2200 volts, 60 Hz is impressed on a certain transformer, the core loss is 240 Watts

Q: A generator is rated 100 MW. 13.8 kV and 90% power factor. The effective resistance is 1.5 times th...

A:

Q: resistor

A: Answer    

Q: Q: If x(t) is the input to linear system with impulse respons of h(t) defind as: X(+) = 8 sinc ( 8) ...

A:

Q: Design a self–bias network using a JFET transistor with IDSS = 8 mA and VP = –6V to have a Q-point a...

A:

Q: a) A 240V single phase circuit is run in conduit in 2 core 70°C PVC/PVC cable having live conductor ...

A: Given: A 240V single phase circuit is run in conduit in 2 core 70°C PVC/PVC cable having a live cond...

Q: A 2 MVA, 2.3-kV three-phase Y-connected alternator operates at rated kVA at a  power factor of 80%. ...

A:

Q: h1 [n] = 38 [n + 3] + 8 [n] + 28 [n – 2] + 8 %3D h1n] h2 [n] = u[n-2] h3 [n] = 8 [n] x[n] y[n] %3D h...

A:

Q: t’s amazing! Zainab exclaimed and asked: How is it possible for a person to speak at a radio station...

A: The general block diagram of FM transmitter is shown below,

Q: Problem 3. Determine the total resistance across ab. R a R R R R R R R R

A:

Q: 4. A capacitive is draws 8 A at 0.78 lead pf when connected across a 550 V, 50 hz supply. If the cir...

A: We need to find out current and reactive power for given circuit

Q: Q3)For the circuit shown below determine the value of current (I) through the resistance R=2N if cur...

A:

Q: create of your own three problem set and solution for impedances and admittance.

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source, eithe...

Q: The noise produced by a resistor is to be amplified by a noiseless amplifier having a voltage gain o...

A:

Q: 11.a. A fiber link has a polarization mode dispersion of 4.2 ps/√km. The fiber link is 5 km. What's ...

A: This is a basic problem of opttical fiber communication The solution is given below

Q: 4 Grve three possible ways to express the function F with eight or fewer literals F = (A,B. C.D)= (0...

A:

Q: Calculate the total impedance (Zin) in the circuit shown below. Your final answer must be in rectang...

A:

Q: 1. An inductive circuit takes a current of 15 A at 0.78 pf when connected to a source 250 V, 50 hz m...

A:

Q: 1. A generator connected through a 5-cycle circuit breaker to a transformer is rated 7500 kVA, 6.9 k...

A:

Q: ½R R Vo V1 V2 (: + + I

A:

Q: 13 I A C I2 BIs I6 1)2A OA D

A: Given

Q: The given data to be used for getting the RMS Values is 0, 5, 10, 30, 50,  70, 50, 30, 10, 5, 0, -5,...

A: In this answer we will find the RMS value using all the given values as explained below. The RMS val...

Q: If, for the Figure below, E = 240 Z0° V, a = 0.5, and Iz = 2L20° A, determine the following: IL Eg Z...

A:

Q: When supplied with a current at 240 V, single phase at 50 Hz a certain circuit takes 15 A. If the fr...

A: As you mentioned i am giving answer of question no 11.

Q: A load of 1250 KW is connected at the receiving end of a 3 phase transmission line 60 km long. The p...

A:

Q: A wireless communication system has a trasmit power Pt = 10 mW. Through extensive measurements, the ...

A: A wireless communication system has a transmit power Pt = 10 mW. Through extensive measurements, the...

Q: 16 V -3 V 2.2 k2 1.2 M2 'pss = 10 mA Vp = -4.5 V Vaso

A:

Q: 35. For the circuit shown, use superposition to find the power being dissipated in R3. * R, R, 10 Q ...

A: According to guidelines we are allowed to do only first question. Post again for remaining one as a ...

Q: Solve for ID, VDS and VGS

A: The given circuit is shown below:

Q: What is the total potential drop through the complete, closed loop shown below? 2 mH 4 nF 1 k 2 1. a...

A: According to KVL sum of the voltages in closed loop is zero.  Voltages can be voltage rise or voltag...

Q: *27. a. Write the mesh currents for the network of Fig. 118 using the general approach. b. Using det...

A:

Q: Laplace transform of the initial and final values ​​of the current i0(t) in the circuit in Figure 2....

A: In the given question they want to know the initial and final current of the inductor. Depending upo...

Q: Problem 26: Use mesh analysis to find the current through the resistor R5. R5 3 N 4 N R2 10 N R1 R6 ...

A:

Q: (2) yubäi Q2/(a) For the network below, * Find Vo 510 k2 680 kQ 77KN 18 k2 22 k2 33 k2 V. 20μν 211 µ...

A:

Q: What is the noise density for a receiver with an input bandwidth of 20 MHz and an equivalent noise t...

A:

Q: Four telephone circuits, each having a S/N ratio of 45 dB, are connected in tandem. A fifth circuit ...

A:

Q: What is the color code of the three-band resistor having a rating of 350 mega-ohm

A:

Q: Given an n – channel enhancement type MOSFET with VT = 3.5 mA and K = 0.4 X 10–3 A/V, determine ID w...

A:

Q: What is a transformer and explain how does it works

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any ...

Q: contain energy at a single frequency and are represented by sine waves, whereas contain energy at mu...

A: Generally in the modulation techniques   Carrier Signal contain energy at a single frequency and are...

Q: A 3-phase, induction motor has the following no-load test data: No load (per phase):  120 V, 5 A, 48...

A: In this question, We need to determine the magnetizing reactance per phase of the approximate equiva...

Q: 3. How many different categories are available for the methods of preparing optical glasses?

A:  The methods of preparing optical glasses are divided into two categories. Conventional glass refin...

Q: 8)Draw the truth table for the gate shown below and write a valid logic expression for it. +SV A.

A:

Q: EP 100 ES Relación = IP 10 IS ES = IS = 3 NP 1000 NS 20,000 EP 150 ES 10 Relación = IP 2 IS, IS = NP...

A: Transformer winding: When the winding is wind on the primary side. This winding is called primary wi...

Q: In a superheterodyne receiver, the incoming RF signal is at 25 dBµ, the RF amplifier has a 30 dB gai...

A: The solution is given below .

Q: 1. A generator connected through a 5-cycle circuit breaker to a transformer is rated 7500 kVA, 6.9 k...

A: Short circuit current: When a fault occurs at any point and a very high magnitude current flows due ...

Q: Which term refers to amount of work done equivalent to the energy present in the field of interactio...

A: The Electric Potential Energy,  is generally the amount of work done  which is equivalent to the fie...

Q: b) Determine the forward diode current for a silicon PN junction diode when the applied forward bias...

A: For a silicon PN junction diode - At T=36°C,V=0.8VandI=15μA

Q: Given IDSS = 9 mA and VP = –3.5 V, determine ID when: VGS = 0 V VGS = –2 V VGS = –3.5 V VGS = –5 V ...

A:

Q: Ideally, all atoms have the same number of protons and electrons, therefore all atoms are considered...

A: When ideally all the atoms have same number of protons and electrons

Q: Draw a half-wave and full-wave rectifier circuit with 1 KQ load resistance and sketch the output wav...

A: Given  Load resistance = 1 kohm Input voltage = 10 sin(wt)

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.