3) When you arrived at work you were informed a large inductor in a server power sup had failed. Looking at the print you determined it is a 1 H, 10A inductor. You checked in the instrument tech's shop and found the largest inductors available were 0.5 H, 5 A and there are 20 of them. Can you design a circuit to replace the failed device? If so draw the circuit

3) When you arrived at work you were informed a large inductor in a server power sup had failed. Looking at the print you determined it is a 1 H, 10A inductor. You checked in the instrument tech's shop and found the largest inductors available were 0.5 H, 5 A and there are 20 of them. Can you design a circuit to replace the failed device? If so draw the circuit

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter20: Capacitance In Ac Circuits

Section: Chapter Questions

Problem 2PA: You are working in an industrial plant. You have been instructed to double the capacitance connected...

See similar textbooks

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
A pure capacitive circuit is connected to a 480-volt, 60-Hz power source. An ammeter indicates a current flow of 24 amperes. The circuit current must be reduced to 16 amperes by connecting a second capacitor in series with the first. What is the value of the existing capacitor? What value capacitor should be connected in series with the original capacitor to limit the circuit current to 16 amperes?
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
With V1, voltage peak to peak is 10 volts, R1=200 Ohm, R2=1000 Ohm and C1= 300 nF. Find Vx, voltage across the the capacitor, C1 and R2 when the frequency is 1000 Hz and 10000 Hz
A 50 hz. current of 2 A flows in a circuit consisting of an adjustable resistor and a 56.6 uF capacitor in series. Determine the value to which resistor should be adjusted for the voltage across the capacitor to be 0.75 the voltage across the circuit.
If a circuit has a resistance of 3002 and a series inductance of 5002, what is the relationship between the applied circuit voltage and the circuit current? The applied voltage lags the circuit current. The phase shift between the circuit voltage and current changes with time. The applied voltage is in phase with the circuit current. The applied voltage leads the circuit cur Previous Page Next Page Page 2 of 10
STEP 4: make sure the capacitor is fully charged using the PSB set to 3.3V. Then switch the OAB jumper to 5V and hold SW1 closed again until the LED goes out
At DC operating point, a capacitor behaves like an open a wire O a resistor
M EXPERIMENT 01 V(n002) V(n001) 10V- 8V- 6V- 4V- 2V- OV- -2V- 4V- -6V- -8V- -10V- 0.00ms 30.00ms 60.00ms 90.00ms 120.00ms 150.00ms 180.00ms K EXPERIMENT 01 X Diode 1N914 V Resistor SINE(0 10 60000 100) 10K .tran 2
What is the minimum size the capacitor can be if we want to keep the ripple voltage at the output to 0.5 V or less?
Question 777 electric plot the output voltage when the resister and capacitor in the series branch and the resister and capacitor in parallel branch are unequal and have fluctuations of of +-15% of the nominal values and analyze the signals Full explain this question and text typing work only thanks