Answered: 2. Given the following two circuits,…

2. Given the following two circuits, find R and V, in circuit (a), and I and R in circuit (b). 0.3 mA Vs + (a) R P = 0.9 mW 16 V I (b) R P= 80 mW

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter23: Resistive-inductive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ

See similar textbooks

Related questions

Q: 17. Two storage batteries are connected in parallel to supply a load having a resistance of 0.12 The…

Q: √₂ Find the symbolic expression for the current 14. R₁ M √₂ m R₂ R3 Page 2 in R4

Q: The power absorbed by Gx in the following circuit is 40 mW. Find the value of Gx. 12 V(+ Gx

A: Given: A circuit, The power absorbed by Gx in the above circuit is 40 mW. To find: The value of…

Q: How do the capacitor and inductor support the circuit in power factor improvement?

A: Capacitors and inductors are commonly used in electrical circuits to improve the power factor, which…

Q: Determine Is in the circuit below in Amperes (A) + 4V Is + 4V 5A - 2V + till 2A 2A 6V

Q: Question: What is a logic gate in digital electronics, and how does it work?

A: We need to explain what is a logic gate in digital electronics, and how does it work .

Q: Oool + 10 ΚΩ 10 ΚΩ 4 mA Μ 310 ΚΩ V

A: I have written this solution as handwritten solution. Hope you find the perfect solution.

Q: For figure shown below, the Coulomb force between charges is same as weight of 1 kg mass. The…

A: Given figure: Two charges, Q1=Q2=1 μC. Mass, m = 1 kg Force, mg=1×10=10 N.

Q: refer to the circuit below, if R = 5 ohms, V1 = 10V, V2 = 4V and Is = 2A. R Vo V₂ what is the…

A: Concept Voltage in parallel branches will be same, and current in series branches will be same…

Q: 18. Two storage batteries, A and B, are connected in parallel to supply a load the resistance of…

A: Introduction Combination of batteries: When two or more batteries are connected together, their…

Q: Given the transfer function Vo(s) 6 A(s) s+3 compute the voltage vo(t) at the steady-state for a(t)…

Q: generator (b) What is the average power dissipated in R? P=[ W Help Enter 500 v generator voltage…

Q: A force of 12 N acts on a body of mass 4kg resting on a rough surface (coeffi- cient of friction is…

Q: 1.2) Find the standard form of the system model below. 4y(t) + 6y ()+14y (t) = 6x (t)

A: 1.2) To find the standard form of the given second order differential equation

Q: 1. viltx M 14 22 Find = G(s) = Vo(s) : V₁(s) 352 ww IF Volt)

A: Convert the given time domain circuit into S domain form using Laplace transform. Apply nodal…

Q: A unity feedback system has G(s) = 40(s+2) s(s+1)(s+4) The steady state error of the system with a…

A: Given: Forward gain, Gs=40s+2ss+1s+4 Ramp input magnitude, A = 5.

Q: Consider the system y = T[x] = x + b where x is the system input and y is the system output. Find a…

A: To find the value of 'b' that makes the system linear

Q: 2. Referring to Fig. 6, develop a formula that will give the voltage gain, V.V₁ in terms of F and…

Q: Find the first root (n=1) of the equation Sn tan n = 0.5

A: Given ζntanζn=0.5 To find the first root (n=1) of the equation.

Q: If the RMS phasor voltage accross an element is: Vrms = 350 29 ° Volts and the RMS current flowing…

A: Given Data: RMS voltage across an element Vrms=350∠29∘ V RMS current in the element Irms=5∠-22∘ A…

Q: a 252 m 352 b √ Rab=45, O Rab O Rab 14, 2 O Rab, 152 M. 3652 152

Q: 3. A conductor has 1.5 Amps running through it. In a time interval of 2.6 minutes, how many coulombs…

A: Q)3 given data, conductor current =1.5A time =2.6 min = 2.6*60=156sec we have to find Q pass…

Q: Use Tellegen's theorem to find I, in the circuit..

A: The required parameter can be calculated by applying passive sign conversion and then the by using…

Q: How the trailing current in IGBT is different from the MOSFET?

A: Trailing current is a phenomenon that occurs in both IGBTs (Insulated Gate Bipolar Transistors) and…

Q: The sacrifice factor of the op-amp is equal to Select one: O a. Aol + Acl O b. 1+ Aol B O c. Aol -…

A: Sacrifice factor : Sacrifice factor of op amp is defined as the ratio of open loop gain and close…

Q: The following circuits are given. Find the current ix. 36 mA (a) R 5ix R₁ 11 ix (b) 120 mA R₂ 24 mA

A: it is asked to find the current ix in given 2 circuits

Q: •1 Given the circuit below: R₁ 1₂ (t) Mycee R₂ L2 (alt) + Delt) 1. find the symbolic expression for…

A: Given the circuit,

Q: (а) A B THOOD фонон 1 1 1 Y 0 1 1 1 (b) A 0 000нннн 1 BOO в О оно C Y 1 1 1 0 0 1 1 HOLOH 1 1 1 0 0…

A: Given the following truth tablr. a) implement the function of given the truth table,(c) A B C Y…

Q: Compute the transfer function H(s) for the asymptotic magnitude Bode di- gram sketched below. All…

A: Given the bode a plote,

Q: 11. Apply the superposition theorem and find the current through 25 ohm resistance of the circuit…

A: Answer: given that a linear circuit with two independent sources

Q: R₁ 5.02 R₂ 78 &-24.0 V 0.10 E₂,-48.0V ű 0.500 Es- 6.0V 5 www 0.05 h P₂ www 40 R $200 >0.200 E 36.0 V

Q: Problem (3) Formulate a complete set of Node-Voltage equations to solve for the node voltages Va Vs…

Q: what is the current through the upper 3-ohm resistor? express answer in amperes

Q: Refer to the circuit below d 30 b 50. www www ≥302 www ww 302 a 20 U O what is the total current in…

A: In this question We need to determine the current I. We are solving this problem using the Delta to…

Q: Solve using kirchhoff's law

A: KVL Algebraic sum of voltage dros around the closed path is equal to zero. KCL Algebraic sum of…

Q: Refer to the circuit below and use nodal analysis 2A(+) 252 O to the left Va O to the right O…

A: We need to find out the current direction for given resistance in the the given circuit.

Q: 1. Find the Thevenin and Norton equivalent circuits for the active network shown in Fig. 2.241 (a).…

A: a) Thevenin & Norton Equivalent circuit is asking, to the given problem. We have to find Vth and…

Q: 6. The four arms of a Wheatstone bridge have the following resistances in ohms. AB= 100, BC= 10.…

Q: In a series circuit with the following devices to a 230volts 60Hz supply with a resistor in the…

A: Given data Supply voltage, Vs=230 V Supply frequency, f=60 Hz Resistor range; R=300 Ω to 990 Ω We…

Q: Determine which of the logic circuits In Figure bellow are equivalent. O O 'B' Select one: O O O E…

A: We need to select correct option for given logic diagram .

Q: 6. Use Millman's theorem, to find the potential of point A with respect to the ground in Fig. 2.243.…

A: 6) millman theorem, we have to find the potential at A point A respect to ground. First we can apply…

Q: 4. 15 C of charge pass through the following element from point A to B. If the element absorbs 250 J…

A: Here i am using below formulae for calculation s. Charge Q= C*V Energy E = 0.5 C*V2

Q: Find the force on a straight conductor of length 0.3 m in -k direction, carrying current of 5 A,…

A: Given: Straight conductor of length, l = 0.3 m in -k direction. Current carrying, I=5 A. Magnetic…

Q: For the output y(t) having a Laplace transform of: Y(s)=(s+21)/(s3+7s2+80s) Determine the final…

Q: Redo the question, a

A: It is given that: SS=150 KVAVP=3000 VVS=300 Vf= 50 HzVsupply=6250 V

Q: Problem (6): Suppose a multi-path system causes both a delay and amplitude change y(t) = x(t) +…

A: I have written this solution as handwritten solution. Hope you find the perfect solution.

Q: Determine the currents in the following circuit using the Kirchhoff's current rule and the voltage…

A: The given circuit diagram is shown below,

Q: Find the fundamental frequency wo and the Fourier series coefficients for the following signals (a)…

Q: 2. Obtain the Thevenin and Norton equivalent circuits for the circuit shown in Fig. 2.241 (b). All…

Q: The variable resistor (R0) in the circuit attached is adjusted for maximum power transfer to R0. a)…

A: The given question is based on the concept of maximum power transfer. It involves finding the value…

Concept explainers

Current Division Method

The generalized current divider formula is given by the following relation below,

Question

Given the following two circuits, find R and V, in
circuit (a), and I and R in circuit (b).
0.3 mA
Vs
+
(a)
R
P=
= 0.9 mW
16 V
I
(b)
R
= 80 mW

Expert Solution

Step 1

Given Data:

a. A single loop circuit with,

Current $I = 0.3 mA$
Power in the resistor $P = 0.3 mW$

b. A single loop circuit with,

Voltage $V = 16 V$
Power in the resistor $P = 80 mW$

To Find:

a. The values of $R & V_{s}$

b. The values of $I$ and $R$ .

Trending now

This is a popular solution!

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

For the following figure, find the total impedance and total current. Explain what is relation between XL and Xc. Find the voltage drops in inductor, capacitor and resistor. XL = 1.8 k VT-15 V R-450 www Xc-1.2 kn
Calculate the VOLTAGE and the CURRENT of C1, C2, L1, R1, R2 in the circuit. C1 & C2 are capacitors L1 is an inductor with 0.0078H R1 & R2 are resistors The source is an AC voltage source of 0.4 V
A 500 V dc source is impressed across two capacitors, 25 microfarad and 12.5 microfarad in series. How much energy is stored in the 25 microfarad capacitor? Draw the diagram.
Determine R₁, RE, Rc of the following for the given networks Vcc-9V Re R₁ R₂-20KQ 41 www h-101B 4₁ a=0.98 I=2 mA VCE=3V
In the following circuit, if R, -90 then INorton and RNorton between a & b are: O a PA 50
8. Find the following: a. the voltage across R5 (Vo) b. the current through R5 11 1A ES 10k R1 27k R4 18k 10k Vo R5 27k R7 12k R6 6.8k
Draw the output voltage waveform of the circuit shown. Label properly the values. 0 Vm T 2 T t + Vi www R +
Design a clamper circuit with the below waveform: -4 V -36 V
A series RL circuit contains two resistors and two inductors.The resistors are 33ohms and 47ohms.The inductors have inductive reactance of 60ohms and 30ohms. When calculating the circuit value, the total resistance used is?
can you explain to me a bit more, so I understand everything until you get the solution. I see how you got 25 angle -10 over 12.81 angle 20.55 but I don't understand how you got that solution from that division
An R-L series circuit contains a resistor and an inductor. The resistor has a value of 6.5 V. The circuit is connected to 120 V and has a current flow of 12 A. What is the inductive reactance of this circuit?
A RL series has two resistors and two inductors. The Z of the circuit is 1000 ohms. The XL of the inductors is 220 ohms and 470 ohms. one of the resistors has a resistance of 300 ohms. What is the resistance of the other resistor?