.a. There may be installations where grounded conductors of different systems are installed within the same raceway, cable, or box. In these cases, it's imperative that the system-grounded conductors remain A. spliced. B. disconnected. C. separated. D. buried. 3.b. In dwelling units, the maximum allowable voltage between conductors that supply lighting fixtures is A. 220 V. B. 120 V. C. 115 V. D. 110 V.

Q: If the diode is open in the figure shown, the anode-cathode voltage of the diode is * R1 -12.7 V…

A:

Q: Two single phase transformers A and B with equal turns ratio have reactance of j3.2 and j19.2…

A:

Q: R(s) R(s)=1/s 1 Y(s) Ts+1 Figure 3 first order control system

A: For the given first order system we need to find its unit step response.

Q: For the circuit shown below, determine the current in the 10-V emf whene=12V 10 V 上 5.00 wwww […

A: Given circuit: E=12 V

Q: Explain the computational procedure of load flow by "fast decoupled load flow" method

A:

Q: Determine the convolution of the signals by means of the z-transform. x₁(n) = (¹u(n-1), x₂(n) = [1 +…

A:

Q: 10.a. Installation of electric-discharge auxiliary equipment (such as fluorescent, mercury-vapor,…

A: NEC :- The purpose of  National Electrical Code (NEC) is protect peoples from hazards of fire and…

Q: A 230/115 V single phase transformer is supplying a load of 5 A at a power factor of 0.866 lagging.…

A:

Q: For the circuit (See image), complete the attached temporary diagram (Use the image). Explain your…

A: In drawing the wave forms, all given conditions have been used. Further points to keep in mind while…

Q: Convert 100 watts of power into dBW? Show all steps

A: Given data, Power is given P = 100 W

Q: B R1 www VR3 = 1.85 V ) VR3 = 5.43 V VR3 = 3.65 V www R7 R5 R6 R2 www R4 R3 The circuit above has R1…

A: Given, The circuit is, R1=820 ΩR2=220 ΩR3=470 ΩR4=910 ΩR5=560 ΩR6=330 ΩR7=680 ΩVAB=100 V

Q: Figure 2(a) shows the block diagram of methanol distillation column system where its closed-loop…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Magnetic field intensity is given by H = 2 cos (2 x 10 ⁹ t -ky) a A/m in air medium. What must be…

A: Given, Magnetic field intensity, H = 2 cos 2×109t-ky az Am

Q: How would the output of Circuit 2 been different if the op amp had not been used? In other  words,…

A: Given: Consider the following circuit: To find: How would the output of Circuit 2 be different if…

Q: Find whether the following wave windings are symmetrical or not explain in details please (1)…

A:

Q: Calculate the minimum bandwidth required to achieve a P(e) of 10^(-6) for a system 8-PSK operating…

A:

Q: 11.a. In dwelling units, motels, hotels, and other occupancies such as dormitories, nursing homes,…

A: When feeder current exceeds 200 A then the demand factor of 70 % applied to excess current Suppose…

Q: Determine the Fourier series representation for the signal x (t) shown in Fig. P. 4.2.9.

A:

Q: In GSM, a "TDMA frame" is composed of eight distinct time slots. Each GSM time slot is 577 s…

A: It is given that: A TDMA frame is composed of eight distinct time slots. GSM time slot is 577 μs.…

Q: For the following circuit, the current I is:

A:

Q: Two inductors are connected in series with L₁= 27 mH, L₂ = 12 mH, and M = 0.0144 mH, find the…

A: Given, Two inductors are connected in series. L1=27 mHL2=12 mHM=0.0144 mH

Q: Por What is the period for the signal x(t) = cos(10лt) + 3sin(10лt): O a. T = 10 b. T = 2/10 O c.…

A: Given x(t)=cos10πt+ 3 sin10πthere we have to find the period of the signal.

Q: e feedback control system mu

A: To explain the correct option as,

Q: Question 1: Discuss Supervised Learning

A: Supervised learning : Supervised learning is also known as supervised machine learning it is a…

Q: Q4) Calculate the DFT of x[n] = {x[0] = 123} a) Calculate the N = 3 point DFT of x[n] b) Calculate…

A:

Q: Q2// Answer the following questions. P2 1- The power rotor input of 3-phase, 60 Hz, 4-pole induction…

A: Induction motor is singly excited AC machine in which input supply is given to stator which generate…

Q: 6.28 If the transistor in the circuit of Fig. 6.29(a) is replaced with another having half the value…

A:

Q: What is wrong with this dioce? XMM1 Short Not enough data O Nothing O Open 12 IDEAL DIODE…

A: For the given circuit diagram we need to find its correctness.

Q: procedure of formulation of Ybus using singular transformation

A: The procedure of formulation of Ybus using singular transformation is given below:

Q: 1. A cylindrical conductor with radius r₁ = 0.5 m and relative permeability of 5 carries a current…

A: Solution- J=4.5e-2rz^ A/m2 let system is cylindrical coordinate system a) From Gauss law/ Ampere…

Q: A system that its output at a given time depends only on the input at the same time is said to be O…

A: Given statement: A system that its output at a given time depends only on the input at the same time…

Q: 3. I4 in Figure 1 is equal to A. 2I. B. 4I. C. 6I. D. 8I.  4. R2 in Figure 1 is equal to A. R. B.…

A:

Q: 4. Find the Q-point for the diodes in the circuits shown below using the constant voltage drop model…

A: Diode: It is a semiconductor device and this is unidirectional because it flows the current when it…

Q: Given at the load: What are the real and reactive power and power factor at the load? Exclude the…

A: We need to find out the power of given voltage and current

Q: (a) For each of the signals given, determine mathematically whether the signal is even, odd, or…

A: Given data, (i) x[n]=6u[n-3] (iv) x[n]=6+.2n+.2-n (vi) x[n]=sinn-π6

Q: A 11 kV transmission line has the following line constants: A = 0.85 degree 5°, B=200 degree 75°.…

A:

Q: An 18-gauge copper wire with a diameter of 3-mm carries a constant current of 1-A. The charge…

A:

Q: 4. The surfaces p = 3 and 5, = 100° and 130°, and z = 3 and 4.5 identify a closed surface.

A:

Q: :) Consider the JFET self-bias configuration circuit. Given that V₂= -8V and Ipss = 12mA. Assume VDD…

A: It is given that: VP=-8 VIDSS=12 mA=12×10-3 AVDD=20 VRD=3.3 KΩRG=1 MΩRS=1 KΩ

Q: Design a square wave generator to produce a square wave of 5Khz frequency. The practical OP-AMP 741…

A:

Q: 3. For the circuit shown, find the currents 11, 12 using: The concept of mesh current analysis 4Ω 12…

A: Given circuit:

Q: D1.8. Transform the following vectors to spherical coordinates at the points given: (a) 10a, at P(x…

A: It is given that: a) 10ax at Px=-3,y=2,z=4b) 10ay at Qρ=5,ϕ=30°,z=4c)10az at Mr=4,θ=110°,ϕ=120°

Q: Using op amps with Vsat = +/- 13 V, design a square/ triangular wave function generator circuit to…

A: Triangular Wave Generator Using Op amp- A Triangular Wave Generator Using Op amp can be formed by…

Q: xplain hybrid operation of solar PV system

A: Hybrid operation of solar PV system: The hybrid solar systems employ specialized hybrid inverters…

Q: A wound coil that has an inductance of 180mH and a resistance of 3592 is connected to a 100V 50Hz…

A: Given data, Circuit diagram is given as,

Q: 10.23. Draw the block diagrams of both the direct forms I and II simulation diagrams for the systems…

A:

Q: For the given circuit and input waveform determine the output waveform. a. b. C. d. 15 a b -10 20 20…

A:

Q: Consider a unity negative feedback system with loop transfer function shown in Figure where…

A: The given loop transfer function is: L(s)=GcsG(s)=Ks2+6s+1s2+5s+1 The given closed-loop system is…

Q: The transfer function of the following closed-loop system is: R(s) H(s) 1-G(s)H(s) G(s) 1+G(s)H(s)…

A: In this question we will find transfer function of given system....

Q: At what rate is thermal energy being generated (The power) in the 2R-resistor when - 16 V and…

A: Given, E=16 VR=3 Ω

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.