2. The number of cubic centimeters of methane, measured at STP, adsorbed on 1 g of charcoal at 0°C and several different pressures is given below. p/mmHg cm³ adsorbed 100 9.75 200 14.5 300 18.2 400 21.4 Plot the data using the Freundlich isotherm and determine the constants KF and 1/n. What do values signify with regards to the mechanism of adsorption?

Q: Propylene gas is hydrogenated in a batch reactor: C3H6 (g) + H₂(g) M C3H8 (2)

A: Giventhe equation for hydrogenation of propylene gas in a batch reactormass of propylene fed=1000…

Q: temperature at the interface

A:

Q: Given the following reaction and concentration of reagents and product from time 1 to time 4 A+B Y…

A: Decomposition of B is a first order reaction.

Q: The Dog patch Skunk Works emits 10 g/h of trimethylamine from a stack 10m high with zero plume rise.…

A:

Q: Calculate the pressure ( in atm) at which the freezing temperature of water is -20°C = 253 K H₂O(s)…

A: Given data: Enthalpy of fusion = 6010 J/mol Initial temperature = 273 K Initial pressure = 1 atm…

Q: C₁=C₂₁ (929) [1-a (25)] + The schematic diffusion profile in Figure 5.13 shows these concentration…

A: Given data: Temperature = 1000 0C Distance = 15 µm Pre-exponential factor = 2.3 × 10-4 m2/s…

Q: Air entering the duct at td-20 c, Q-39% for heating by heater to td-24c.. you know the flow rat of…

A: Specific humidity and enthalpy values are estimated from the psychometric chart. Latent heat load is…

Q: Assume that the permeability of oxygen in the alveoli is P=4x10-8 cms-1. The P O2 in alveolar air is…

A:

Q: 3.8 moles of an ideal gas at 27.0°C expands isothermally from an initial volume of 20.0 dm³ to a…

A: Given that :n  =3.8 molT =27 C =27 + 273.15 =300.15 KV1=20 dm3V2=83.1 dm3constant external…

Q: Hello sir I study in chemical engineering 3rd sem please help to understand my class exercise  A…

A: Mach number is ratio of speed of object to that of sound. If mach number> 1 supersonic. =1 sonic…

Q: Crude oil is fractioned by two separating columns. The incoming crude oil is composed of, in weight…

A: Given that, The mass flow rate of stream 1 m1 = 1435 kg/h The composition of feed stream 1 (Weight…

Q: Given: Mass of 1-peso coins collected from Experiment 1. Sample No. Sample No. 1 6 2 7 3 8 4 5…

A:

Q: The time it takes to bake a bread at 120°C is 25 min. The same bread can be baked only in 360 s in…

A:

Q: Look at the Cu-Ni alloy in picture 1. After 700 hours of heat treatment at 1100 °C, the…

A:

Q: A homeowner uses 2431 m³ of natural gas in a year to heat a home. Assume that natural gas is all…

A: Given that, Volume of methane CH4 V = 2431 m3 Pressure P = 1.4 atm Temperature T = 26.5oC = 26.5 +…

Q: phase diagram

A:

Q: The molar volume of pure methanol is 40 cc/mole. Also, the volume of a solution containing 1000 g of…

A: Given: The pure species volume of methanol (1) is given as V1 = 40 cm3/mol The volume of the…

Q: If the solution X has a pH of 6 and solution Y has a hydronium ion concentration twice that of…

A:

Q: A vegetable after drying to moisture content of 5% dry basis (weight basis) is to be packaged…

A: Given data: Initial moisture content of vegetable = 5 % dy basis Final moisture content of vegetable…

Q: Steam enters an adiabatic turbine at 1.2 MPa and 451 °C and leaves at 129 °C with a quality of 44…

A: Given  Adiabatic turbine with Intel pressure P = 1.2MPa Intel temperature of turbine T = 451 oC At…

Q: 17.84: The following table shows the composition of (BaSr) Ti03 of 3 batches in weight percentages.…

A: The desired composition is 1:1:1 of Ba:Sr:Ti. However, the actual composition is not exactly 1:1:1.…

Q: PROBLEM 1 A mixture of dichloromethane (1) and ethyl acetate (2) and is separated in a flash drum at…

A: Hello Subscriber! There are multiple subparts to this question. As per our policy, we have solved…

Q: A benzene solution of an organic compound A analyses 10% of A. Th molality of the solution is…

A: The molality of the solution given is m = 0.62 Basis: 1 kg of solvent (benzene) The mole fraction of…

Q: 1.  A gas mixture is known to consist of CO2, N2 and H2O. It is analyzed by first passing it through…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: hs. = 2083 J/(kg-K)) flows through double pipe heat Ex25: Hot oil at a rate of 1.2 kg/s (Cp…

A: Given  Mass of Hot oil = 1.2 kg/s Overall heat trasfer cofficient U = 500 w/(m2 K)

Q: A large spherical storage tank, 2 m in diameter, is buried in the earth at a location where the…

A:

Q: The decanted sludge of 20,000 kg/h contains 5 weight % water, 10 weight % zinc sulfate and the…

A: INTRODUCTION - Target compounds in a solid raw material are leached by solvents in a process known…

Q: The composition of fuel gas is: 4% H2, 6% H₂S, 5% CO₂, 42% C3H8, and 43% C4H10 In every I mol of…

A: Given data: Composition of a gaseous fuel is as follows: H2 = 4 % H2S = 6 % CO2 = 5 % C3H8 = 42 %…

Q: Solid calcium fluoride (CaF2) reacts with sulfuric acid (H2SO4) to form solid calcium sulfate…

A: It is given that Fluorite ore is having 96.0 wt% CaF2 and 4.0 wt% SiO2. This calcium fluoride (CaF2)…

Q: Calculate the mass flux (kg/m2-s) for the following tank leaks given that the storage pressure is…

A: Introduction The rate of mass flow is referred to as mass flux in physics and engineering. kg/m2sare…

Q: Problem 3 Consider a 700 mol/h feed entering a flash distillation unit or still under isothermal…

A: Given, The feed rate, F = 700 mol/h The mole fraction of benzene, z = 0.45 The operating pressure, P…

Q: The "normal boiling point" is the temperature that a liquid will boil at 1 atm pressure. Most…

A:

Q: Refer to the following problem: The pressure drop for a fluid flowing through a packed bed of solids…

A:

Q: An evaporation-crystallization process

A:

Q: Propane gas at 85 oF and a gauge pressure of 1.5 atm flows into a reactor at a rate of 1412 kg/hr.…

A: Given  Temperature  =85 F Gauge pressure  = 1.5 atm Absolute pressure = 1+1.5…

Q: A 4.00 x 104 M solution of aniline in H₂0 has absorbance A = 0.504 at 280 nm, when measured in a…

A: Given that- Concentration of aniline solution 1= 4.0 x 10-4 M Absorbance of aniline in H2O, A=0.504…

Q: d. The flash drum is operated such that the liquid mole fraction is 33 mol % dichloromethane, liquid…

A:

Q: 7 evaporators are connected in series, i.e., the concentrated product of the first one is fed to the…

A: Introduction   Chemical engineers refer to a multiple-effect evaporator as a device for effectively…

Q: Determine the AASHTO and USCS classifications for the soil whose sieve analysis results are shown…

A:

Q: A stream of water from a fire hose with a flow rate of 320 gallons per minute and a speed of 35 m/s…

A:

Q: fuel/air mass ratio of the combustion of 80 moles toluene in air

A:

Q: a. Please give the proper base units for each property: Pressure (SI) Acceleration (CGS) b. True or…

A:

Q: There are 300 cubic meter/min of atmospheric air initially at 25 C wet bulb temperature and 60 % RH…

A:

Q: *9.36. Biodiesel fuel-a sustainable alternative to petroleum diesel as a transportation fuel-is…

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question…

Q: A rigid, well-insulated tank contains a two-phase mixture of ammonia with 0.0025 ft3 of saturated…

A:

Q: Using the figure below, the lower plate is being pulled at a relative velocity of 3.14 m/s greater…

A: Given, Viscosity of fluid = 2.75 centipoise = 0.00275 Pa-sec Distance between plates = 1.3 m Reality…

Q: Find the difference in pressure between tanks A and B, if d₁ = 2 ft, d₂ = 6 in, d² = 2.4 in, and d₁…

A: For a detailed solution, please see the attached files.

Q: The heart is effectively made up of two pumps that create flow through the human circulatory system…

A: Introduction  A pump is a tool that moves fluids (drinks or gases), or occasionally slurries, via…

Q: Copper is extracted from ore by a smelting facility using a fuel analyzing 25% methanol and 75%…

A: Given that- Fuel composition 1= 25% methanol + 75 % 1-propanol Price of fuel 1= ₱ 27.32 per liter…

Q: Assuming the validity of Raoult's law, do the calculations for the acetone(1)/tert-butanol (2)…

A: