6. Say you are trying to separate two compounds by column chromatography. You run a column and collect the eluent in five fractions. You analyze each fraction by TLC on the same plate (shown below). Based on the TLC plate, how effective was your separation? ••• ---1----1-- 1 2 3 4 5

6. Say you are trying to separate two compounds by column chromatography. You run a column and collect the eluent in five fractions. You analyze each fraction by TLC on the same plate (shown below). Based on the TLC plate, how effective was your separation? ••• ---1----1-- 1 2 3 4 5

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter34: Miscellaneous Separation Methods

Section: Chapter Questions

Problem 34.1QAP

See similar textbooks

Related questions

Q: A chromatographic analysis is performed with a sample containing toluene and benzene. The column…

Q: The following four compounds are present in a mixture. You want to separate them using reverse-phase…

A: Order of elution First 4, then 1, then 2, lastly 3. Justification. As reverse-phase liquid…

Q: Prelaboratory Assignment for Paper Chromatography 0 The 1 SAYIY

A: Note : Compound A is more soluble in mobile phase. Therefore compound A is less polar and having…

Q: Muna Al Naabi in the Analytical chemistry laboratory wanted to separate chlorophenol by liquid…

A: LIQUID CHROMATOGRAPHY(LC): An analytical technique which is used to isolate a chemical sample into…

Q: 4. On a 20 cm paper chromatography plate, an analyte was spotted 1 cm from the bottom edge. The…

Q: The identity and ratio of solvents are necessary in chromatography for achieving a good separation.…

A: if your solvent had an overly polar TLC developer then all the components of the mixture will move…

Q: Chromatographic analysis using gas-liquid chromatography with a 40-cm packed column gave the…

A: Given, Compound Retention time, min…

Q: 16 A 14E 12 10 4 10 20 30 40 Time, min 50 60 70 A chromatogram of a two-component mixture Detector…

A: Since we only answer up to 3 sub-parts, we will answer the first 3.Please resubmit the question and…

Q: A chromatogram from a certain column has a peak with a w1/ 2 of 12 mm and a tr of 650 mm as…

A: Given, Width of half peak height , w12= 12 mm retention time , tr = 650 mm

Q: Which statements are true for molecular exclusion chromatography? I Molecular exclusion…

A: Molecular sieve chromatography, is a chromatographic process that separates molecules in solution…

Q: How many theoretical plates produce a chromatography peak eluting at 12.83 min with a width at…

A: The no. of theoretical plates can be calculated as: Where N is the no. of theoretical plates, tr is…

Q: mixture of three components is separated using paper chromatography, and each component is analyzed…

A: Given: Absorbance of standard solution- Compound A = 0.72 Compound B = 0.55 Compound C = 0.80 For…

Q: 2. A TIc plate was run on the fractions (#1-4) collected from a silica gravity column chromatography…

Q: A chromatogram gives an ideal Gaussian peak with tr = 8.70 min and win = 0.19 min. How many…

A: 1. The number of theoretical plates (N) = 11616 2. The plate height of the column (H) = 0.00938 mm

Q: 2. A Tlc plate was run on the fractions (#1-4) collected from a silica gravity column chromatography…

A: According to the company guidelines, we have to answer the first question only. So, please kindly…

Q: 16. In this chromatographic technique the mobile should consists of buffer solution or with known…

A: The mobile phase of Ion Exchange Chromatography (IEC) is usually a buffer solution or a pH known…

Q: In a gas chromatographic run, anthracene peak was eluted at 7.50 min. The adjusted retention time of…

A: Hii there, As there are multiple question posted. we are answering first question. If you need…

Q: Consider the peaks for heptane (14.56 min) and p-difluorobenzene (14.77 min) in the chromatogram.…

A: a.

Q: Analysis of an unknown plant extract yield two peaks X and Y in a chromatogram, 15.65 and 17.03 min…

Q: 2. a) What is a bonded phase in HPLC? b) Give an example of a bonded phase in reversed-phase liquid…

A: Bonded Phase is the compound that is directly attached to the stationary phase in the liquid…

Q: When the use of 2D Thin layer Chromatography is better than normal TLC? Please shortly answer at…

Q: A student researcher performed a chromatographic separation of caffeine and aspartame with methanol…

A: Given, retention time for methanol (tm) = 27.9 sec retention time for caffeine (tc) = 95.0 sec…

Q: (6)(Inorganic) In an ion exchange chromatography column, based on sulfonate groups, as shown in…

A: The anions are produced by the removal of hydrogen ion (H+) from a neutral compound such as…

Q: Which substance is best to run the column chromatography? a)The solvent that is very polar B)The…

Q: 7] Which of the following are necessary steps in performing paper chromatography? I. Saturate…

Q: Olivia developed a new dye called Dye C. It was analyzed against other dyes using paper…

Q: The following data were obtained by gas-liquid chromatography on a 40-cm packed column: Compound tr,…

A: To solve this problem, we will need the following relations regarding gas-liquid chromatography : 1.…

Q: 19. What is thin layer chromatography (TLC) LEAST useful for from the list below? A) To determine if…

A: "Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: SFC combines important advantages of gas and liquid chromatography. It is especially useful for…

A: The chromatography is the separation technique used for identification and separation of compounds…

Q: 1- What are the main two types of columns in the HPLC? 2-What are the most disadvantages of…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Rank the following compounds in terms of decreasing theoretical retention factors if a reverse-phase…

A: Reverse-phase chromatography is a chromatographic technic in which the stationary phase is…

Q: i) Determine the adjusted retention times for substance x and y. ii) Calculate the retention factors…

A: Since you have asked a question with multiple subparts, we will answer first three subparts for you.…

Q: A student used thin layer chromatography to confirm whether he could successfully separate two…

A: TLC means “Thin Layer Chromatography”. This experiment is done on Wattman paper. If the molecule has…

Q: An analysis of acid mixture was conducted using reversed-phase liquid chromatography with 20 mL/min…

A: Column length (L) = 10 cm Flow rate (r) = 20 mL/min Retention time of Y (tR,Y) = 4.4 min Width of Y…

Q: What are the quantification methods for supercritical fluid chromatography?

A: Interpretation- To give all the quantification methods for supercritical fluid chromatography -…

Q: If retention times found on a chromatogram are 0.60 min for CH4 (=tm), 7.0 min for pentane, 8.0 min…

A: We use the formula below to find Kovat's retention index(I): Kovat's retention index, I = 100*n +…

Q: A chromatography column with a length of 10.3 cm and inner diameter of 4.61 mm is packed with a…

Q: Ms. Muna Al Naabi in the Analytical chemistry laboratory wanted to separate chlorophenol by liquid…

A: Number of theoretical plates and plate height can be calculated using respective formulas.

Q: 1. What would be the effect of the following errors in chromatographic work? a. Damaged silica gel…

Q: Calculate the separation factor (or selectivity factor), between two compounds, 1 and 2, whose…

A: The selectivity factor (α) of a column for two analytes A and B where A eluting before B is given…

Q: Sample contains (A, B, C, D) analyzed by thin layer chromatography using solvent system X the result…

A: Thin-layer chromatography has two phases a stationary phase and a mobile phase. The silica gel…

Q: chromatogram below show a separation of a mixture of 2 components injected in a 25

A: The separation technique in which the liquid is a mobile phase where the molecules and sample ions…

Q: A chromatogram of a two-component mixture on a 25-cm packed LC column is shown in the figure below.…

Q: 4. a. What physical property of a compound predicts whether that compound travels slowly or rapidly…

A: Gas chromatography is an analytical method to separate the components of a mixture in a sample by…

Q: In a chromatographic analysis of an unknown mixture, compound A has a retention time of 5.56 minutes…

Q: A mixture of three components is separated using paper chromatography, and each component is…

A: Given: Absorbance of standard solution- Compound A = 0.72 Compound B = 0.55 Compound C = 0.80 For…

Q: A TLC plate showed two spots A and B with Rf 0.20 and 0.30, respectively. Sketch a TLC chromatogram…

A: Sketch of TLC chromatogram: TLC plate = 10cm

Q: Suppose you are trying to separate a mixture of compounds using reversed-phase liquid chromatography…

A: In RPLC for better resolution eluent strength of the mobile phase should decrease to increase the…

Q: 12. A standard solution with known concentrations of tartaric acid and fumaric acid was prepared and…

Q: All chromatographic techniques can be used as separation methods. True O False

Question

6. Say you are trying to separate two compounds by column chromatography. You run a column
and collect the eluent in five fractions. You analyze each fraction by TLC on the same plate
(shown below). Based on the TLC plate, how effective was your separation?
-------1---
1 2 3 4 5

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Trending now

This is a popular solution!

Step by step

Solved in 5 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

How can the selectivity factor be manipulated in (a) GC and (b) LC?
a. Say you are trying to separate two compounds by column chromatography. You run a column and collect the eluent in five fractions. You analyze each fraction by TLC on the same plate (shown below). Based on the TLC plate, how effective was your separation? Consider the purity of each fraction. - - - - - - - - ----| 1 2 3 4 5
Qno1: why there is a need of chromatography and chromatography thecniqs. B) when and where we should use normal and reverse phase chromatography
In molecular exclusion (size exclusion) chromatography, the molecules have the longest retention times. a) the larger molecules b) the smaller molecules
what is chromatography? Explain different types of chromatography and explain how to seperate compounds. indicate stationary phase mobile phase.
A GC-MS was used to analyze an unknown sample. Based off the chromatogram, at least how many different compounds were in this sample? Detector Signal u M Retention Time
Which statement(s) are correct for gas chromatography? A) the components in a mixture can be identified from their retention time. B) the relative peak areas give the proportions of components in a mixture. C) Calibration curves are used to confirms the concentrations of components in a mixture.
You spotted a mixture of three compounds, labeled A-C, on a silica plate. The resulting thin layer chromatography (TLC) plate with a mobile solvent mixture of 95 % hexanes and 5 % ethyl acetate is shown below. Which of the spots traveled the furthest up the TLC plate corresponding to spot 3?
In all forms of chromatography, there is a mobile phase and a stationary phase. In thin layer chromatography what is the stationary phase?
QUESTION 5 In a chromatographic separation using a polar stationary phase and a mobile phase composed of 60% hexane and 40% ethyl acetate, two compounds, benzene (peak A) and toluene (peak B), are eluted. The width of peak A at its base is 1.2 min, the width of peak B at its base is 1.3 min, and the retention time of peak A is 5.2 min and peak B is 3.5 min. What is the resolution (Rs) between these two peaks and is it acceptable? R = 1.36. It is not an acceptable resolution. R = 0.74. It is an acceptable resolution. R = 1.36. It is an acceptable resolution. R = 0.74. It is not an acceptable resolution.