2-64 Nitrogen enters a steady-flow heat exchanger at 150 kPa, 10°C, and 100 m/s, and it receives heat in the amount of 120 kJ/kg as it flows through it. Nitrogen leaves the heat exchanger at 100 kPa with a velocity of 200 m/s. Determine the Mach number of the nitrogen at the inlet and the exit of the heat exchanger.

2-64 Nitrogen enters a steady-flow heat exchanger at 150 kPa, 10°C, and 100 m/s, and it receives heat in the amount of 120 kJ/kg as it flows through it. Nitrogen leaves the heat exchanger at 100 kPa with a velocity of 200 m/s. Determine the Mach number of the nitrogen at the inlet and the exit of the heat exchanger.

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter11: Temperature And Temperature- Related Variables In Engineering

Section: Chapter Questions

Problem 40P

See similar textbooks

Similar questions

The second stage nitrification process is :presented by the following equation Nitrobacter 2NO2+ 02 -> 2NO3 Give the value of Oxygen Required for this ?stage in Ib / IbN oxidized إختر أحد الخيارات 4.57 .a O 1.0 .b O 1.14 .c O 3.43 .d O
problem 5.3 Consider a steam power plant that operates on the ideal reheat Rankine cycle. The plant maintains the boiler at 5000 kPa, the reheat section at 1200 kPa, and the condenser at 20 kPa. The mixture quality at the exit of both turbines is 96 percent. Determine the temperature at the inlet of each turbine and the cycle's thermal efficiency. Answers: 327°C, 481°C, 35.0 percent High-P turbine Low-P turbine Reheater Boiler Condenser 2 Pump
Problem 2 Refrigerant-134a enters the compressor of a refrigeration system as saturated vapor at 0.16 MPa, and leaves as superheated vapor at 0.9 MPa and 70°C at a rate of 0.08 kg/s. Determine the rates of energy transfers by mass into and out of the compressor. Assume the kinetic and potential energies are negligible.
1) A cylinder of volume 50cm made of Pyrex glass is full to the brim with acetone. Suppose the cylinder and acetone are warmed by 30°C. (Coefficient of linear expansion of glass, 3.2 x 10-6K-1 and acetone, 5.0 x 10-5K-1) i. Calculate the change in volume of the glass. ii. Calculate the change in volume of the acetone. ii. Will any acetone spill out of the cylinder? Explain.
Several liquids are layered inside a tank with pressur- ized air at the top. If the air pressure is 3.2 kPa, calcu- late the pressure at the bottom of the tank if the lay- ers include 20 cm of SAE 10 oil, 10 cm of water, 15 cm of glycerin, and 18 cm of carbon tetrachloride.
Calculate the specific heat of the material in J/g-deg C if material of 10 kilograms raises by 2 deg C when 2000 joules of heat is added. O 100 O 50 O 0.1 O 0.2 O none of the above
Consider 5.0 pounds per minute of water vapor at 100 lb/in², 500°F, and a velocity of 100 ft/s entering a nozzle operating at steady state and expanding adiabatically to the exit, where the pressure is 40 lb/in². The isentropic nozzle efficiency is 85.0%. Determine the velocity of the steam at the exit, in ft/s, and the rate of entropy production, in Btu/min-°R.
Steam enters a turbine at 15bar and 600°C with a rate of 0.371 kg/s. The steam expands to 0.08 bar with quality at 90%. Stray heat transfer and kinetic and potential energy effects are negligible. For operation at steady state, • the volume flowrate at the turbine outlet is m³/s, ⚫the power developed by the turbine is ⚫and the temperature at the turbine exit is kW, °C.
A vapor compression refrigeration cycle uses steam as the working fluid. Steamflows steadily with a mass ow rate of 0.5 kg/s. Saturated vapor at 2.0 o C (State 1) enters an uninsulated compressor and it is compressed to 0.35 bar (State 2). Heat transfer at the rate of 105 kJ/s occurs from the compressor to its surroundings and the heat transfer exactly balances the entropy generation rate so that s2 = s1. The boundary and surrounding temperature of the compressor is measured to be 26.67 o C. Steam exits as saturated liquid at 0.34 bar (State 3) from the condenser. Steam leaving the condenser is then throttled in an expansion valve (State 4) before entering a constant pressure evaporator to complete the thermodynamic cycle. (a) Calculate the power (kJ/s) for the compressor. (b) Determine the isentropic efficiency (%) of the compressor. (c) Calculate the entropy generation for the compressor. (d) Find the coefficient of performance of the refrigeration cycle. (e) Show the cycle on T-s…
B. A Carnot engine operates between two temperature reservoirs maintained at 200°C and 20 °C, respectively. If the desired output of the engine is 15 kW, as shown in Fig. below, determine the heat transfer from the high-temperature reservoir and the heat transfer to the low-temperature reservoir. TH-200°C On Engine QL T₁ - 20°C W 15 kW
A closed system undergoes a cycle consisting of two processes. During the first process, which starts at an initial system pressure of 1.00 atm and system temperature of 300K, 60 kJ of heat is transferred from the system while 25 kJ of work is done on the system. At the end of the first process, the system pressure is 0.5 atm. During the second process, 15 kJ of work is done by the system. The temperature and pressure of the surroundings are constant throughout at 300K and one atm, respectively. Determine Q, W, ΔU and ΔH for the cycle.
..............Wh@t is the equivalent head of kerosene (s=.9) annd mercury( s=14.2). For a 4m head of water.......