. Do the following operation (i) (246 )8 + (521)8 (ii) (324 )8 + (631)8 (iii) (704 )8 - (103)8

Q: (a) The model for a position control system using a DC motor is shown in Figure 1.1. Calculate the…

A: The required parameters can be calculated by obtaining the closed loop transfer function of the…

Q: If the electric potential at a single point is known, can E S at that point be determined? If so,…

A: Electric Potential:- Electric potential is the effort required to transport a unit charge from one…

Q: The transfer function of the system T(s) = Y(s)/U(s) is:

A: Given:  x.=Ax+Buy=CxA=01-10-5  B=10 and C=010 Required: Transfer functionT.F=YsUs

Q: The diodes that are not operated in the reverse biased mode are O a. Varactor diode O b. Tunnel…

A: Diode:- A two-terminal electrical component called a diode is one that conducts current solely in…

Q: 10. Design a Full adder using Half adders you may use other gates to complete the requirement Show…

A: The full adder has three inputs and two outputs  Let the two inputs are A, B, and the carry-in input…

Q: Write an HDL gate-level description of the circuit shown in

A: Logic gate:- Logic gates are the device of the digital system. AND gate, OR gate, and NOT gate are…

Q: For the circuit shown below: Rs = 8 kQ, RG = 1500 kQ, R₁ = 40 kQ, RD= 18 ko, gm= 2.75 mA/V a) Draw…

A: We need to find out the input and output impedance and voltage gain for given circuit

Q: Transfer the circuit of the figure to the frequency domain and calculate a)…

A: By using Laplace for the differential equations, it is simple to solve time domain differential…

Q: A Carrier of 450 W,1MHz is amplitude modulated by sinusoidal signal of 15 KHz to a depth of 50%.…

A: Given: In an Amplitude modulation PC=450 WAC=1 MHzfm=15 kHzμ=50%=0.5

Q: For the circuit shown below: Rs=8kQ, RG = 1500 kQ, R₂ = 40 kQ, RD= 18 ko, gm= 2.75 mA/V a) Draw the…

A: The required parameter can be calculated by using the small signal equivalent circuit. The small…

Q: What is the value of E in each HDL block, assuming that RA=1?Verilog (block and nonblocking…

A: Verilog (block and nonblocking operators) 1. RA = RA − 1;  // This is a blocking statement so value…

Q: A ____________ is used to ensure a known state for a signal. It is typically used with switches to…

A: When external devices are disconnected or have a high impedance, a pull-down resistor is employed to…

Q: Explain double revolving field theory. A 3-phase delta connected 440 volt, 50Hz, 4-pole induction…

A: Since you have asked multiple questions, we will solve the second question for you. If you want any…

Q: A system is represented by the transfer function

A: given system transfer function  we find poles then we can indicate in state variable representation…

Q: ystem h Example 8.6.2 Design a phase lead loop transfer function given below such that the system…

A: Gs.Hs=Ks21+0.05sKa=lims→0 s2 Gs.Hs=lims→0 s2 Ks21+0.05s=K∴ K=Ka=100Thus,…

Q: Transformers and Special Locations 4.a. What's the primary difference between the wire in the…

A: Given: Transformer: Transformer is a static device. It is used for transferring power from one place…

Q: The state-equations of the control system shown in Fig.1 is: U(s) a. O b. 0 с. c. A = 0 -L d. A 0 0…

A:

Q: A strand of wire has resistance 60-ohms. Find the net resistance of 25 such strands (in ohms) if…

A: This question belongs to circuit theory . It is based on the concept of parallel combination of…

Q: 11. Which of the following is the drawback for cordless telephones? a) Security b) Wireless…

A: The correct option along with the explanation is provided in the following section.

Q: ratio to the ratio of 15. Referring to Fig. 16.11, if Vpp = 2 V for the varactor of Fig. 16.10, find…

A:

Q: 1. The height of the response curve in a system depends only on the value of R. The width of the re-…

A: As per the honor code I will answer first three questions. Kindly repost the other questions again.…

Q: . DESIGN SPECIFICATION -1 The input impedance to a certain amplifier at a frequency of 2 GHz is…

A: Given, Input Impedance=30-j25Ω Source Impedance=50Ω Microstrip Thickness=Microstrip…

Q: Determine the voltages across all capacitors v₁.₂ & v₂ for t> 0. 2 ΚΩ t=0 1mF E 1kΩ + V₂ HH 8 mF - 1…

A:

Q: Draw another version of the circuit in Fig.

A: Given, MOSFET A=WL=151 MOSFET B=WL=7.51 MOSFET C=WL=151 MOSFET D=WL=151 MOSFET MA =WL=21 MOSFET…

Q: 1.1 Explain the following terms with respect to antennas: 1.1.1 Radiation resistance 1.1.2 Beamwidth…

A: Note: We are authorized to answer the first three sub-parts at a time, so we are answering the first…

Q: For the waveform shown below, find Vrms v(t) HAA 4 6 8 l10 -1 2.

A: It is given that:

Q: Obtain Vx and Ix in the circuit depicted in Fig. 10.40.

A: Given: Required: Ix and Vx

Q: (c) The forward path transfer function of a unity-feedback control system is given as K S(1 +…

A:

Q: Apply Thevenin's theorem to find Vo in the circuit of the figure. Consider R=110. 3 A www 492 www 16…

A: Given here a electrical circuit and asked to find the voltage V0 by using the thevenin theorem.

Q: The quantity of charge Q in coulombs (C) that has passed through a point in a wire up to time t…

A: Given: The charge Qt=t3-4t2+6t+4

Q: Calculate the generator current by the ohm method

A: Goven transformer 1 -19.92 kV/ 277 V , X=10 % transformer 2 -19.92 kV/ 240 V , X=10 % Z1 =6 +j 3 Ω…

Q: d.c. motor has 774 armature conductors. If In a 4-pole rmature current is 50 Amp. and flux per pole…

A:

Q: If there are 10A of direct current through the filament of a light bulb, how many coulombs have…

A: Answer: a. 20 C   Explanation:   a. It is a valid option.  The current I is given by Current,I =…

Q: The circuit to the right consists of a battery (Vo = 3.00 V) and five resistors (R₁ = 711 S2, R₂ =…

A: Given values:- V0=3.00 VR1=711 Ω,  R2=282 ΩR3=463 Ω,  R4=434 ΩR5=465 Ω

Q: Select the value of C (in uF) to produce the desired total capacitance of C7=6 µF in the circuit in…

A: Given: A combination of capacitors.  Total capacitance of the combination CT is given 6 μF, we have…

Q: Write a dataflow description of the BCD-to-excess-3 converter using the Boolean expressions listed…

A: The dataflow modelling describes the combinational circuit based on their function. The Excess 3…

Q: Represent the unsigned decimal numbers 791 and 658 in BCD, and then show the steps necessary to form…

A: Given unsigned decimal number = 791 7=0111 9=1001 1=0001

Q: For the following circuit, find Vo a. 18.6V b. 19.6V c. 19.3V d. None 20V Si www 1k 2k Ge Si www Vo…

A:

Q: T/2 T VIE V +sen wot + V1 + (-1) Σ N-2 (1-N²) cos Not

A: Given: Half wave rectified signal with peak amplitude V.   Fourier series of the above mentioned…

Q: H.W Q1) A four pole, three-phase synchronous generator is rated 250 MVA, its terminal voltage is 24…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: what is dc shunt and series motor?

A: Motor is an electrical machine which converts the electrical energy into mechanical energy. DC motor…

Q: Figure Q1(c) shows a simple conveyor system used in industry to detect and count number of metal…

A: According to the question, for the given simple conveyor as shown below We need to explain the…

Q: A system is represented by the transfer function Y(s) R(s) = T(S) The state variable representation…

A: The given transfer function is YsRs=s+3s3+6s2+12s+8. We need to determine the state space…

Q: Derive the transfer function of the * :circuit shown in Figure below Vin L C: Vout

A: Given data, Given circuit diagram is,

Q: Determine the transfer functions for the multiple inputs and multiple outputs system given as: -…

A:

Q: The electric field strength between two parallel conducting plates separated by 4.40 cm is 6.60 x…

A: Given data, E=6.60×104 V/md=4.40 cm    =4.40×10-2 m

Q: The gure below shows with two batteries and three resistors. The potential difference across the…

A: It is given that:

Q: A photovoltaic solar cell is given which is rated at 3.7V, 2.6A. Design a photovoltaic solar array…

A:

Q: Assume 185 and 122 are signed 8-bit decimal integers stored in sign-magnitude format. Calculate 185…

A: It is given that:∙185∙122

Q: Determine the inductor current fo

A: