14. When an individual is in water, the convective heat loss term is grea:ty increased. For water immersion, K, 16.5 kcal/m hr'C. Assuming the BMR of a resting man is 72 kcal/hr, find the water temperature at which the water heat loss is just balanced by the BMR. Assume A, =1.75 m2 andT, = 34°C. %3D

14. When an individual is in water, the convective heat loss term is grea:ty increased. For water immersion, K, 16.5 kcal/m hr'C. Assuming the BMR of a resting man is 72 kcal/hr, find the water temperature at which the water heat loss is just balanced by the BMR. Assume A, =1.75 m2 andT, = 34°C. %3D

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter8: Natural Convection

Section: Chapter Questions

Problem 8.19P

See similar textbooks

Similar questions

How much energy (in Joules) is required to fully melt 20g of ice taken from the freezer at - 5 degree C (negative 5 C), put on a stove and gently heated until fully molten?
A Metal container with a mass of 2 kg and containing 2.30 kg of water is put it on a fire. Assume that there is no heat exchange with the surrounding, how much heat must be added to raise the temperature from 20.0 o C to 80.0 o C. (CAl= 910 j/kg•K and Cwater=4190 j/kg•K)
24/. The heat absorbed to raise the temperature of 430 kg of water is 604569 J and specific heat capacity of the material is 4.26 J/kg. K. Find the temperature of the water in ⁰C.
Q.10 A chemical processing shop having a larg latent heat gain is required to bea conditioned. The design condition and loads are as follow. Outside design condition. .......... 40°C DBT and 27° WBT Inside design condition ............ 25°C DBT and 50% RH Room sensible heat. .35 kW Room latent heat Ventilation air requirenient is 80 cnim. Find out the following. ) Yentilation load ( Room and effective sensible heat factors (ii) Amount of reheat if ADP is 10.8C (tv) Supply air quantity (v) Temperature of air entering and leaving the coil (vi) Grand total heat. Assume suitable BPF.
A 0.41 m^3 air tank is pressurized to 5.17 MPa. When the temperature reaches -13deg C, calculate the air mass in kg. a.76.3 b.28.4 c.69.3 d.32.0
Air from the discharge of a compressor enters a 1 m3 storage tank. The initial air pressure in the tank is 500kPa, and the temperature is 600 ⁰K. The tank cools, and the internal energy decreases by 213 kJ/kg. Determine the ff: a.) The Work done, b.) The heat Loss (unit in KJ), c.) The change in enthalpy, d.) The final Temperature.
0.20 .l 12:42 景令60 ... KB/s laung mateilais, (C) nquius, (u) gases: 9. Suppose a person stated that heat cannot be transferred in a vacuum. How do you respond? 10. Review any standard text on thermodynamics and define: (a) heat, (b) internal energy, (c) work, (d) enthalpy. 11. Define and discuss ge. LIST OF WORKED EXAMPLES 1-1 Conduction through copper plate 1-2 Convection calculation 1-3 Multimode heat transfer 1-4 Heat source and convection 1-5 Radiation heat transfer 1-6 Total heat loss by convection and radiation PROBLEMS 1-1 If 3 kW is conducted through a section of insulating material 0.6 m2 in cross section and 2.5 cm thick and the thermal conductivity may be taken as 0.2 W/m - °C, compute the temperature difference across the material. 1-2 A temperature difference of 85°C is impressed across a fiberglass layer of 13 cm thickness. The thermal conductivity of the fiberglass is 0.035 W/m - °C. Compute the heat transferred through the material per hour per unit area. 1-3 A…
Find the specific heat at constant pressure of nitrogen gas with a molecular mass of 28 g/mol and specific heat at constant volume of 740 J/kg.K A. 1076 J/kg-K B. 1540 J/kg-K C. 2709 J/kg-K D. 1036 J/kg-K
An auditorium of 150 seating capacity is conditioned for the given specifications. Succasshy snd Outdoor conditions .32°C and 65% R.H Required air inlet conditions.... .24°C and 55 % R.H. The quantity of air supplied .0.5 m /min/person. The required condition is achieved first by cooling and dehumidifying and then by heating. Find the following: a) the capacity of the cooling coil in tons of refrigeration b) the capacity of heating coil in kW. c) By-pass factor of the heating coil if the surface temperature of the coil is 22°C.
5. Two kilogram of certain gas with R = 0.218 kJ/kg-Kundergoes a process and results to the following changes: AH= 2190 kJ, AU = 1460 kl. D. What is the change in termperature?
15. 1.4 m' of a gas at a pressure of 1.26 bar is compressed to a volume of 0.28 m³. The final is 7 bar. Assuming the compression to be polytropic, calculate the heat transfer and change in internal energy. Assume y- 1.4. pressure
A cylihder ftted with a pi3 ton contans water at 16 bar and 400C.Water 3 Cooled by following two in series paths (Consecutively) Path 1-2 :water 3 Cooled to saturated while presswe vapor state remans Constaut. Path 2-3: water r3 Cooled to the pressure of 8 bar while volume remans constart. a) Sketch a both paths on P-v and T-y diagramd 6) what B the temperatwe of the at the end of the water process? c) Determihe the final state of water, If As mixture, evaluate the quality (x). d) Calcula te the work as kJ lkg for overall process. e) Calculate the heat trasfer as gikg for overall process.