4.0¹ concrete canoe 2. Calculate d, the submerged depth in water of the concrete canoe. The specific gravity of the canoe is 2.2. The canoe has a thickness of 3 inches on sides and bottom. Will the boat float?
Q: What is the precision measurement of 1 7/8 inch
A: PRECISION IS DEGREE TO WHICH REPEATED MEASUREMENTS UNDER THE SAME CONDITIONS SHOW THE SAME RESULTS.
Q: 3. The pipe ACDE is supported by ball-and-socket joints at A and E and by the wire DF. Determine the…
A: Given,
Q: If the specific volume of a gas is 360 ft3/slug, what is its specific weight (lb/ft3)?
A:
Q: A closed, rigid tank contains 1.50 kg of water, initially a two phase liquid-vapor mixture at T₁ =…
A: Given data :- mass = 1.50 kg Initial T1=90°C (saturated mixture) And final T2 = 120°C (saturated…
Q: voice that the order of the elements of the matrixdeterminant is important; switching rows 2 and 3…
A: Given data :- Force = (130i - 155j +70k) N Dimensions are x1=1.35 m…
Q: Between two sections in a vessel, a fluid moves in a steady flow manner. At entrance: A1=20 m2,…
A:
Q: What is the rate of heat transfer through a piece of Celotex 3 ft by 8 ft by 1 in. in thickness, if…
A: Given:Area of celotex, A=3 ft x 8 ftThickness, t=1 inTemperature of one surface, T1=80°FTemperature…
Q: Problem 4 A partly full water tank admits water at 85 N/s weight flow while ejecting water on the…
A:
Q: 3. Determine the tension in the cable and the horizontal and vertical components of the reaction of…
A:
Q: 2. In an Ideal Rankine Cycle, the steam throttle condition is 8Mpa and 480C. If turbine exhaust is…
A: The stepwise procedure to solve this problem is shown in the following attached image:
Q: 1. The approach & efficiency of cooling tower is 10°C 4 60% respectively, If the tempe. rature of…
A: Given Data- Approach=10'C Efficiency=0.60 Leaving temprature=37'C We have to find Inlet temprature
Q: An industrial freezer is designed to operate with an internal air temperature of - 20°C when the…
A: This question is related to the series connection of thermal resistance. There are two types of…
Q: Determine the force in each member of the loaded truss. The force is positive if in tension,…
A:
Q: airplane is cruising at an elevation of 35,000 feet from sea level. Determine the amount of gage…
A: Given-Information:- Elevation, h = 35 000 feet from sea levelPatm = 101.3251- 0.02256z5.256z = 0 at…
Q: Make 2 free body diagrams
A: The free body diagram for the point B is as shown below. Here, FAB and FBC are the forces in the…
Q: The wheel is attached to the spring. The mass of the wheel is m=20 kg. The radius of the wheel is…
A: Write the given data. m=20 kgr=0.6 mkG=0.4 mL0=1 mk=2 N/mθ=30°L2=4 m
Q: 3. A 2 kg mass of oxygen expands at a constant pressure of 172 kPa in piston-cylinder system from a…
A:
Q: What is the maximum liquid water depth for a laminar flow if the flow speed is 0.01 m/s? (The…
A:
Q: Consider a 25-m-long thick-walled concrete duct (k 5 0.75 W/m·K) of square cross section. The outer…
A: Given:Length of the duct, L=25 mThermal conductivity, k=0.75 W/m.KOuter dimensions,Ao=20 cm X 20…
Q: Which of the points is located in the third quarte
A: Given Points To find Points located in third quarter
Q: Soda from a ms=12oz can at temperature Ts=16 degrees celcius is poured in its entirety into a glass…
A: Given Data: Mass of Soda ms=12 oz=12 oz×0.0283 kgoz=0.3396 kg Temperature of soda Ts=16° C Mass of…
Q: Consider the frame shown in (Figure 1). The suspended cylinder has a mass of 85 kg. Figure 1.5m 2 m…
A:
Q: For a hydroelectric plant, a hydraulic turbine-generator is installed at the site below the free…
A:
Q: A suspended date that's able to pivot from the top seperates two liquids. There is a stopper that…
A: Given, Gate height, h=0.5 m Since, the liquid on the right is twice as dense as liquid on the left.…
Q: The common unit is ______
A: Hook's Law:- According to Hook's law stress is directly proportional to strain for any material…
Q: The bar shown below has a constant width of 41 mm and a thickness of 13 mm. The maximum average…
A: The maximum force in the section CD considering the right portion is The maximum force in the…
Q: The mass center G of the 1235-kg rear-engine car is located as shown in the figure. Determine the…
A:
Q: A carpenter holds a 15-lb 2-in. by 4-in. board as shown. If he exerts vertical forces on the board,…
A:
Q: Calculate the forces in members AB, BH, and BG. Members BF and CG are cables which can support…
A: Given data Member BF and CG are tension members. Find the force in AB, BH and BG.
Q: PROBLEM: The cable and boom system shown support a load of 1555 N. Determine the tensile force T'in…
A:
Q: Q3) Determine the force in each member of the truss. State if the members are in tension or…
A:
Q: Plate 1 Fluid AX Vo Plate 2 Navier-Stokes Equations - A Newtonian fluid is confined between two…
A: Given Data: A viscous fluid confined between two parallel vertical plates separated by distance B,…
Q: (a) List out the classification of air-condition (b) With the aid of following sketch diagra details…
A: Air-Conditioning:- By removing the heat and moisture from an area, air conditioning (also known as…
Q: Three parallel plates are placed horizontally and are separated by two fluids at 18°C, with Plate A…
A: Given:
Q: As shown in the figure, a 260-ft tank contains 25 lb of H₂O initially at 30 lbf/in². The tank is…
A:
Q: Draw the V and M diagrams, find the deflection under the 75 klb load and the displacement of point…
A: The free body diagram of member BC is RBH and RBV are the horizontal and vertical resistance force…
Q: If a vessel that contains 3.500 ft of water at 50 °F and atmospheric pressure is heated to 160 °F.…
A: Given : V1 = 3.5 ft³ Since density of water At 50 ⁰ F = 62.4 pcf At 160⁰ F = 61 pcf
Q: The 330-kg uniform I-beam supports the load shown. Determine the reactions at the supports.
A:
Q: Determine the magnitude P of the vertical force required to lift the wheelbarrow free of the ground…
A:
Q: The uniform beam has a mass of 40 kg per meter of length. Determine the reactions at the supports. A…
A:
Q: A scuba tank contains 1.5 kg of air. The air in the tank is initially at 15°C The tank is left near…
A: (a) The final temperature of the air inside the cylinder can be determined as shown below.
Q: Carbon dioxide gas is compressed at steady state from a pressure of 16 lb/in² and a temperature of…
A:
Q: Calculate the rate of heat transfer by radiation from an unlagged steam pipe, 50 mm, o.d. at 393 K…
A: Given : outer diameter of pipe, D = 50 mm pipe surface temperature , TS = 393 K air temperature,…
Q: An open 2-mm-diameter tube is inserted into a pan of ethyl alcohol and a similar 4 mm-diameter tube…
A: The capillary rise is given as h=4σcosθρgd Here, σ is the surface tension, ρ is the density of the…
Q: review the example. Thank you very much Question : Determine the power required (Watts) to drive…
A: Given:Speed of the pump, N=1 rpsDischarge of oil, ρ=850 kg/m3Flow rate, Q=375.3 gpmbore, d=250…
Q: Exercises 1. The approach & efficiency of cooling tower is 10°C 4 60% respectively. If the tempe.…
A:
Q: 2) The ballistic pendulum is a simple device to measure projectile speed v by observing the maximum…
A: Given data :- Mass of projectile = 40 g Mass of box = 16 kg Maximum angle = 23° Brief introduction:-…
Q: 3-152 Consider a 25-m-long thick-walled concrete duct (k = 0.75 W/m-K) of square cross section. The…
A:
Q: A pump has a brake horsepower of 35 hp with an efficiency of 68%. Neglecting frictional losses,…
A: Given:Brake horsepower, BP=35 hpEfficiency of the pump, η=68%Height of discharge, h=60 m
Q: A compressor draws in 0.5 kgm/s of air with 7 m/s speed, 100 kPa pressure, and 0.95 m3/kgm. The air…
A:
Step by step
Solved in 2 steps with 1 images
- Determine the volume of the concrete arch dam.The hemispherical glass bowl is filled with water. Find the location y of the center of gravity of the filled bowl. Approximate the bowl as a thin shell of radius R=6.15in. Use 1=162lb/ft3 for glass and 2=62.4lb/ft3 for water.= 1045 kg/m³), it's size 5 m long, 3 m wide and 1.4 m high. The depth of immersion A rectangular block float in sea water (Psea water of the block is 0.5 m in sea water. Determine the metacentric height, if the center of gravity is 0.7 m above the bottom of the block.
- A square lamina (each side equal to 2m) is submerged vertically in water such that the upper edge of the lamina is at a depth of 0.5 m from the free liquid surface. What will be the hydrostatic pressure in kPa on the lamina? Determine the center of gravity on the lamina from the free liquid surface.A solid mat has a diameter of 3.81 cm and a relative density of 0.089. It floats in water at a depth "h". Determine this height if: al the thrust due to the air is negligible b) the thrust of the air is not negligible PAIRE=1,225kg/m° (use 4 decimal places for your calculations).A closed vessel 1 m in diameter is completely filled with water. If the vessel is rotated at 1200 rpm, what increase in pressure will occur at the top of the tank at the circumference? Ans. 1970 kPa
- A barrel in the form of a frustum of a cone with a radius of 3m and 6m at the bottom and at the top respectively. It is 5m high and is 4/5 full of oil (0.83). Determine the a. Total hydrostatic force "F" acting on the wall of the barrel in kN and b. its line of action "s" from the bottom50" 4. A vertical rectangular gate 3m wide and 1.75m high has water on one side with surface of liquid 3m above its top. Determine the magnitude of the total hydrostatic force acting on the gate and its distance from the water surface.Compute the depth of the center of pressure for a vertical triangular gate having a height "h" and a base width "b" and submerged in a liquid with its vertex at the liquid surface. If the vertex is 1m below the surface, determine the location of the center of pressure from the surface if b =5m and d = 4m. And Compute also the total hydrostatic force on one side of the gate. L.S. hcp h d cg cp e b
- the gate and locat On 3. An iceberg having a specific gravity of 0.92 is floating on sait water of specific gravity 1.03. If the volume of the ice below the water surface is 2500 cubic meter, what is the total volume of the ice? Botton. 2 m 0=503- Find the total pressure and position of center of pressure FREE WATER SURFACE on a triangular plate of base 2 m and height 3 m which is 60 2.5 immersed in water in such a way that the plane of the plate h* -2 m makes an angle of 60 with the free surface of the water. 3 m YP The base of the plate is parallel to water surface and at a depth of 2.5 m from water surface.An empty long neck bottle with an upper cylinder diameter of 1 inch, with the length of 4 inches and lower cylinder measures 4 inches in diameter and length of 5 inches is vertically immersed in a body of water. How deep will you submerged the bottle from the mouth opening in order to occupy the whole bottle neck with water. please show the formula used and cancellation of units, if possible include illustration also.