2. The conducting rod shown in the accompanying figure moves along parallel metal rails that are 25-cm apart. The system is in a uniform magnetic field of strength 0.75 T, which is directed into the page. The resistances of the rod and the rails are negligible, but the section PQ has a resistance of 0.25 92. (a) What is the emf (including its sense) induced in the rod when it is moving to the right with a speed of 5.0 m/s? (b) What force is required to keep the rod moving at this speed? (c) What is the rate at which work is done by this force? (d) What is the power dissipated in the resistor? B x M xx x x X 0.25 Ω x x X X X X x x 25 cm x x * * N x 5.0 m/s

2. The conducting rod shown in the accompanying figure moves along parallel metal rails that are 25-cm apart. The system is in a uniform magnetic field of strength 0.75 T, which is directed into the page. The resistances of the rod and the rails are negligible, but the section PQ has a resistance of 0.25 92. (a) What is the emf (including its sense) induced in the rod when it is moving to the right with a speed of 5.0 m/s? (b) What force is required to keep the rod moving at this speed? (c) What is the rate at which work is done by this force? (d) What is the power dissipated in the resistor? B x M xx x x X 0.25 Ω x x X X X X x x 25 cm x x * * N x 5.0 m/s

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter13: Electromagnetic Induction

Section: Chapter Questions

Problem 69AP: The conducting rod shown in the accompanying figure moves along parallel metal rails that are 25-cm...

See similar textbooks

Similar questions

The accompanying figure shows a metal disk of inner radius r1 and other radius r2 rotating at an angular velocity while in a uniform magnetic field directed parallel to the rotational axis. The brush leads of voltmeter are connected to the dark's inner and outer surfaces as shown. What is the reading of the voltmeter ?
The magnetic flux through the loop shown in the accompanying figure varies with time according to m=2.00e3tsin(120t) , where m is in milliwebers. What are the direction and magnitude of the current through the 5.00 resistor at (a) t= 0; (b) t=2.17102 s and (c)t=3.00 s?
How is the percentage change in the strength of the magnetic field across the face of the toroid related to the percentage change in the radial distance from the axis of the toroid?
A solenoid is wound with 2000 turns pet meter. When the cuiient is 5.2 A, what is the magnetic field within the solenoid?
12.7 Check Your Understanding What is the ratio of the magnetic field produced from using a finite formula over the infinite approximation for an angle of (a) 85°? (b) 89°? The solenoid has 1000 mins in 50 cm with a current of 1.0 A flowing through the coils
A single-turn circular loop of wire of radius 50 mm lies in a plane perpendicular to a spatially uniform magnetic field. During a 0.10-s time interval, the magnitude of the field Increases uniformly from 200 to 300 mT. (a) Determine the emf Induced in the ioop. (b) If the magnetic field is directed out of the page, what is the direction of the cun-ent induced in the loop?
In the circuit sho in the accompanying figure, the rtd slides along the conducting rails at a constant VelOCity v. The velocity is in the same plane as the rails and directed at an angle 6 to them. A uniform magnetic field Bis directed out of the page. What is the emf induced in the r?
Is Ampere’s law valid for all closed paths? Why isn’t it normally useful for calculating a magnetic field?
Design a current loop that, when rotated in a uniform magnetic field of strength 0.10 T, will produce an emf =0 sin t. where 0=110V and 0=110V .
Check Your Understanding Shown below is a rod of length l that is rotated counterclockwise around the axis through O by the torque due to mg . Assuming that the rod is in a uniform magnetic field B , what is the emf induced between the ends of the rod when its angular velocity is ? Which end of the rod is at a higher potential?
The square armature coil of an alternating current generator has 200 turns and is 20.0 cm on side. When it rotates at 3600 rpm, its peak output voltage is 120 V. (a) Wliat is the frequency' of the output voltage? (b) What is the strength of the magnetic field in which the coil is turning?
In the August 1992 space shuttle flight, only 250 m of the conducting tether considered in Example 23.2 could be let out. A 40.0 V motional emf was generated in me Earth’s 5.00105T field, while moving at 7.80103m/s. What was the angle between the shuttle’s velocity and the Earth’s field, assuming the conductor was perpendicular to the field?