3. A 5.6 µF capacitor is charged to 1000 V. Determine the initial stored charge and energy. If this capacitor is discharged to 0 V in a time interval of 1 µs, find the average power delivered by the capacitor during the discharge interval.

3. A 5.6 µF capacitor is charged to 1000 V. Determine the initial stored charge and energy. If this capacitor is discharged to 0 V in a time interval of 1 µs, find the average power delivered by the capacitor during the discharge interval.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: Only question 13

A: As mentioned, we have to answer only question 13. Given:n-channel JFET characteristic plot:we need…

Q: 2. Determine the potential across R1. Assume that the zener diode follows a piecewise linear model,…

Q: What are the expected readings of the following in the figure below? (R = 7.10 Q2, AV = 5.50 V) A…

Q: 4. A Darlington transistor is essentially an array of two transistors connected as shown below.…

Q: H.W: Calculate the Fourier series for the waveform 27² 4(-1)" n² Ans. a = & an= f(t)=1² N Mi. N -2π…

A: A periodic function of,To find :The Fourier series of the waveform.

Q: H.W: Calculate the Fourier series for the waveform

Q: 24v (1 3 4 кл 320KL 5 КЛ W 22,5 кл 15кл

Q: Design a home alarm system using inputs from a door sensor, a window sensor, a motion detector, and…

Q: Draw an interfacing circuit and write a program based on the following scenario. Suppose you're…

A: Since you have posted a question with multiple subparts, we will solve the first three subparts for…

Q: The current (1) in an electrical circuit is directly proportional to the voltage applied (E) and…

A: Electric current is the flow of electric charge in a conductor, typically measured in amperes…

Q: 4. At time t = 0, a series-connected capacitor and inductor are placed across the terminals of a…

Q: Find the unknown quantities for the circuits below using the information provided. E + V₁ www 1A 202…

A: 1. First circuit diagram -2. Second circuit diagram -

Q: 4.2-2 Consider the following baseband message signals (iv) m(t) = 50exp(-100|t) sgn(t); and (v)…

A: DSB-SC stands for Double Sideband-Suppressed Carrier.It is a modulation technique used in…

Q: What is the value of the capacitor that could be used to replace each capacitor network below?…

A: In the given question we need to calculate the equivalent capacitance.

Q: 1. The op amp in this circuit is ideal. R3 has a maximum value of 100 kn and σ is restricted to the…

A: a. The range of v0 is -1 v to -6.6 v. b. Hence at σ=0 the operational amplifier…

Q: An analog system with transfer function G(S) =is sampled through zero-order hold sampler with…

Q: i1(t) = 1.2e ^-3tA, R 1 = 5ΜΩ,C 1=2 µF Derive the complete solution for vx(t) fort > = 0 i₁(t) ↑ R₁…

A: The voltage across a capacitor will not change suddenly unless an impulse source is applied.In d.c.…

Q: Questions: What happens in the virtual simulation when you put the sensor directly on top of a…

A: Virtual simulation - Virtual simulation is the application of partial immersion in a digital…

Q: Problem (1) Use mesh current method to formulate the equations needed to solve for I, I, and Ic…

A: In the given circuit the mesh currents needs to be calculated and the power of the sources needs to…

Q: sig Rsig www R₂ C₁ HH R₁ Rc- R6 +Vcc +₁₁ C₂ C3 R3 VO

A: We need to find out the value of capacitor for given lower cut off frequency.

Q: 4.) Determine the mesh currents for the circuit shown in Figure 4. Scos(x) v 80 い GH Figure 4 Y3 F…

A: The given circuit isWe need to determine the mesh currents.

Q: Assume the NMOS and PMOS transistors in a CMOS inverter have kn'= 100 μA/V², Vthn = 0.7 V, kp'= 50…

A: a) If you find the solution doubtful or doesn't match with your answer provided, or you feel that I…

Q: K(s+1) 1. One general feedback system has G(s) = s² (s+3)(s+4) and H(s)=2s Find the value of gain K…

A: see the attatchment given below for details.to solve these types of problem we should have basic…

Q: When an ammeter is used to measure the current in the circuit shown in (Figure 1), it reads 10 A.…

Q: If the poles or zeros in s-plane is presented as below, what would its time response look like?

A: From pole zero plot, it is clear that root are real and equal.

Q: me voltage and current at the terminals of a typical circuit element are zero for t less than zero.…

A: For t<0v(t)=0i(t)=0For t0, voltage and current are:

Q: Can you explain each step specially how they integrate in step 3 and 4 please

A: Asked to explain the each step from previously solved solution.

Q: Find the current i4 symbolically using nodal analysis and explain nodal analysis generally and how…

A: Nodal analysis is a method used in electrical circuit analysis to determine the voltage at each node…

Q: Design the network in Fig. 6.101 such that l2 = 21₁ and 13 = 212. + 91 mA E 28 V 1 +₁₁ R₁ 12 R₂ www…

A: Given circuit:here we have to design a circuit such that

Q: Determine the voltages Va,Vb, and Vab for the networks in Fig. 5.118. 12 V + +₁H. 8 V 20 V 6V 4V +10…

A: The question is about finding node voltages Va , Vb and Vab.

Q: -. A block diagram is shown in the following figure, try to calculate C/R. G₁ H₁ H₂ G₂ G3

Q: Determine the voltage dropped across R₁, given: 4 Ę₁ = 144 V, R₁ = 36 Q2, R₂ = 14 Q2, R₂ = 47 Q, and…

A: Given circuit is,Asked to find the voltage drop across the resistor R4 =?

Q: Complete the truth table for the following sequential circuit: Answer: A 0 0 0 0 1 1 1 1 DQ a' B 0 0…

A: Complete the truth table for the following sequential circuit.It is positive edge triggered flip…

Q: A 208-V four-pole 60-Hz Y-connected wound-rotor induction motor is rated at 30 hp. Its equivalent…

A: The data given in the question are:Asked to find the,Line current ILStator copper losses PSCLAir gap…

Q: 10 cos5t V 152 w x 2H m 0,2F 4lx ell 1H

A: Given:a network,we need to find the current ix(t).

Q: Explain and draw an NPN transistor chip in a circuit of your own design. I want the actual chips…

A: An NPN transistor has three terminals: the emitter (E), the base (B), and the collector (C). In an…

Q: ix +1 ww R1 E(t) vo(t) ww R2 с + rmix

A: Given Data:Consider the given DC circuit with the node as,To Find:The expression of the node…

Q: 60 A in. Vx – ↓ ? Slove зол 20 л 15Л Зол

A: KVL stands for Kirchhoff's voltage law, which states that the total voltage around a closed loop in…

Q: When an ammeter is used to measure the current in the circuit shown in (Figure 1), it reads 10 A.…

A: From the given circuit diagram,Consider the center position node as V1 and right side position node…

Q: Using the voltage divider rule or Kirchhoff's voltage law, determine the unknown voltages for the…

A: Given circuit is,Asked to find the unknown voltage by using voltage divider rule or KVL.Note:…

Q: How can these logic equations be modified to remove potential timing glitches? AB' + A'C + BC' (A'…

A: Given:a) AB' + A'C + BC'b) (A' + B)(A+C')(B'+C)we need to find:how can these logic equations be…

Q: #1. Consider the circuit shown, with V-14.2V. V₁ R₂ R3 R₁ ww R (0) 103 59 192 ww R₂ R3 a) Use…

A: The circuit diagram is shown below,

Q: 2 A www R₁ www A R₂ Use the result to find i. 12 V - b 592 4 A Problem 04.050.b - Using equivalent…

A: Given:with we need to find the currrent i.

Q: Q4 VDS=VGS When I = 40 μA, VDs is read as 0.6 V. Increasing I by 50 µA leads to 0.1 V increase in…

Q: Refer to the following circuit diagram. Use source conversion, or any other method, determine the…

A: In this question, we need to determine current IZ4 using the source transformation and any other…

Q: How can a timing diagramfor AB, Cin, S, and Cout be drawn for this full adder?

A: We need to complete the below timing diagram.

Q: An FIR filter has coefficients bk = {1, 2, 1}. What is the magnitude of the output signal from this…

A: Given data:Filter coefficients bk=Input signal x(n)=2.5 (a DC constant)To find:The magnitude of the…

Q: Find vout in symbolic form USING nodal analysis. please explain nodal analysis and what to look for…

A: In this question, we need to determine the output voltage Vout using the nodal analysis. This is…

Q: How. Find k values such that the to be stable Risi K S(5² +5+i)(5+4) Following system ( (s)

A: For the given system calculate the values of K for which system is stable.

Q: Find the equivalent resistance Req for the circuit in Figure P.4, if R1 = 20 Ω, R2 = 10 Ω, R3 = 10…

A: In this question, we need to determine the equivalent resistance. we solve this problem using series…

Question

3. A 5.6 µF capacitor is charged to 1000 V. Determine the
initial stored charge and energy. If this capacitor is
discharged to 0 V in a time interval of 1 µs, find the
average power delivered by the capacitor during the
discharge interval.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
A 20-ohm resistor and a capacitor are connected in series with a battery of 60 volts. At t = 0, there is no charge on the capacitor. Find the capacitance if the current at t = 5 seconds is 3/e^s amperes. Ans. 0.05 Farads
Please explain this question properly A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
a) The voltage across a 20uF capacitance is v. = 50 sin( at - 80) volts and Frequency equal to 100 Hz. Determine the current through the capacitor i and sketch its waveform. b) Define phasor
What is the value of the induced voltage of the self-inductance when the rate of current is from 200 uA to 20 uA and the total time interval is 5 uS?
In the box below, show that the time constant r is the time it takes the voltage across a discharging capacitor to reach the value V0/e.
9/ Identify from the following statement when the capacitance can be discharged? a. If resistor is connected in parallel with the capacitor b. If inductor is connected in parallel with the capacitor c. If resistor is connected in series with the capacitor d. If inductor is connected in series with the capacitor
When the switch is in position 2, the circuit will discharge the capacitor. Draw the circuit for the discharge phase. (without any of the charge phase components). and determine the time constant for the discharge phase and the equations for v(t) and i(t) for the discharge phase.