3. Consider a commercial InGaAs pin photodiode whose responsivity is shown in the Figure. Its dark current is 3.5nA. Answer the following. a) Calculate the incident optical power required to produce a photo generated current of thrice of the dark current when a wavelength of 1700nm is incident on the photodiode. And then calculate the QE of the photodetector at 1700nm?

3. Consider a commercial InGaAs pin photodiode whose responsivity is shown in the Figure. Its dark current is 3.5nA. Answer the following. a) Calculate the incident optical power required to produce a photo generated current of thrice of the dark current when a wavelength of 1700nm is incident on the photodiode. And then calculate the QE of the photodetector at 1700nm?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Determine the resultant photocurrent of a p–i–n photodiode having responsivity of 0.41 if an incident optical power = 10 × 10-6 W. Also find the voltage across load resistor of 50 ohms.
An RG-11/U foam coaxial cable has a maximum voltage standing wave of 52v and a maximum voltage 17v. Find (a) the SWR, (b) the reflection coefficient, and (c)the value of a resistive load. (d)What is the output power?(disregard attenuation due to length). SOLVE ONLY THE (D) WHAT IS THE OUTPUT POWER
9 What is field pattern in m.)TE mode in rectangular waveguide?n.)TM mode in rectangular waveguide?
What is field pattern in a. Rectangular waveguide?b. TE mode in rectangular waveguide?c. TM mode in rectangular waveguide?
this question related to Optoelectronics and Nanophotonics a) List the wavelength ranges for the three optical communication windows andb) identify their sub bands (all in terms of wavelength). Finally,c) give two examples for the uses of each main optical communication window. d) What is griffin ?What is important?
What are em and he modes? How do they differ from te and tem modes? What is a single mode waveguide and why is it 0th order mode?
Explain the generation of PWM waves by using common collector circuit. Also state ptractical application of PWM Subject Is Communication System.
P 2.7a What will be the cutoff wavelength for dominant mode in rectangular waveguide whose length is 10 cm? (2)
A 2 V signal is incident to the interface from a 75 Ohm region propagating to a 50 Ohm impedance region. What is the reflection coefficient? What is value of the incident, reflected and transmitted wave? What voltage would you measure on either side of the interface right after the signal goes through the interface.
8-The wave power per length is 1354 W/m, the device-width of the wave energy system is 6.3 m, the capture width ratio is 0.44, the rated power is 14379 W. Determine the percentage degree of utilization. O 26.10 O 23.49 O 22.19 O 28.71
Describe, with the aid of suitable diagrams the constituent parts of an optical receiver. The description should describe both the function and type of noise added at each part. Explain the origin of the quantum limit for ideal photodetectors.
2. A phase retardation plate ade by quartz has thickness 0.1436 mm. For what wavelength in the visible range (400- 750nm) it will act as (i) quarter-wave plate & (ii) half wave plate? Given µ,= 1.5443 and pH=1.5533. [Ans: 738.6nm, 574.4 nm, 470 nm for QWP and 517 nm for HWP.] [CO3]