10. Consider the complicated arrangement below: ol mi bega aldaco wo bosce ond ltod berdos and od dreamse 1 m2vo goe The coefficient of friction between m1 and the plane is µ1 and between m2 and the plane is µ2. Assuming a massless, unstretchable string and a frictionless pulley, obtain the relationship between the variables that determines which mass goes up and which goes down.

10. Consider the complicated arrangement below: ol mi bega aldaco wo bosce ond ltod berdos and od dreamse 1 m2vo goe The coefficient of friction between m1 and the plane is µ1 and between m2 and the plane is µ2. Assuming a massless, unstretchable string and a frictionless pulley, obtain the relationship between the variables that determines which mass goes up and which goes down.

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter6: Applications Of Newton's Laws

Section: Chapter Questions

Problem 123AP: Two blocks connected by a string are pulled across a horizontal surface by a force applied to one of...

See similar textbooks

Similar questions

Check Your Understanding A block of mass 1.0 kg rests on a horizontal surface. The frictional coefficients for the block and surface are s=0.50and k=0.40 . (a) What is the minimum horizontal force required to move the block? (b) What is the block’s acceleration when this force is applied?
(a) What is the maximum frictional force in the knee joint of a person who supports 66.0 kg of her mass on that knee? (b) During strenuous exercise, it is possible to exert forces to the joints that are easily 10 times greater than the weight being supported. What is the maximum force of friction under such conditions? The frictional forces in joints are relatively small in all circumstances except when the joints deteriorate, such as from injury or arthritis. Increased frictional forces can cause further damage and pam.
As shown below, the coefficient of kinetic friction between the surface and the larger block is 0.20, and the coefficient of kinetic friction between the surface and the smaller block is 0.30. lf F=10Nand M=1.0kg , what is the tension in the connecting string?
A person doing a chin-up weighs 700 N, exclusive of the arms. During the first 25.0 cm of the lift, each arm exerts an upward force of 355 N on the torso. If the upward movement starts from rest, what is the persons velocity at that point?
A skydiver is at an altitude of 1520 m. After 10.0 seconds of free fall, he opens his parachute and finds that the air resistance, FD , is given by the formula FD=bv , where bis a constant and vis the velocity. If b=0.750 , and the mass of the skydiver is 82.0 kg, first set up differential equations for the velocity and the position, and then find: (a) the speed of the skydiver when the parachute opens, (b) the distance fallen before the parachute opens, (c) the terminal velocity after the parachute opens (find the limiting velocity), and (d) the time the skydiver is in the air after the parachute opens.
A student is attempting to move a 30-kg mini-fridge into her dorm room. During a moment of Inattention, the mini-fridge slides down a 35 degree incline at constant speed when she applies a force of 25 N acting up and parallel to the Incline. What is the coefficient of kinetic friction between the fridge and the surface of the incline?
A particle of mass 2.0 kg is acted on by a single force (a) What is the particle’s acceleration? (b) If the particle starts at rests how far does it travel in the first 5.0 s?
Two blocks connected by a string are pulled across a horizontal surface by a force applied to one of the blocks, as shown below. The coefficient of kinetic friction between the blocks and the surface is 0.25. If each block has an acceleration of 2.0m/s2to the right, what is the magnitude Fof the applied force?
In the following figure m = 20.0 kg and a622 The coetticient of kinetic friction betwoen the biock and the incline is a -0.40 (Eigure 1) Part A What must be the mass my of the hanging block ifit ia to descend 14.5 m in the tinst 3.00 s after the system is neleaned from rest? Express your anewer with the appropriate units. Figure t of 1 my Value Units Submit Bequest Aner Provide Feedback Next>
A 250.0 N box is placed on a horizontal surface and a force of 150 N is applied at anangle of 30.0o from the horizontal. As a result, the box slides along the surface with anacceleration of 05.00 m/s2What is the coefficient of friction between the box and the surface?
You are climbing on a hill that is inclined at 15degrees with the horizontal and you wish tobuild a rope tow to pull yourself up. Ignoring friction, calculate the tension you needed on therope to give your body that has a mass of 45kg a 1.5 m/s^2 acceleration. What if you are toconsider the friction of 100N, what is the value of the tension and coefficient of friction?
A box of mass 100.0kg rests on level ground and there is no friction between the box and theground. Resting on top of that mass is a 40.0kg mass with friction coecient that's unknown. A ropeis tied to the 100.0 kg mass and draped over a pulley from which a third mass hangs. How much massmust the hanging mass have in order for the acceleration of all masses to be 5ms2 ? What is the minimum possible friction coecient of the 40.0kg mass in the prior problem?