2. Consider the toroidal core in problem 2b of HW 22. a) Find an expression for the stored magnetic energy. b) Deter- mine self-inductance from magnetic energy.

Q: 2. Solve for the transfer function R G₁ H₁ H₂ G₂ G₁ H₂ G₁

A:

Q: The convolution between the two sequences x₁ (n) = [1, 2, 3] and x₂ (n) = [3, 2, 1] is y(n) = [1, 2,…

A: Given: Two discrete time sequences,  x1[n]=[1, 2, 3], x2[n]=[3, 2, 1],  To find: Convolution of…

Q: A three phase, 60 Hz, 6-poles induction motor has a full-load speed of at 1150 rpm and delivers…

A: Given data f=60 Hz P=6 NFL=1150 rmp Nreduced=960 rpm To find out We have to determine the ratio of…

Q: 1. Draw the I-V characteristic of diodes and show the breakdown voltage, knee voltage on the graph.…

A: The given table containing the data is shown below. We need to draw the I-V characteristics of…

Q: Convert each of the following transfer function into its difference equation a. H(z) b. H(z) = =…

A:

Q: 8p50) In the figure, a block slides along a track from one level to a higher level, by moving…

A: The given figure is shown below, Where,Initial speed, v0=7.7 m/s.Height, h=0.98m.Kinetic friction…

Q: Given a PNP transistor in the figure below, determine Vc and IB -22 V

A: In the given questions we need to do the DC analysis of the given circuit and need to calculate…

Q: Present State nextState Output z X=0 X=1 X=0 X=1 A B C D D A D G B B P с D l O O 1 оо using the…

A:

Q: Determine the impulse response for the system + y(n) + 4 y(n_l) + 3y(n=2) = X(n-1).

A: In this question we need to find the impulse response of the given system

Q: (c) A 4-bit ripple adder has inputs 1101 and 1001, and carry in = 0. What would the output of the…

A: Solution: Given data; input A 1101 input B 1001 carry 0 Determine: here find output of…

Q: Q2: Repeat Q1 for a band-stop filter having the ideal response: TT 1, |w|≤ = 0, Ha(w)= = 1, 7673…

A: Given: Frequency response of a digital filter,  Hdω=1;ω≤π60;π6<ω≤π31;π3≤ω≤π, To find: Coefficient…

Q: Q-2) A non-uniform surface current density flows as: = {ªlor'sin (r) over S': (a≤r'≤ 2a, 0 ≤ 4' <…

A: According to the question, for the given geometry as shown below A non-uniform surface current…

Q: For the circuit shown below, find the value of AVO, if duty ratio of switch is 0.4 and it is…

A: Buck-Boost convertor Duty ratio, α = 0.4 Frequency, f = 25kHz

Q: Q-A 200 V, 10 A, 1000 rpm, separately excited d.c. motor has an armature resistance of 30. The motor…

A:

Q: 5. There is a circuit with two resistors in parallel that are connected to a 12V battery. The…

A: In this question we need to find the current through other resistor.

Q: 2. Plastic kayaks are manufactured using a process called rotomolding. Molten plastic is injected…

A:

Q: Learning Goal: To use information about the power provided by a source or absorbed by a load to…

A:

Q: Problem 2: In the switch-based circuit below, the switch is in position A from a long time, then…

A: The above question is based on the transient analysis of a 2nd order circuit. Since multiple…

Q: A single-phase transformer has resistance and reactance of 0.2 pu and 0.6 pu respectively. Its pu…

A:

Q: Compare ASK, PSK and FSK digital modulation schemes. Explain advantages and disadvantages of all…

A: Comparison of digital modulation techniques ASK, PSK and FSK.

Q: What are the two turns ratios which maximize the power rating increase of an autotransformer in…

A:

Q: In the given figure are pole-zero plots of transfer functions of the systems of the general form H()…

A: In this question we need to choose a correct option

Q: a. Solve 72210+ 1010 in binary. -1 b. Solve 72210- 1010 in binary. 722 = 10 // 0 / 00/0 (0= 10/0…

A: To Solve: 72210 /1010 in binary 72210 - 1010 in binary 72210 x 1010 in binary

Q: The output y(k) of a discrete-time system is given by y(k)= u(k+2)-u(k-2) where k is an integer…

A: Given Data: An output of a system is, yk=uk+2. uk-2 Where, uk=Discrete Unit Step Sequence To…

Q: ere is a collection of 100 ohms and 10 ohms resistors. Design a circuit, with min number of…

A:

Q: b) In the circuit in the diagram below the meter M which has the internal resistance R goes to…

A: The given circuit is shown below. In the circuit in the diagram below the meter M has an internal…

Q: Vi 3 v + 1 Fig. 1 Vi R₁ TTİNT Fig. 2 R

A:

Q: For C1=10 F, C2=21 F, C3=31 F, C4-60 F, C5=48 F, C6-43 F, C7=76 F, C8-19 F & C9=16 F in the circuit…

A:

Q: A 50-kW, 440-V, 50-Hz, six-pole induction motor has a slip of 6 percent when operating at full-load…

A:

Q: Problem Three A closed loop feedback control system for a DC motor with speed control is shown…

A:

Q: I just need the algebraic manipulation using the given Equation

A: The given equation is,YsUs=Ks2+4+7Ks1+Ks2+4+7Ks.Here,We have to simplify the given equation.

Q: The resistor R, in the circuit in the figure is adjusted until the ideal op amp saturates. (Figure…

A:

Q: Two wattmeter method is used for measurement of power in balanced three-phase load supplied from a…

A: Two wattmeter method- Balanced three-phase load- Reading of one of the wattmeters is half of the…

Q: Plot the nyquist plot for the system +2 5+1 (5+5) (5² +45 +4) X(s) - D Ye

A: According to the question, for the given system as shown below We need to draw Nyquist plot of the…

Q: What is the value of A?   What is the value of w ? What is the value of Q(theta) ?

A: In this question we need to find the value of A , w and θ show in voltage expression.

Q: Determine the voltage V2 shown in the circuit, consider the following: * IB =?; I₁ = 52 - 18° A; I₂…

A: For the given circuit the node voltage and the current between the two node need to be calculated…

Q: 4) Calculate the maximum transmission distance for a fiber link with attenuation of 0.5db/km if mput…

A: For a fiber link with, Attenuation of 0.5 dB/km. Input launch power is 200 μW. Optical output power…

Q: Given the following logic function: F = x’y’z’ + xyz + xy’z + x’yz’ Draw the logic diagram after…

A: Need to simplify the given boolean expression and the same need to be constructed in logisim and…

Q: Problem 1. A signal x(t) with frequency as given an ADC (Analog to Digital Converter) running at…

A: Analog to Digital Converter:   When a continuous time domain signal is passed through the ADC it…

Q: Find the power dissipated in the 3 k2 resistor in the circuit in Figure 1. 750 Ω 192 V + 15 ΚΩ 3 ΚΩ…

A: In this question,  We need to determine the power dissipated in the 3k ohm resistance.  We know…

Q: a) What is the largest voltage that you can apply to a 1kΩ resistor that can dissipate up to 0.25 W?…

A: In part a, we need to find the maximum voltage that can be applied across a resistor for the given…

Q: A full wave rectifier instrument calibrated on sine wave indicating 3.33 V for a triangular input.…

A: A full wave rectifier instrument- Indicated value = 3.33 V for a triangular input.   To Find- The %…

Q: H(s): 6s² + 18s +12 2s³ +10s² +16s+12

A:

Q: The current, i, through a capacitor depends on time, t, and is given by i= c() where V is the…

A: In this question We need to determine the  voltage across the terminal capacitor.  Given current in…

Q: A system has the unit sample response h(n) given by h(n)=-u(n) + 3u(n-4)-2u(n-7) (a) Is the system…

A: As per the guidelines of Bartleby we suppose to answer first three subpart only for solution of…

Q: 2. Find i, (in microamperes) in the circuit in Figure 2. SV 10 ΚΩ www 6ΚΩ {3 ΚΩ Figure 2 5 ΚΩ SV -SV…

A: To find iL (in microamperes) in the given circuit. The circuit diagram is,

Q: EXAMPLE 5.2 For the network of Fig. 5.28, determine: a. re. b. Zi. c. Zo (ro = ο Ω). d. Ay (ro = ο…

A:

Q: Two SCRs are used in a midpoint converter arrangement. The source RMS voltage is 230 V, and the…

A: phase voltage = 230 V frequency F = 50 HZ inductor (load side ) = 100 millihenry inductor (source…

Q: 19. R1=5000 2 in a non-inverting amplifier whose gain = 5.3. What is R2?

A:

Q: What type of filter the following amplifier represents? Ignore transistor high frequency parasitic…

A: Need to identify the type of filter that the given circuit act based on the given conditions.

Type of Magnetic Material

Every material has a unique composition that defines its magnetic behavior. Some materials get attracted towards a magnet and are called magnetic materials. Based on the magnetic properties held by each material, they are classified into different types.