. 3x8 Decoder Circuit (FULL Logic Circuit)
Q: Q4 5Ω 20/0° + 20 ΩΣ V j3 Ω -j607 For the circuit shown above, determine : a b ZL (a) The impedance…
A:
Q: (c) A 4-bit ripple adder has inputs 1101 and 1001, and carry in = 0. What would the output of the…
A: Solution: Given data; input A 1101 input B 1001 carry 0 Determine: here find output of…
Q: 3.11 Find V, and the power dissipated in all the resistors in the circuit of Fig. 3.60.
A: The circuit is given that:
Q: List 8051's primary characteristics. Explain the basic microcontroller block diagram using a clean…
A: The 8051 Microcontroller is one of the basic types of microcontrollers, designed by Intel in 1980s.…
Q: 2 Vs(1) No, turns Ne turns Vp(t)= 36sin(wt), where w is the angular frequency and t is time. When Np…
A:
Q: What type of filter the following amplifier represents? Ignore transistor high frequency parasitic…
A: Need to identify the type of filter that the given circuit act based on the given conditions.
Q: Find the steady-state errors for inputs of 5u(t), 5tu(t), and 5t'u(t) to the system shown below. The…
A:
Q: Find the power dissipated in the 3 k2 resistor in the circuit in Figure 1. 750 Ω 192 V + 15 ΚΩ 3 ΚΩ…
A: In this question, We need to determine the power dissipated in the 3k ohm resistance. We know…
Q: Find to in the circuit in (Figure 1), given that is = 0.550 mA. Assume the op amp is ideal. Express…
A: We need to calculate the output current.
Q: 2. Find i, (in microamperes) in the circuit in Figure 2. SV 10 ΚΩ www 6ΚΩ {3 ΚΩ Figure 2 5 ΚΩ SV -SV…
A: To find iL (in microamperes) in the given circuit. The circuit diagram is,
Q: R G₁ G₂ G₂ H₂ H₂ G₁
A: We need to find out transfer function of given block diagram by using of Mason's gain formula.
Q: Present State nextState Output z X=0 X=1 X=0 X=1 A B C D D A D G B B P с D l O O 1 оо using the…
A:
Q: For the integrator circuit if the input voltage is given by the equation and the values of R and C…
A: In this question We need to determine the output voltage of the integrator If input voltage and RC…
Q: A single-input, single-output system is described by 1 - x = [-26 -²₁ ]x + [ 1² ] 4. -a y=[ 10 ]x…
A: Here , single input, single output system is given We need to find a value for the system exhibits…
Q: For the circuit shown below, find the value of AVO, if duty ratio of switch is 0.4 and it is…
A: The given circuit is buck boost converter- Duty ratio α =0.4, Frequency f=25 kHz. To Find- The…
Q: Consider the circuit containing a nonlinear element N as shown in Figure 4.54. The vi relation for N…
A: Given: The circuit below contains a nonlinear element N whose v-i relationship is given by the…
Q: 3. Find: (a) Vp (b) VP-P (c) Frequency (d) Period (e) Angular Velocity (f) Phase angle (g) Equation…
A: Given waveform:- We need to determine a) Vp b) Vp-p c) Frequency(f) d) Period (T) e) Angular…
Q: gure 3.3 ΚΩ w + 3,3 kΩ 3.3 ΚΩ w NV +xx V 3.3 kn SOMME w 3.3 ΚΩ www * 20 ΚΩ Determine the gain of…
A:
Q: Following the conditions: V1 = 3 volts, V2 = 2 volts, R1 = 1000 ohms, R2 = 6000 ohms, and RL = 1000…
A: In this question We need to determine the output Vo , power delivered to the circuit by the 3V and…
Q: A 380 KW load is connected in parallel a 30 kvars traffic bank. The Food input reflects a power…
A:
Q: 1) What happens to the waveform of the magnetizing current of a power transformer as the transformer…
A: Dear student, Since you have posted multiple questions, we will provide the solution only to the…
Q: Three distributors X, Y and Z supplying loads at P, Q, R and S as shown in Fig. Resistances of…
A:
Q: Calculate the 4-point DFT of the following sequence. x[n] = {2,-1,-1,2} Where the underlined sample…
A: here we have to find the 4-point DFT of the given sequence.
Q: X уб (2) ·lock- D₂ D using AND delay = 2 Q /Q'₂ determine the maximum clous frequency. write an…
A:
Q: 1. Reduce to canonical form R G₁ H₁ H₂ G₂ H₂ G₁ C
A: Given: Block diagram of a control system, To find: We have to reduce the block diagram to its…
Q: 2 A discrete-time signal x(n) is shown in Fig. P2.2. Sketch and label carefully each of the…
A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…
Q: (10) Find the equivalent impedance in phasor form for the circuit shown in Figure 2. Given: I, 5 cos…
A: The circuit diagram is given as, The current, I=5cos377t+45° A The resistor, R=1 KΩ The inductor,…
Q: A multistage amplifier is stable if, at the frequency for which the phase of the loop gain is-180…
A: "Unfortunately, due to technical limitations, we are unable to provide a handwritten solution at…
Q: Draw the phasor diagram of a loading single-phase transformer it operating with RLC load, wh of R-15…
A: Given Data: A single-phase transformer with an RLC load of, Resistor R=15 Ω Inductive reactance…
Q: What type of filter the following amplifier represents? Ignore transistor high frequency parasitic…
A:
Q: Millimeter-wave radar generates a narrower beam than conventional microwave radar, making it less…
A:
Q: Draw the positive, negative and zero sequence networks.
A: In this question we need to Draw the positive, negative and zero sequence networks.
Q: Digital Logic Design Using K-map derive the minimum SOP expression for each of the following…
A: For the given boolean expression the reduced sum of product needs to be obtained by using the k-map…
Q: A-For the lossless T.L. with 1-60m, Zr-Zo-7502, f-10MHz, find Zs, and Za at d-0.25
A:
Q: 3 Show that (a) 8(n) = u(n) - u(n-1) (b) u(n) = Σ= δ(k) = Σ0 δ(n – k)
A:
Q: 3 Show that ad (a) δ(n) = u(n) - u(n − 1) (b) u(n) = Σ=-0 δ(κ) = Σοδ(n – k) 8
A: Step-1-> Ans(a)->
Q: 3. In a coaxial cable having a conducting core and a conducting jacket, which Bessel function could…
A: The Bessel function that could be used to describe the radial dependence of the guided fields in a…
Q: c. If both terminals of a PN junction are grounded (V₁=0) the electrostatic potential A must equal…
A: If both terminals of a PN junction are grounded the electrostatic potential ∆ϕ must equal zero. In…
Q: Find Vo for the circuit in Figure using Nodal Analysis
A: For the given circuit the output voltage Vo needs to be calculated by using nodal analysis
Q: (3) A Schmidt Trigger has the shown hystereses transfer characteristics, where the trip points dre:…
A: A Schmidt Trigger had the shown below, Where the trip points are, Vi1=23 volts and Vi2=-2 volts. An…
Q: 1. Determine C for the system represented by D
A: The output response of the multiple input and multiple output needs to be obtained by using the…
Q: Consider the root locus of the system shown in Figure Q11. O The angles (in degrees) for the…
A:
Q: с 5+3j 3 9 Find current across D 300м с 7m H inductor 32 resistor 5+3j Let: leg = 5 sin (30t +30)…
A:
Q: Which of the following is true when an AC voltage is inputted to a diode then the voltage is…
A:
Q: A 300 HP balanced three-phase motor operates at 10√3 KVrms with a power factor of 0.8(-). The motor…
A:
Q: A causal system is represented by the following difference equa y(n)= x(n)+0.5 x(n-1) 75…
A: Given: Difference equation of causal system, y(n)=x(n)+0.5x(n-1)+0.75y(n-1)-0.125y(n-2), To find:…
Q: boolean expression of this image
A: In this question We need to determine the output of the circuit. This is combination of the NOT, OR…
Q: Simplify the following Boolean functions, using three-variable maps: (a) F(x, y, z) = (0, 2, 6, 7)…
A: For the given boolean function the simplified boolean expression needs to be obtained by using three…
Q: For the circuit shown, determine the Thevenin equivalent voltage seen from the terminals marked A)…
A:
Q: www FR₁ IB R₂ VBE Ic Rc VCE IE RE Vcc For the given circuit, R₁ is 100 kn, R₂ is 50 km, Rċ is 5 km,…
A:
1. 3x8 Decoder Circuit (FULL Logic Circuit)
Step by step
Solved in 4 steps with 3 images
- Q.19 Draw logic diagram for 4 to 1 line multiplexer. Q.20 Draw logic diagram for 1 to 4 line de-multiflexer.1- What does the VoH parameter of a logic IC refer to? a) The highest permissible output voltage. b) The lowest output voltage recognized as logic 1. c) The highest output voltage recognized as logic 1. d) The highest output voltage recognized as logic 0.TTL output circuits are classified into two main kinds. What are these two sorts?
- Question: What is a logic gate in digital electronics, and how does it work?Explain the function of Multiplexer and, Draw the 2 x 1 multiplexer logic circuit diagram and function table. How many selection inputs are required for a 4096 x 1 Multiplexer?In IC 74153,the input at pin number 14 is Options A-Connected to ground B-Connected to power/VCC C-Connected to LOGIC State D-Connected to LOGIC Probe
- Q1// What are the difference between Logic Devices and Programmable Logic Devices? Q2// Explain the advantage's of Programmable Logic Devices? Q3// List the disadvantages of Fixed function logic devices. Q4// Compare between Logic Devices and Programmable Logic Devices?An analog voltage (0 to 5) volt is to be converted to 8 bit digital form. d. What is the error made in quantization of 2.2 volt as a percentage of the input.Classify IC logic circuits based on the package density, i.e. the number of devices in an IC chip.