaDTZ) in.l.60 102 mL water at 3 1.2C (the density of water at 31.2C is 0.995 g/cm3). What is the molar mass of sodium diatrizoate? What is the vapor pressure of this solution if the vapor pressure of pure water at 31.2C is 34.1 torr?
A 5.04 g sample of a solid containing Ni is dissolved in 20.0 mL water. A 5.00 mL aliquot of this solution is diluted to 100.0 mL and analyzed in the lab. The analyzed solution was determined to contain 5.53 ppm Ni. Determine the molar concentration of Ni in the 20.0 mL solution. concentration: M Determine the mass, in grams, of Ni in the original sample. mass: g Determine the weight percent of Ni in the sample. weight percent: % * TOOLS x10
Density of solution:Trial 1: 1.2 g/mLTrial 2: 1.2 g/mLTrial 3: 1.2 g/mL Average density = 1.2 g/mL What is the relative average deviaion, %?
= 209; S =32 ). What is the solubility of Bi2S3 in g/L (At. Mass: Bi = Ksp Bi2S3= 1.6 x 10-72 Answer format: 1.00x10-14 (Don't put the unit. Round-off your final answer in two decimal place)
Concentration of Acetic Acid in a Vinegar Solution. Average molarity of NaOH Volume HC₂H30₂ sample Final buret reading Initial buret reading Volume NaOH (Show all units and all calculations) Molarity of HC₂H30₂ (unrounded) Average molarity of HC₂H302 (unrounded) Deviations Average deviation Best estimate for molarity of HC₂H302 Average mass percent HC₂H302 46.4mL Oml Ran out of Base ↓ ↓ ↓ ↓ 10.014 HOA je beart giov isults weari?! ferottelucuny Cambia) 10 Kousad Question 1. A Rolaids tablet contains calcium carbonate that neutralizes stomach acid. If 44.55 mL of 0.448 M hydrochloric acid is required to neutralize one tablet, how many milligrams of calcium carbonate are in a Rolaids tablet? CaCO, (s) + 2HCl(aq) → CaCl₂ (aq) + H₂O (1) + CO₂ (g)
Should be 3 answers in total. Will thumbs up! Next the student conducts two different runs: In RUN 1, 10.0 mL of 5.00 M NAOH is combined with 10.0 mL of 0.010 M CO and 80.0 mL of wate In RUN 2, 20.0 mL of 5.00 M NAOH is combined with 10.0 mL of 0.010 M CO and 70.0 mL of wate The following plots were obtained for each of the runs: [crystal orange] vs time (RUN 1) In[crystal orange] vs time (RUN 1) 0.0012 0.001 -2 y--0.4463x- 7.3334 y =-0.0002x + 0.0007 R- 0.6565 R = 0.893 0.0008 4 0.0006 -6 0.0004 -8 0.0002 0.0002 -12 time (hr) time (hr) 1/[crystal orange] vs time (RUN 1) 1/[crystal orange] vs time (RUN 2) 12000 25000 10000 20000 8000 15000 6000 y = 2000x + 1000 R =1 10000 y 4000x + 1000 R =1 4000 2000 5000 time (hr) time (hr) Figure 4. Kinetic traces for the reaction between crystal orange and sodium hydroxide. What is the order with respect to CO? | Select ] What is the order with respect to NaOH? | Select ] What is the value of the averaged rate constant for the reaction above? Give…
Standardization of a sodium hydroxide (NaOH) solution against potassium hydrogen phthalate (KHP) yielded the following results: Mass of KHP, g Volume of NaOH, mL 0.7987 38.29 0.8365 38.96 0.8104 38.51 0.8039 38.29 MM KHP: 204.22 MM NaOH: 40.00 a. Calculate the mean molar concentration of sodium hydroxide. (First, compute the concentration of NAOH in each titration then compute for its mean/average value.) b. Calculate the standard deviation. Please provide solutions for your answers. If you have used your calculator for calculating for mean and standard deviation, you can just provide the formula with the values indicated.
A sample (50 mL) of a bottled water was added to a 100 mL volumetric flask and then diluted to the mark. From this stock solution, 50 mL was taken, added to a 100 mL volumetric flask and diluted to the mark. Final concentration of the serial dilution: 587.7161ppm. 1. what is the concentration in the original bottle (ppm)
1. A solution is known to contain 38.04 ± 0.03 mM KCl, and you have taken an aliquot of this solution using a pipette calibrated to deliver 20.013 ±0.006 mL. Determine the number of moles of KCl that are delivered in the aliquot, including the absolute uncertainly in that value. 2. You deliver the aliquot taken in problem 1 into a volumetric flask with a volume of 250.00 mL ± 0.02 % and dilute the solution to volume in the flask using Dl water. What is the concentration of KCl in this flask, report your answer with the absolute uncertainty. 3. Tabulated below are replicate titration volumes for an analysis. What is the error (both absolute and percent) for the average titration volume?
4. A fat sample with combination of acids contain standard hydrochloric acid for blank and sample with 8mL and 5mL respectively. The normality of the standard hydrochloric acid is 0.93N and the weight of the sample is 3 grams. Calculate the saponification value.
1. 500.0 mL 0.2 M KI2. 500.0 mL 0.2 M KCl3. 500.0 mL 0.1 M K2S2O84. 500.0 mL 0.1 M K2SO45. 500.0 mL 4.0 mM Na2S2O3 (from Na2S2O3∙5H2O)pls compelete the 2nd table given the data
A 0.1475-M solution of Ba(OH)2 was used to titrate the acetic acid (60.05 g/mol) in a dilute aqueous solution. The following results were obtained. (See attached image)(a) Calculate the mean w/v percentage of acetic acid in the sample.(b) Calculate the standard deviation for the results.(c) Calculate the 90% confidence interval for the mean.(d) (d) At the 90% confidence level, could any of the results be discarded?