0cm diameter well fully penetrates an unconfined aquifer with saturate thickness ho-60m and hydraulic conductivity K-9x10-3 m/min, calculate the drawdown at point k and the drawdown at the pumping well, assume ro=120m mear an impervious boundary. The well is being pumped at a constant rate of 1.5m³/min. Impervious boudary

0cm diameter well fully penetrates an unconfined aquifer with saturate thickness ho-60m and hydraulic conductivity K-9x10-3 m/min, calculate the drawdown at point k and the drawdown at the pumping well, assume ro=120m mear an impervious boundary. The well is being pumped at a constant rate of 1.5m³/min. Impervious boudary

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter6: Hydraulic Conductivity

Section: Chapter Questions

Problem 6.15P

See similar textbooks

Similar questions

Q2) A fully penetrating well of diameter 0.3 m is located in an uncontined aquifer of saturated depth 45 m. If the drawdown in the well is 15 m for the discharge of 1200 m³/day and the radius of influence is 300 m, compute hydraulic conductivity?
A 12 inch diameter well was installed in an unconfined aquifer consisting of a 60 foot thick layer of sand. The water table was 15 feet below the ground surface before pumping of the well began. The well was then pumped at a rate of 30 gallons per minute and the water level in the well dropped to 45 feet below the ground surface after a steady-state condition was reached. The radius of well influence is 4000 feet. a) Calculate the permeability of the sand b) Compute and plot the drawdown surface
The wells shown below are in a leaky confined aquifer. The aquifer has a hydraulic conductivity of 30 ft/d, saturated thickness of 45.0 ft, and storage coefficient of 0.00080. The aquitard above has a thickness of 8.0 ft and vertical conductivity of 0.45 ft/d. Well A was turned on at noon Sunday with a flow rate of 150 gpm. Well B was turned on at noon Tuesday with a flow rate of 200 gpm. Find the total drawdown in ft at the observation well C at noon Thursday. 150 ft 350 ft 150 ft
Assignment no. 3 Problem # 1. A 300 mm diameter test well penetrates 24 m. below the static water table. After 24 hours of pumping at 69 liters/sec. The water level in an observation well at a distance of 96m from the test well is lowered 0.60m. And the other observation well at a distance of 34m from the test well, the drawdown is 1.2m. a. Compute the coefficient of permeability of the unconfined aquifer in m/day. b. Compute the transmissibility of the unconfined aquifer in m2/day. Compute the transmissibility of a confined aquifer 8m. thick below the unconfined aquifer in m2/day. I.
Question Two An unconfined aquifer with a well pumping 0.4m3/s and saturated thickness is 24m.lf the drawdown 50m from the well is 1m and the drawdown 100m from the well is 0.5m, calculate the hydraulic conductivity and transmissivity of the aquifer.The solution should include a labeled diagram.
Don't copy from other solutions thank you. Three piezometers have been installed in the confined aquifer having a uniform thickness of 4.6 m. and hydraulic conductivity of 2 x 104 m/s. a) Compute the hydraulic grądient. b) Compute the transmissivity in m2/day. c) Compute the flow rate per unit width of the aquifer in liters/day.
Question- Well Hydraulics Civil Engg. A 20cm well penetrated directly into a confined aquifer of permeability 4.4x10 m/s is with a thickness of 12m. Under steady state condition, the radius of influence is 150m and the drawdown is 3m. The discharge is..?
6.8 Calculate the hydraulic detention time (0) of a CSTR with settled-solids recycle if Y = 0.6 g VSS,/g BOD,| ĝ = 20 g BOD,/g VSS,-d K = 20 mg BOD¸/1 b = 0.25/d f, = 0.8 S° = 10,000 mg BOD,/1 X_ = 4000 mg/1 X = 0 0. = 6 d Q = 1000 m³/d %3D Discuss the practicality of treating this rather high-strength soluble wastewater by this method.
A 30 cm diameter well completely 15 points penetrates a confined aquifer of permeability of 45 m/day. The thickness of the aquifer is 20 m. Under steady state of pumping the drawdown at the well found to be 3.0 m and the radius of influence was 300 m. Calculate the discharge of the well * Pumping well dia = 2r + Original piezometric surface Piezometric surface under pumping Aquiclude Flow Confined aquifer Aquiclude Well Operating in a Confined Aquifer 1.548 m^3/min 0.0258 m^3/min 0.258 m^3/min 0.0851 m^3/min
B- A 20cm diameter well penetrates fully a confined aquifer of thickness 25m .when the well is pumped at a rate of 200 liters/ minute the drawdown in two observaƟons wells located at 10m and 100m distance from center of well are found to be 3.5m and 0.05 m respectively .calculate the hydraulic conductivity of the aquifer and the radius of influence and the drawdown in the well.?
ASAP
Please answer with complete solution and Fbd. A field sample of an unconfined aquifer is packed in a test cylinder. The length and diameter of the cylinder are 60cm and 8cm, respectively. The field sample is tested for a period of 2min under a constant head difference of 18.5 cm. As a result, 50cm3 of water is collected at the outlet. Determine the hydraulic conductivity of the aquifer sample.