14) the difference between internal generated voltage and output voltage in synchronous generatorcaused by:A. armature reactionB. The self-inductance of the armature coilsC. The resistance of the armature coilsD. The effect of salient-pole rotor shapesE. All above15) A 6-pole, 50-Hz, 3-9 induction motor is running at 950 rpm and has rotor Cu loss of 5 kW. Itsrotor input is ..kW.А. 100В. 10С. 10000D. 95E. 95011) A centrifugal switch is used to dis- connect 'starting winding when motor has:A. run for about 1 minuteB. run for about 5 minutesC. picked up about 50 to 70 per cent of rated speedD. picked up about 10 to 25 per cent of rated speedE. picked up about 0 to 10 per cent of rated speed12)If starting winding of a single-phase induction motor is left in the circuit, it will:A. run fasterB. spark at light loadsC. draw excessive current and overheatD. run slowerE. spark at rated loads13)The capacitors used in single-phase capacitor motors have no:A. voltage ratingB. dielectric mediumC. polarity markingD. definite valueE. All above

As per guidelines given to us,we can only provide the solution of first question in multiple type of…

14) the difference between internal generated voltage and output voltage in synchronous generator caused by: A. armature reaction B. The self-inductance of the armature coils C. The resistance of the armature coils D. The effect of salient-pole rotor shapes E. All above 15) A 6-pole, 50-Hz, 3-p induction motor is running at 950 rpm and has rotor Cu loss of 5 kW. Its rotor input is ..kW. А. 100 В. 10 С. 10000 D. 95 E. 950

14) the difference between internal generated voltage and output voltage in synchronous generator caused by: A. armature reaction B. The self-inductance of the armature coils C. The resistance of the armature coils D. The effect of salient-pole rotor shapes E. All above 15) A 6-pole, 50-Hz, 3-p induction motor is running at 950 rpm and has rotor Cu loss of 5 kW. Its rotor input is ..kW. А. 100 В. 10 С. 10000 D. 95 E. 950

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Discuss the effects of rotor resistance in T-S characteristics of 3 phase induction motor.
What are the various losses in an induction motor? On what factors do they depend? IV. V. List the different types of stray load losses in an induction motor.
Explain the conditions for parallel operation of synchronous generators. A three phase, wye connected, synchronous generator is rated 150 MW, 0.85 lagging power factor, 12.6 kV, 60 Hz, and 1800 rpm. Each winding has an armature resistance of 0.05Q and a synchronous reactance of 0.6Q. Draw the phasor diagram with values, show torque angle and determine the induced voltage for the condition of rated load.
7 A three-phase, 60-cycle, 32-pole synchronous generator has a sinusoidally distributed air-gap flux of 0.025 weber/pole. The armature core has 324 slots. The armature winding is Y-connected. There are two coil sides per slot and two turns per coil. The coil pitch is 9 slots. Find the generated voltage between the line terminals. Ans. 2,445 V
1. 2. 4. 4. •.. .... ..... .... E.g. • 2. A 3 phase, 460 V, 10hp, 60 Hz, four-pole induction machine delivers rated output power at a slip of 0.05. determine the a. Synchronous speed and motor speed b. speed of the rotating air gad field c. frequency of the rotor circuit d. Slip in rpm e. Speed of the rotor field relative to the i. rotor structure ii. Stator structure iii Stator rotating field f. haft torque of this motor at the rated load? ... .... Equivalent Circuit • The induction motor consists of a two magnetically connected systems: Stator and rotor • This is similar to a transformer that also has two magnetically connected systems: primary and secondary windings. • The induction motor is similar to the transformer with the excention that its secondarv windings are free to.
The resistance and reactance per phase of the rotor of a 3-phase induction motor are 0.6 ohm and 5 ohms respectively. The induction motor has a star-connected rotor and when the stator is connected to a supply of normal voltage, the induced e.m.f. between the slip rings at standstill is 80 V. Calculate the current in each phase and the power factor at starting when (i) the slip-rings are shorted, (ii) slip-rings are connected to a star-connected resistance of 4 ohm per phase.
A value of magnetizing current in a 3-phase induction motor * gives power factor smaller .. larger smaller. .poor large . better O large...poor O
i. Briefly describe the 5 major types of DC generators according to the manner in which their field flux is produced.
1.5 A 10‐pole, 380 ‐V, 50 Hz, D‐connected three‐phase induction motor is rotating a quarry belt conveyor. The machine has the following parameters, referred to the stator, on a per phase basis: Stator Parameters Winding Resistance................0.19 Ω ......... Winding Reactance.................1.12 Ω.......... Rotor Parameters Winding Resistance......................0.29 Ω Winding Reactance.....................1.12 Ω Magnetising Reactance................................16.8 Ω Equivalent Core‐loss Resistance....................900 Ω. The friction and windage losses are 320 W. When the motor runs at its rated slip of 2.6 %. Determine: 1.5.1 The stator current. 1.5.2 Estimate the Output torque of the motor under the rated conditions. 1.5.3 The Motor…
6- In a stepper motor, how is the speed of rotation determined? a) By the current supplied to the motor. b) By the magnitude of the voltage applied. c) By the load applied to the motor. d) By the frequency of the waveforms used. 7- A transformer core is laminated to a) reduce hysteresis loss b) reduce eddy current losses c) reduce copper losses d) reduce all above losses 8- An induction motor with 580 r.p.m. speed at 60 Hz will have a) 8 poles b) 6 poles c) 4 poles d) 2 poles 9- If any two phases for an induction motor are interchanged a) the motor will run in reverse direction b) the motor will run at reduced speed c) the motor will not run d) the motor will burn 10- No-Load speed of which of the following motor will be highest? a) Shunt motor b) Series motor c) Short-Shunt compound motor d) Long-Shunt compound motor
Three Phase Induction Mot... The relative speed of stator magnetic field with respect to rotor of a 30 induction motor with 4 pole, 50 Hz frequency. If the slip is 0.05.
Q / What is the benefit, purpose and conclusions of making single-phase induction motors ..?