4g 5 g 2 g 100 g 49." R Lactic acid Salicylic acid Trichloroacetic acid Flexible collodion qs ad Sig: wart remover. Use as directed. (a) Flexible collodion contains 20% w/w camphor and 30% w/w castor oil. How many grams of each would be contained in 30 g of the mixture? (b) The specific gravity of castor oil is 0.955. How many milliliters of the oil is contained in 30 g of the mixture? (c) If the specific gravity of the mixture is 0.781, what are the percent w/v con- centrations of lactic acid, salicylic acid, and trichloroacetic acid in the mixture?

Q: A 25 mL liquid bleach sample is diluted with water to 1000 mL in a bubble gel. 25 mL of the diluted…

A: The balanced chemical reactions are as follows: I- + OCl- + H2O = I2 + Cl- + 2OH- 2 Na2S2O3 + I2 =…

Q: Describe the preparation of the following reagents. 1. 250 mL of a solution that is 0.0376 N Mgl2…

A: (1)  Given that -  Volume of Magnesium iodide, Mgl2  solution = 250 mL  Normality of magnesium…

Q: 3. CRYSTALLIZATION Mix in a beaker 2g of benzoic acid and 10ml of dist. Water. Boil gently over a…

A: The crystallization and sublimation procedures for benzoic acid are given in experiments 3 and 4.

Q: Describe in words and by means of complete chemical equations, how a mixture of 1.25 g of benzoic…

A: Liquid- liquid extraction: This method is used to separate the mixture of two compounds according to…

Q: Describe the solution's preparation: i). 500 mL 0.250 M ethylene glycol (MW = 62.07) from a…

A: (i) from following formula -  Molarity = percentage×density×10/molar mass  Molarity =…

Q: 3. Calculate the mean-square end-to-end distance and root-mean-square radius of gyration of…

A: Given data: Characteristic ratio, C = 6.9 bond length, l = 0.12nm Formula used: Mean square…

Q: 4 g 5 g 28 100 g R Lactic acid Salicylic acid Trichloroacetic acid Flexible collodion qs ad Sig:…

A: Given, Mass of lactic acid = 4 gm Mass of salicylic acid = 5 gm Mass of tri chloroacetic acid = 2 gm…

Q: The petition coeficiente between benzene and water for carta iLife is approximately 3.9 .you are…

A: The given question employs the Nernst Distribution Law. The partition coefficient between the amount…

Q: If you have 6.76 g of caffeine dissolved in 57.2 mL of water and the extraction coefficient between…

A: Extraction is a technique by which a compound dissolved in a solvent is extracted into another…

Q: The Ksp values of two solid carbonates, A2CO3 and BCO3, were determined by preparing 250.0-mL…

A: Sparingly soluble salts are those that do not dissolve completely in solution rather maintain…

Q: The fat content of 10 g of commercial ice cream was determined by the Mojonnier method. The weights…

A: To calculate the percent of fat extracted during third extraction, we would first need to calculate…

Q: Vitamin C content in nutraceutical fomulation can be detemined by 2,6- dichloroindophenol…

A: Vitamin C is one of the water soluble vitamins. It is found in sour fruits and is important to…

Q: what is stationary phase and mobile pase in GC-MS in the practical to ideofu ths componentx in…

A: The components of vanilla and the mobile and the gas phase is given :

Q: True/False: While emulsions and microemulsions consist of the same 3 ingredients; aqueous phase, oil…

A: True.

Q: B. B. How many grams of glucose and of water are in 500g of a 5.3% by mass glucose solution ? 25M…

A: B. B. Given, Mass percent of glucose solution = 5.3% Mass of solution = 500 g Answer 4A.…

Q: You have to make 100mL of 0.05M HCI from a 10M HCI stock solution, but the only measuring devices…

A: Given that,  Molarity of Stock HCl solution M1 = 10 M Molarity of dilute HCl solution,M2  = 0.05 M…

Q: You were given a mixture of two miscible solvent A and B that you are tasked to separate. You know…

A: The mixture consist of two miscible solvent A and B which has different boiling points. Hence, the…

Q: You need to purify 0.8 grams of an impure sample of trans-cinnamic acid. After the purification is…

A: In the recrystallisation process of trans cinnamic Acid, A mixed solvent ethanol and water have to…

Q: 4 litres of water obtained from a borewell in Vellore contains FeSO4 = 30.4 mg; CaSO4 = 13.6 mg;…

A:

Q: . What is Chromatography? What kind of Chromatography did you use to separate food colors in this…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: You measured the melting point of the recrystallized product Ttal=142,2-145,5°C. Based on this…

A: Given that, Melting point of recrystallized product = 142.2℃ to 145.5℃ .

Q: 1. Why should the stopper always be removed from a separatory funnel whenever a liquid is being…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: During the chromatography the solvent may be changed from hexanes/ ethyl acetate (8:2) to hexanes/…

A: Given: Solvent system 1:   Hexane/Ethyl acetate (8:2)Solvent system 2:   Hexane/Ethyl acetate (4:6)…

Q: is 77.18%. The melting point range of crude benzoic acid = 112-119°C and the melting point range of…

A: The question is based on the results obtained after recrystallizing benzoic acid. the yields and…

Q: Tea leaves were boiled and around 1.00 gram of caffeine were extracted using 175.0 ml of water. if…

A: Given: Amount of caffeine=1 g Volume of caffeine solution=175 mL Portion of dichloromethane=20 mL…

Q: The following tests are used for control of organic impurities in organic medicinal substances,…

A: Option B is correct.

Q: Describe the preparation of 1100 mL of 6.00 M HNO, from the commercial reagent that is 91% HNO3(w/w)…

A: The volume of the required solution is = 1100 mL The molarity of the required solution is = 6.00 M…

Q: what are key reactions involved in seperation of liquid mixtures by simple and fractional…

A: Introduction: Chromatography and distillation is a technique used to separate the mixture of…

Q: Nitric acid samples were prepared by diluting the 68 w/v% high purity-grade or 61 w/v% electronic…

A: 68 % w/v means 68 g of HNO3 is present in 100 mL solution. Determination of no. of mol. of HNO3:…

Q: 1- To purify the mobile phase gas in GC we commonly use: a) IEC b) adsorption c) partition d) traps…

A: Note: Here you asked multiple questions in a image, So according to guidelines here is a solution to…

Q: The distribution ratio for X between n-hexane and water is 8.9. Calculate the concentration of X…

A:

Q: Imagine you are an organic chemistry student who isolates a crude sample of salicylic acid following…

A: The melting point is largely dependent on the impurities present in the substance. If there are…

Q: NH3 obtained when 0.5 g of an organic compound substance was subjected to Kjeldahl's method was…

A:

Q: Calculate the molarity of a Sulfuric acid reagent (98% w/w) with a specific gravity of 1.80.

A: Given,  Sulfuric acid reagent (98% w/w) with a specific gravity of 1.80

Q: Give the molar concentration of HCl with a specific gravity of 1.18 and has 37.0 % (w/w) purity. (

A: Give the molar concentration of HCl with a specific gravity of 1.18 and has 37.0 % (w/w) purity.

Q: Objective: To determine the percent NaCl (w/v) of a water sample 5.00 mL sample diluted to 50 mL…

A: Balanced chemical equation: NaCl (aq)  +  AgNO3 (aq)  ------>  NaNO3 (aq)  +  AgCl (s) From the…

Q: Principles of separation by capillary Isolachophoresis

A: Capillary isotachophoresis: Capillary Isotachophoresis  is a analytical chemistry technique which…

Q: Objective: To determine the percent NaCl (w/v) of a water sample 5.00 mL sample diluted to 50 mL…

A: The question is based on the concept of quantitative estimation. we have to calculate percentage…

Q: Starting Material mmol mL Methyl Salicylate 10.0 1.3 Weight m.p. (°C) 1.59 g 158-160 Product…

A: % Yield = 100 x mmol of salicylic acid/mmol of methyl salicylate Number of mmol = 1000 x Mass in…

Q: 6.0 mL of cyclohexanol, 8 mL of 85% phosphoric acid, and 10 drops of sulfuric acid are added to a…

A: The percentage yield can be calculated by the formula  = Actual yield x 100 /theoretical yield

Q: Fill out the Flow Scheme below. Obtain your ternary mixture and follow the steps on p. 2. in CH,Cl2…

A: 3 compounds need to be extracted. Benzoic acid Ethyl – p - aminobenzoate Naphthalene in…

Q: How efficient is the extraction of caffeine from tea leaves containing 1.0 g caffeine in 80 ml…

A: Caffeine is water soluble but so are some tannins and gallic acid which is formed in the process of…

Q: You are asked to manufacture 100 kg of polyester with a number-average molecular weight of 2000 by…

A: Polymerization is a chemical reaction in which the chemical compound of lower molecular link…

Q: Polar solutes were separated by HPLC (not HILIC) with a bonded phase containing polar diol…

A: The more polar the solvent, the greater the eluent strength on a polar column, and the shorter the…

Q: In 10 g of a PVC sample (Mw = 100,000; Mn = 70,000), you add 20 g another PVC sample with Mw 60,000,…

A: Polymers are extended chains, and huge organic molecules that are produced from multiple shorter…

Q: 1. A polymer consists of lkg of polyester with number-average molecular weight 10000g mol-1 is mixed…

A:

Q: An open tubular column with a diameter of 215 µm and a stationary phase thickness on the inner wall…

A: Given:-              diameter of open tubular column = 215 μm                      Unretained solute…

Q: Carboxylic acids, including fatty acids and benzoic acids, are often present in both municipal and…

A:

Q: C. A cube of dimensions 10 cm x 10 cm x 10 cm has mass of 1.90 Kg a water content w = 15%. The…

A: This question has multiple parts . As per the guidelines we are allowed to provide solution of…

Q: 11. What is the concentration of losartan in this suspension, in mg/mL? 12. An infant is prescribed…

A:

Q: set-up, e volatile acetc е аcet

A: Given data set: Mass of the empty flask = 351.44 g Mass of the heated flask = 355.02 g Thus, Mass of…

Q: If you have 6.61 g of caffeine dissolved in 72.3 mL of water and the extraction coefficient between…

A: The extraction coefficient can be described as the ratio of the concentration of the substance in…