3. For a parallel circuit of 20 ohms resistor and a 10 ohms inductor, is connected to a 110/60 cps Volts source a) find the Impedance b) determine current IR c) determine the current IL d) find the inductance.

3. For a parallel circuit of 20 ohms resistor and a 10 ohms inductor, is connected to a 110/60 cps Volts source a) find the Impedance b) determine current IR c) determine the current IL d) find the inductance.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 3PA: You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors...

See similar textbooks

Related questions

Q: Bulbs A, B, and C are identical and all glow. to. Order, from highest to lowest, the luminosity of t...

Q: I, 122 I Y + RL V, ЗА SW1 -How to find Pmax of RL when SW1 is open I, 2A when SW is close 12N V, + R...

A: The solution is given below

Q: Find the average value of a half-wave rectified signal with a peak value of 20 mV.

A: Given data For half wave rectifier: Peak value Vp = 20 mV Average value Vavg = ? Formula Vavg = ...

Q: Consider tne following :2( 312 32 -ww ww ww 6 12 6 V What is the value of the current I in the above...

Q: a. State with reason if the following waveform is periodic or not and if periodic what is its period...

A: Note: As per the policy we can solve only one question, please re-upload the remaining question as a...

Q: Determine Vout for fig. 1 Vcc 5V D1 R1 Vout 1.5kQ silicon diode D2 Germanium Diode

Q: • T or F, modify the wrong part if False, please underline twice your answer if True or False. At ...

A: It's a FALSE statement

Q: rent with a frequency of 60HZ reaches its positive maximum of 20A at time 2ms. Write down the equati...

Q: circuit is built around a bi-polar NP?N transistor. The Base network has a resistor (RB) and diode (...

Q: • T or F, modify the wrong part if False, please underline twice your answer if True or False. A c...

A: The solution is given below

Q: Question 1: 9A HAla Given a system with an input-output relation y(n) = cos2(n + 1)+x(n- 1). Answer ...

Q: Design an excess 3 to binary decoder using the unused combinations of the code as don’t care conditi...

Q: Problem 1: Determine IB, IE, I10 kN, VB, VC, and VE in the circuit. Assume Bdc = 100.

Q: 20x ix 10 Ω 8 A 12 VB Vc VA + ↑ )1 A 52 Ux -Find x in the ff eq: XA+xB+0.5C=9 XA+xB+xC=0 XA+xB=8

Q: The armature resistance of 220V shunt DC motor is 0.4 takes load armature of 2A and run at 1350 r.p....

Q: • T or F, modify the wrong part if False, please underline twice your answer if True or False. ...

A: Transformer is a two winding device and works on mutual induction . When primary winding is excited ...

Q: Sketch output waveform the following CLIPPER circuits. Pl

A: Given clipper circuits and input sinusoidal waveform with amplitude 8v and -8v then the output wave...

Q: T or F, modify the wrong part if False, please underline twice your answer if True or False. A 100...

A: Voltage regulation is defined as the rise in voltage from full load to no load , exprrssed as a frac...

Q: -Find RL through Norton's Theorem when the switch is open.

Q: Determine the current and power dissipated in the resistor in the figure below. 11 v+ 14 N A P142

A: We need to find out current and power for given circuit

Q: The primary to secondary turns ratio of a transformer used in a HWR is 20:1. The primary is connecte...

A: The solution is given below

Q: In a DC motor, why forces are generated for parts of the loop and not for other parts of the loop. T...

A: Answer -

Q: Define the Signum function.

A: In this case, the signum function needs to be defined.

Q: 13. Find the rms values of the following sinusoidal waveforms: a. v= 10 millivolts sin (377t + 60) b...

Q: A 415V TPN busbar rising main chipped to a surface is to provide a 240V supply to each of 8 individu...

A: Solution- The circuit arrangement from the above data- It is showing how each flat must be connect...

Q: ix 10 2 8 A 1Ω 82 VB VA PA W Vx ↑ 1 A 5Ω. Figure 1 assume the following node voltages were obtained ...

Q: Please ASAP all answers are wrong in previous...Find ZL for maximum ave. power transfer (ac) and ge...

A: Thevenin voltage is the voltage at ZL terminals with ZL is open circuit. Thevenin impedance is the i...

Q: 2. How long is a wire made from 100 cm' of copper if its resistance is 8.5 ohms? The resistivity of ...

Q: EX : (13) :- According to the Shannon's Channel capacity theorem: Answer the following questions: (1...

A: According to Shannon's channel capacity theorem:

Q: A 10-poles, 3-phase alternator is coupled to an engine running at 600 r.p.m. It supplies 3- phase in...

A: Synchronous speed = (120×frequency)/poles. Slip of motor = (synchronous speed-motor speed)/synchrono...

Q: Ex (6):-. A television signal (video and audio) has a bandwidth of 4.5 MHz. This signal is sampled, ...

A: Given, Bandwidth of a television signal (fm) = 4.5 MHz Number of voltage levels (L) = 1024 Sampling ...

Q: 4. The circuit uses current- (or shunt-) feedback bias. The Si transistor has ICEO = 0, VCEsat =0, a...

A: It is given that: ICEO=0VCEsat=0β=100RC=2kVCC=12V

Q: 7) Ventricular late potential analysis in the ST segment of the ECG requires analysis in the frequen...

Q: Ignoring the provided value of β(120) draw the load line for the network of Fig. 4.118 on the charac...

Q: Diode D1 connected to Vbe of NPN transistor.18 with forward biased of while D2 connected to the Vbe ...

A: Find the Vbe of diode D1 is which connected across NPN transistor and Vbe of diode D2 which is conne...

Q: 1. A metallic conductor has a resistivity of 18 x 100m. What is the resistance of a piece that is 30...

Q: A HWR circuit is transformer fed from the 220 V line. If the circuit provides a peak output voltage ...

Q: If the ammeter parameters due to insertion include 1200 internal resistance and a load resistance of...

A: Given, Internal resistance, Rint=120 Ω Load resistance, RL=2 kΩ Let the source voltage is V

Q: It is found that the resistance of a coil of wire increases from 40 ohms at 15 degrees Celsius to 50...

A: Given resistance of coil of wire, R15=40 Ω at 15 degrees celsius R50=50 Ω at 60 degrees celsius

Q: 1. Convert points P(1,3,5) from Cartesian to Cylindrical and Spherical coordinates. 2. Convert point...

Q: At a location in Europe, it is necessary to supply 300 kW of 60-Hz power. The only power sources ava...

Q: (i) It is required to set the operating point by biasing with collector feedback resistor at Ic = 1m...

Q: Note: All question solutions should be based on Ohm's Law and/or Kirchhoff's laws. A: Determine vo a...

A: Given:

Q: 1. How you can recognize the heathy thyristor from the faulty one?

A: Note: As per the policy we can solve only one question, please re-upload the remaining question as a...

Q: With the given circuit, you are tasked to do the ff: a. Write the node-voltage equations (where ther...

A: Use virtual ground concept.

Q: GENERAL SAFETY RULES FOR ELECTRICITY AND ELECTRONICS Safe practices will protect you and your fellow...

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you ar...

Q: A synchronous generator having no-load frequency of 51HZ and droop constant of 0.5Hz/MW is synchroni...

A: Given a synchronous generator having, No load frequency, fnl=51 Hz Drop constant = 0.5 Hz/MW Slope =...

Q: 20. An electric iron draws 2.5 A at 230 V. Determin resistance. A. 78 ohms B. 84 ohms C. 92 ohms D. ...

Q: 5. At a corner of a 30 mm x 40 mm rectangle is placed a charge of -40µC and at the two adjacent corn...

A: The given figure is shown below:

Q: Take a look at Figure 3. Please find the current through the segment of the bottom wire between the ...

A: Given circuit,

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

3. For a parallel circuit of 20 ohms resistor and a
10 ohms inductor, is connected to a 110/60 cps
Volts source a) find the Impedance b)
determine current IR c) determine the current
IL d) find the inductance.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
1. Enumerate five formulas for series-parallel capacitances across Vt source and draw the circuit. 2. Enumerate five formulas for parallel-series capacitances across Vt source and draw the circuit.
A resistor & a capacitor are connected in series across 230V, ac supply. The current taken by the circuit is 4 A for 50 Hz frequency. The current is reduced to 2 A, when the frequency of supply is decreased to 40 Hz. Determine the value of resistor & the capacitor.
A series circuit consisting of 10 ohm resistance and 60 mH inductance is connected to a 220-volt, 50-hertz source. Determine the voltage drop across the inductance.
A 5uF capacitor is connected across an emf of 50 Volts maximum value and frequency of 1000 cycles. What is the equation of the current?
1.Enumerate five formulas for four series connected capacitances across Vt source and draw the circuit. 1. Enumerate five formulas for four parallel connected capacitances across Vt source and draw the circuit.
Describe the behavior of the voltage across the resistor with time as thecapacitor charges. Explain the reason for this behavior.
Full-wave rectified sine wave circuit is used to measure the RMS value of a half square wave with the help of PMMC meter. The meter was actually calibrated for sine wave. The circuit uses a meter movement with a full scale deflection current of 200uA and internal meter resistance of 5kΩ. Assuming Non-ideal diodes having resistance 1kΩ, Analyze the circuit to determine the value of series multiplier resister and the corrected RMS voltage, if meter is to read 225V RMS full-scale.
What voltage is boosted at the output of a multiplier.Choices: average, rms, peak, or instantaneous Which assumption is not used in the analysis of multipliers?Choices: a capacitor will not discharge, start with the cycle of the source that will forward bias the nearest diode, the output will always be multiplied, or a single diode is forward biased at a time A voltage multiplierChoices: multiplies the output voltage, has very high voltage and low current ,can employ inductors, or may not have equal numbers of diodes and capacitors A voltage regulator maintains constant voltage at the load regardless of variations atChoices: the input and output, the load, source, or in the environment Between a lower percent regulation and a higher one, which is better?Choices: lower or higher
4) Determine the value of branch current, I1 and I25) Determine the value of voltage across resistor, R1, R2 and R36) Determine the value of voltage across capacitor, C1 and C27) Determine the value of voltage across inductor, L.
An inductor of 150hms and resistance of 10 Ohms are connected in series to a 230V, 50 Hz ac supply. Determine the active and reactive power and power factor in the circuit.